Question about 2003 Jaguar XJ-Series
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
take off inner door panel, lower track and put the window back in. If parts on track are broken buy new ones. Use urathain to reinstall window.
Posted on Jul 28, 2008
I've had this problem and I believe its a common problem with S types. There is a white plastic slider that wraps around a metal strut and moves up and down as the window opens and closes. The problem is that the plastic slider breaks if the car door is slammed when the window is half way down, When this occurs the slider breaks free and the wire that pulls it up and down wraps itself around the motor and jamms everything up. The fix is to replace the window regulator as a complete unit. This fairly straight forward and worth the effort as you most likely will be replacing the other regulators if you keep the car for a while. Buy the regulator either from Jag dealer or OEM part which is approx 1/2 the cost (I found mine on ebay!). Make sure your get the correct unit, left, right, front and rear are different. Take off the door panel, its all clips except you need to unscrew the two scews under the rubber insert in the door pocket first. After you have removed the panel remove the black plastic cover as well. You need to detach the glass window from the regulator, This is done by punching out the brass insert in the middle of the plastic plug that is pushed through a hole in the glass. Be careful, if you hit it too hard you can break the glass, I ended up drilling it out as this was easier. Once you have the plastic plug out the glass is detached and you can remove the regulator. This is just a few screws, the only tricky part is to get the angle right to pull it out the door frame. Installation of the regulator is just the reverse. Good luck.
Posted on Sep 13, 2008
SOURCE: Jaguar XK8 Window Problem
Same thing has happened on mine!
The solution is to reprogram the window limits. You need to sit in the car with doors shut! Turn the key in ignition in position I or II, roll down the window all the way and keep holding the switch for 5 seconds, then roll the window up and again keep the switch pressed for 5 seconds, repeat same steps for other door.
Reprogramming is also described in the owners manual. I don't know how mine became deprogrammed, should only happen if the battery is disconnected!
Posted on Mar 29, 2009
Tips for a great answer:
May 16, 2014 | 2004 Honda Odyssey
Mar 09, 2013 | Cars & Trucks
Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.
Sep 12, 2012 | 2011 Hyundai ix35 2.0
Feb 19, 2011 | 2004 Ford Crown Victoria
Oct 21, 2010 | 1999 Honda Passport
Aug 24, 2008 | 2003 Volkswagen New Beetle Convertible
May 31, 2008 | 2002 Honda Odyssey
100 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: