Question about Dodge Avenger

Open Question

Remove the seat cover of my dodge avenger 2010 sxt assistant driver seat

SRS wire disconnected, so I want to remove the seat cover of the assistant driver seat

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: HOW TO REMOVE 2000 DODGE CARAVAN REAR SEAT

There are 2 handles on the back of the seat where it attaches to the floor. If you hold the button on the handle and push it down it should release the seat from the floor. After this it just rolls out the back. Same for the middle seat if you need to remove it.

Posted on Mar 08, 2009

Ad
  • 6 Answers

SOURCE: How can I remove front row seat headrest?

Most volvo headrest can be removed by releasing the catches which are on the back of the headrest on some models and on the front on others I believe on 960 they are on the back. To release the seat on a 960 look where the shafts should be then follow it down on the back where the seat back top stops then goes in press around that area you should be able to find the catch there pull up on the headrest while releasing the catch you have to do this on both sides. The headrest should come off this also works on 740 and 760 series the volvo 780 is a different story the only way to get the headrest off on that is to disassemble the seat

Posted on Mar 14, 2009

  • 1 Answer

SOURCE: not sure on how to remove the back seat of my

The bottom of the seat is held by a clip on each end. Pull up on the front of the seat about a foot from each end. The back should have attachment bolts that are visable with the bottom removed.

Posted on Aug 07, 2009

csmock132
  • 4669 Answers

SOURCE: how do you remove the crankshaft from 2004 dodge

What size engine. You want to know how to remove the crankshaft pulley right?

Posted on Jul 04, 2010

MNfisherman
  • 11896 Answers

SOURCE: how do you access the rear spark plugs on a 2008

Which engine is this?

Posted on Sep 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a 2010 dodge avenger sxt right passenger side fender fit a 2008 Dodge avenger sxt model both are 4dr sedans


Ebay part. It will list all vehicles the fender will fit. Kind of a "reverse" interchange book, but it works.

Mar 11, 2015 | Dodge Avenger Cars & Trucks

1 Answer

To replace a blown turn signal light on a 2010 dodge avenger ?


front or rear cause ya may not have to remove any screws on headlight assembly's ya have to get to the back where the wires hook up and twist the socket to get to the bulb same on tail lights but ya have to go through the trunk

Dec 28, 2014 | 2010 Dodge Avenger SXT

1 Answer

Replace blown tail light on 2010 dodge avenger


go to a partsstore-like napa--zone--advanc-pepboys--theyd lov to assist u

Dec 28, 2014 | 2010 Dodge Avenger

1 Answer

Where is the crankshaft position sensor located on a 2010 dodge avenger 2.4L


most are located on the ft lower part of engine by crankshaft with 2 wires going to it

Oct 17, 2014 | 2010 Dodge Avenger

1 Answer

How to remove front seat back 2010 cts


Remove the front and rear trim covers over the four bolts that hold the seat to the floor, then go under the seat and disconnect all the wiring being careful not to break any of the connector locking tables.

Jul 12, 2012 | 2010 Cadillac CTS

1 Answer

Oil get into spark plug well. need to know how to replace the valve cover gasket on a 2003 dodge intrepid sxt . clean sparkplugs well of all oil and replaced sparkplugs


Hi
these are the things you need to do.

Allow the car engine to cool by letting the car sit idle for several hours. Lift the hood and disconnect the negative battery cable. Remove the upper intake manifold assembly. Using the spark plug tool, remove the spark plugs. Disconnect the spark plug wires. This can be accomplished by pulling straight out on the boot. Locate the cylinder head and disconnect the closed ventilation system and evaporation control system from it.

Locate the left cylinder head cover and remove the DIS coil. Using the wrench, loosen and remove the rocker arm cover mounting bolts. Carefully remove the rocker arm cover from the cylinder head. Remove the gasket cover. Using the screwdriver, gently nudge the gasket to remove it from the seating area.

Using the automotive cleaner, remove any particles, oil or other remnants that were left by the old gasket. Place the new gasket in the gasket seating area. Using the torque wrench, tighten the rocker arm cover fasteners. Reverse the steps used to remove the parts

Complete the maintenance by adding oil to the car and allowing it to run idle for 10 to 15 minutes.

Feb 22, 2011 | Dodge Intrepid Cars & Trucks

4 Answers

2008 dodge avenger spark plug location and socket size.


  • 2008+ Dodge Avenger 2.4L 4cyl.
  • Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
  • Once removed you will see 4 black spark plug covers with one hex type screw holding each.
  • Remove Hex screw and place aside, pull upward to remove plug boot from plug.
  • To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
  • Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

Feb 14, 2009 | 2008 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...