Question about 2003 Chrysler PT Cruiser

Open Question

No heat in my pt cruiser - 2003 Chrysler PT Cruiser

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: 2001 pt cruiser no heat

did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Posted on Jan 04, 2009

Ad
  • 80 Answers

SOURCE: 2001 pt cruiser

I recently had the same problem with my car. The solution for me was to remove the coolant lines going into the firewall(be sure to let it cool down first)and blow out the heater core with compressed air.I went from blowing barely luke warm air to awesome heat...good luck

Posted on Jan 14, 2009

  • 1 Answer

SOURCE: 2001 PT Cruiser - blower and power windows stopped

Haven.t fixed it yet, but there is a bad wire or loose connection in a group of wires located behind the fuse panel. In the group of wires one of them is apparently the problem. When I move the wires the blower motor and power windows work, but they eventually stop again. I haven't had time to find and fix the exact wire that's the problem yet, it's not an area that I can easily get to!

RW

Posted on Jul 05, 2009

  • 1810 Answers

SOURCE: 2001 PT Cruiser Defogger Can't Be Set

sounds like your air intake knob is sticking
turn fresh air knob to allow fresh air then try and change the seting

Posted on Jan 23, 2010

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How much coolant goes into the radiator of a 2001 pt cruiser?


Approximate coolant capacity.
2001 to 2002 Chrysler PT Cruiser: 7.2 qt (7 liters)
2003 to 2010 Chrysler PT Cruiser: 6.5 qt (6.2 liters)
Mar 4, 2015

Which coolant for a Chrysler PT Cruiser? - PT Cruiser Repair

pt.cruiser.repair/663/which-coolant-for-a-chrysler-pt-cruiser/
2001 pt cruiser Google Search

Jan 27, 2017 | 2001 Chrysler PT Cruiser

1 Answer

Why am I not getting sufficient heat in my 2001 Chrysler PT Cruiser?


One of two things. Most likely is that your heater core is somewhat plugged up or your thermostat is stuck open.

Oct 12, 2014 | 2001 Chrysler PT Cruiser

1 Answer

2001 pt cruiser over heating wired fan direct fan works but car still over heats replaced thermostat temp. sensor fuses etc...


Sounds like the engine head gasket needs to be replaced.The gasket has deteriated from the engine cylinder and coolant passage and overheating the coolant. Sometimes you will see coolant mixed with engine oil, or milky solution on the oil dipstick

Feb 21, 2011 | 2002 Chrysler PT Cruiser

1 Answer

When tun on the a/c to my 05 pt cruiser it doesnt


This is because the engine does not accelerate and the RPM falls below the minimum the PCM is in charge of sending a signal for the engine to increase the RPM.Thanks

Feb 27, 2010 | 2005 Chrysler PT Cruiser

1 Answer

2001 PT Cruiser Defogger Can't Be Set


sounds like your air intake knob is sticking
turn fresh air knob to allow fresh air then try and change the seting

Jan 23, 2010 | 2001 Chrysler PT Cruiser

1 Answer

2001 pt cruiser


I recently had the same problem with my car. The solution for me was to remove the coolant lines going into the firewall(be sure to let it cool down first)and blow out the heater core with compressed air.I went from blowing barely luke warm air to awesome heat...good luck

Jan 14, 2009 | 2001 Chrysler PT Cruiser

1 Answer

2001 pt cruiser no heat


did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Jan 04, 2009 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...