Question about 2004 Pontiac Grand Am

Open Question

How to replace wiper arm bushings on 20004 Pontiac Grand AM

The bushings on the arm from the wiper motor

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: i took my 2002 pontiac

The wiper motor is located under the plastic air intake at the base of the windshield on the driver's side of the vehicle. It is not too hard to get at and you will need to remove at least the lh wiper arm. It is very possible it is a linkage problem and not the motor (the arms pop off their sockets sometimes on these cars) Take the plastic cover off and you will see the arms and be able to tell if they are disconnected or not.

Posted on Jan 06, 2009

Ad
  • 70 Answers

SOURCE: the wiper arm came off of my 2004 pontiac grand

If it's the blade arm it's generally always best to replace it new and will come with new fasteners.

If it's the assembly arm itself depending upon how it was broken off you may need to replace assembly the arm from the stem complete with new / serviceable used bracket.

Posted on Jul 27, 2009

coriluv
  • 30 Answers

SOURCE: have a '04 pontiac grand am. wipers work occasionally

on your signal switch,wipers there all attached together,one goes you need to change the whole thing

Posted on Jul 27, 2009

  • 1 Answer

SOURCE: The windshield wiper mechanism arm fell off.

snapped wiper transmission arm back into place and it works just fine. thanks for your concern. will not need help after all...

Posted on Jan 22, 2010

  • 97 Answers

SOURCE: 2001 pontiac grand prix- wiper blades stop in

needs wiper module. check bushings around wiper motor at the firewall.

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Pontiac Grand Prix wipers will not turn off


replace the arm it's self. take the streering wheel..

Jan 29, 2014 | 1999 Pontiac Grand Prix

2 Answers

WIPER MOTOR RUNS BUT WIPERS WONT MOVE


everyone will tell you that the linkage/transmission will need to be replaced but it doesn't,,most of the time its a bushing and O'Rielly's auto parts sells a "WIPER LINKAGE BUSHING ASSORTMENT" part# 49447 and it sells for about $5 bucks. Its fits tight and took a few minutes to install but its worth the trouble to save about $100

Feb 28, 2013 | 2008 Pontiac G6 Sedan

2 Answers

Windshield wiper one stop moving on my 97 grand prix


Hello, you'll will need to remove wiper motor crouling to get the wiper motor. There will be two rods attached to the wiper motor. Now, this arms operate the wipers on your auto wind shield.
One of the arms have came loose from it ball joint. GB....stewbison

Sep 24, 2011 | 2002 Pontiac Grand Prix

1 Answer

Wind shield wipers dont work. I can hear the motor running but the wipers wont move.. Whats wrong??


The wiper motor has an arm ( or two ) linking the motor to the wipers. These arms have plastic bushings and it is possible one or more bushings wore out and the arm (s) fell off the motor. You'll need to look at a specific repair manual for your car to see where exactly the arm ( s ) are and what is involved in replacing those bushings, as some vehicles require you to replace the arm with the bushings and others allow you to just replace the bushings.
Hope this helps!!

Nov 24, 2010 | 1991 Toyota Corolla

2 Answers

I have one wiper that does not work the other stops in the middle of the windshield how can i fix them


The motor could be bad, but it's likely that the ball joint connections under the hood area under the cowl have become disconnected for the one windshield wiper arm.

The connection of the arm that moves should be checked for being at the correct angle for parking.
Removal & Installation 2000-03 Wiper Motor and Bushing Replacement L4-2.2L (Vin F) & V6-3.0L (Vin R) To Remove:
sat_car_22_fw-wpr_arm_xp.gif

  1. Before servicing the vehicle refer to the precautions at the beginning of this section
  2. Remove the wiper arm finish caps
  3. Mark both wiper arm positions on the windshield by using a wax pencil or tape
  4. Remove or disconnect the following:
    • Wiper arm retaining nuts and washers
    • Wiper arms
    • Weather-strip at rear of hood sat_car_22_f_wshd_wthr-strp.gif

      sat_car_22_f_wshd_gril_nts.gif

    • Grill nuts from base of wiper arm shaft
    • Grill
    • Electrical harness connector from the wiper motor
    • Wiper motor retaining bolts
    • Wiper motor assembly from plenum area
    sat_car_22_f_wpr-mtr_asy.gif

    sat_car_19_wpr_mdl_rmv.gif

  5. If replacing wiper module bushings remove the steel bushing first then the rubber grommet
  6. Remove the wiper motor from the transmission assembly
To Install:
  1. Install or connect the following:
    • Wiper motor to transmission assembly NOTE: If the wiper module bushings were replaced install the rubber grommet first then the steel bushing.
    • Wiper motor to plenum area
    • Wiper motor retaining bolts; torque to 44 lb-in. (5 Nm)
    • Electrical harness connector to the wiper motor
    • Weather-strip at the rear of hood
    • Grill
    • Grill nuts to the base of the wiper arm shaft
  2. Install the wiper arm assemblies at the marks made during removal or at the PARK position if a new wiper motor is installed
  3. Install the wiper arm retaining washers and nuts; torque to 9 lb-ft. (12 Nm)
  4. Install the wiper arm finish caps
  5. Verify correct wiper system operation
prev.gif next.gif

Oct 05, 2010 | 2001 Saturn L-Series

1 Answer

2002 pontiac grand prix. windshield wipers stop straight up on windshield when turned off.


If you have just changed the wiper arms, they may not have been reinstalled correctly.....hoever if it has just started happening,,,,,???

unfortunately this is a wiper motor fault....not the switch.......inside the motor is a PARK function.....this is where the wipers will stop after doing a swipe across the windscreen and the switch is turned off.........this park function is a section inside the motor that cannot be removed and replaced internally, and it would cost more than just a replacement wiper motor

Good luck and i hope this helps...
Please vote if you liked this response

Aug 23, 2010 | 2002 Pontiac Grand Prix

1 Answer

2001 pontiac grand prix- wiper blades stop in


needs wiper module. check bushings around wiper motor at the firewall.

Mar 13, 2010 | 2001 Pontiac Grand Prix

1 Answer

1999 pontiac windsheild wipers,motor makes a sound but they wont work,can move them manually


the wiper transmission they call it between the wiper motor and the wiper arms are stripped or broken
a replacement is needed

Mar 02, 2010 | 1999 Pontiac Grand Prix

1 Answer

After replacing the wiper motor and linkage bushings on my Grand Voyager SE, the wiper arms stop in the straight up position when ''at rest''. Help please


Remove the arms,and place them back on where they need to go,do not turn the wipers on,do this as they set now.If the wiper blades when turned on go off the left side of the windshield ,then you will have to remove everything again,and move the wipers down in the rest position,and align everything up to the rest position,with the wipers at rest,and the motor at rest.

Jan 22, 2010 | 1992 Plymouth Grand Voyager

2 Answers

I took my 2002 pontiac grand prix in to a garage this morning and was told my winshield wiper motor is the problem, my nephew thinks he can fix it, he just wants to know if it is on top of my car or is it...


The wiper motor is located under the plastic air intake at the base of the windshield on the driver's side of the vehicle. It is not too hard to get at and you will need to remove at least the lh wiper arm. It is very possible it is a linkage problem and not the motor (the arms pop off their sockets sometimes on these cars) Take the plastic cover off and you will see the arms and be able to tell if they are disconnected or not.

Dec 03, 2008 | 2002 Pontiac Grand Prix

Not finding what you are looking for?
2004 Pontiac Grand Am Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...