Question about Cars & Trucks

1 Answer

Gear shift stuck in park I have bought a new gear shift,new battery and put on a new break light and still nothing .I have put a lot of money in this truck somebody please help me...its a 1996 landrover discovery

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,333 Answers

  • Neutral safety switch sends a signal to the on-board computer to allow the engine to start and to engage the transmission
  • When not replaced, vehicle may experience no start and/or transmission will not shift out of park.Here's a link to the part.

Posted on Nov 24, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ryan7896
  • 31 Answers

SOURCE: Landrover discovery wont start but battery is good

This usually is the starter, especially if your truck has had an oil leak going for a while as the oil will run down into the starter and cause it to intermittenly fail. Also check your battery terminals and make sure you have a good connectivity.

Posted on Mar 27, 2009

martin538
  • 117 Answers

SOURCE: need head bolt torque settings for 200 landrover discovery 4.0 liter 241 cu.in.

Stage 1 20nm
Stage 2 +90 degrees
Stage 3 +90 degrees

Posted on Apr 13, 2009

  • 275 Answers

SOURCE: remove the inside rear door panel for 1995 Landrover

Remove the 2 bolts holding the grab handle ( 10mm) Remove the screw holding the pull handle plastic cover and remove the cover. Use a fork and pry the panel away from the door and you will be able to pull it off. Before refitting, check all of the plastic clips that hold the panel to the door, some will have broken off. Remove them and fit them back on to the trim panel and glue them on. Refit is reverse as removal. Hope that helps

Posted on Mar 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gear shift stuck in park


You should take your car back to the person or place that you fixed it and tell them it is worse than before. Insist on getting your money back if it is not fixed.

Jul 12, 2017 | Ford F-250 Cars & Trucks

2 Answers

WHY CAN'T I SHIFT MY 1997 GRAND MARQUIS OUT OF PARK AND INTO ANY GEAR?


You may have a faulty Break-light switch. If the switch is bad, then it will behave as if you have no breaks afa the shift-lever is concerned.

Sep 07, 2012 | 1997 Mercury Grand Marquis

1 Answer

Gear shift is stuck


yhad992, You fail to mention if your vehicle has an automatic or manual transmission and which gear it is stuck in. However, I am going to assume that it is an automatic and you can't get it out of park. Get in your vehicle and have someone see if you have any break lights. This may seem like a strange approach but the break switch controls not only the lights but something called the shift solenoid. This is a safety device that allows your vehicle to be put in gear only when the brake is applied. If you have no brake lights then you will have no power going to the shift solenoid. If this is the case then have your brake switch replaced. Good luck with this.

May 14, 2011 | 2008 Chevrolet Impala

1 Answer

2006 Cobalt . The Gear shift is stuck in park.


theres a switch that controls the shifter when the brake is applied. try putting the car into gear with the key on accessory, not on. if it goes into gear the switch needs to be replaced.

Dec 28, 2009 | 2006 Chevrolet Cobalt

2 Answers

Gear shift stuck


EITHER IT IS CONNECTED TO THE TRANS BY A ROD OR CABLE SOMETHING HAS COME LOOSE THERE

Aug 31, 2009 | 2002 Mazda Tribute

1 Answer

2008 avenger


possibly the brake light switch

Jun 05, 2017 | 2008 Dodge Avenger

2 Answers

My 2003 Mercury Mountaineer Gear Shift is stuck.


THERE IS A SENSOR ON THE BRAKE PEDAL THAT RELEASES THE THE SHIFTER.THERE A 3 COMPONENTS INVOLVED.U CAN PUT IT IN NEUTRAL BEFORE U START THE CAR.THEN WIL SHIFT.

May 01, 2009 | 2004 Mercury Mountaineer

1 Answer

1999 accord wont shift out of park and no break lights.


u have a problem with ur break light switch,,, its at the brake pedal and is threaded into the brake pedal bracket, if u have a new one and are going to replace it, disconnect the connector, loosen the 14mm nut and remove the switch by turning it counterclockwise...install ther new switch by turning it clockwise and tightening the 14mm nut then reconnect the connector...be sure to adjust the switch or else the brake lights will stay on at all times...draining ur battery and possibly burning out ur bulbs...this also releases ur trans from park to put into gears

Apr 11, 2009 | 1999 Honda Accord

4 Answers

My car won't go in gear


I got same problem when I first got the car (bought used), took me a day to find out one of the fuse blown caused the problem now I always have 10A fuse spare in my glove comparment, check all your fuses (I believe it's an Audio/Clock 10A fuse) will solve your, good luck ...

Oct 06, 2008 | 2005 Chevrolet Aveo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...