Question about 2011 GMC Canyon

Open Question

Dash key symbol

Key in lock symbol came on dashboard?

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Are all the dashboard lights supposed to come on when the key is engaged?


All of the red dash warning symbols should illuminate when the key is turned to the "ON" position.

Mar 12, 2015 | 2006 Chevrolet Malibu

1 Answer

Why wont my vehicle start when there is a lock symbol on the dash?


I had this same problem with my 2004 gmc envoy. Mine was a key problem. I had a 2001 impala that had identical keys that contain a chip that is read by the ignition switch. Both of my keys were near each other on the keyring and when the impala key was to close to the ignition the truck would not start and the light came on that looks like a lock. I took the impala key off the keychain and never had another problem.

May 25, 2014 | 2008 GMC Envoy

1 Answer

Sign of car with key warning light on dash


Here is a fix >

Security and Immobilizer System Indicator Symbols Symbols & Tell-tales
engine_immobilizer.gifsecurity_indicator_symbol.gifThese are Security and/or Immobilizer System Indicator symbols used by manufacturers. One of these symbols lights momentarily to indicate that the ignition switch is locked and will need the proper transponder-equipped key to re-start. The vehicle is immobilized otherwise. Green symbols will flash when the vehicle is immobilized.
lock.gifIf the symbol is visible when the vehicle is on, it indicates a malfunction in the security system. If the engine does not start with the correct key, and the security indicator remains on, the system may have a malfunction. You will need to contact your dealer in either case.
Keep the Symbol meanings with you!


Feb 09, 2013 | 2008 Hyundai Getz 1.3

1 Answer

A key symbol on dashboard and lights are not working


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Nov 14, 2012 | 2008 Smart fortwo

1 Answer

My 2004 Chevy suburban won't start but there is a locked padlock on dashboard , is this why?


sound like problem in the theft security systm,try this insert another key in the ignition switch, the other key could be worn where pcm and bcm dont recognize it. and switch ignition on engine off watch padlock symbol with ignition switch left on 10 minutes the padlock symbol will extinguish or turn off then you will turn off ignition switch wait 5 seconds then try starting vechicle if start your theft security failing need let dealership check it out.

Aug 27, 2012 | 2004 Chevrolet Suburban

1 Answer

I have a spanner symbol on my 407. what does this mean??


You need to carry out the periodical car service due (e.g. engine oil & filter, air filter, fuel filter, cabin air filter). The "service" spanner symbol "reset" button is placed on the lower right corner of the dashboard. See picture below:

tdisline_303.jpg
Then you should reset the "service" spanner symbol by pressing on the "reset" button on dashboard, when ignition key is in OFF position. Hold the button pressed and turn ignition key in ON position. Hold the button pressed and see on the dashboard successive numbers will appear: "10", "9", "8", ... , "1", "0". Then release the button and switch OFF the ignition key. The "service" spanner symbol followed by "20000 km" (or "30000 km" depending of the engine type), will appear for few seconds after turning ignition key in ON position, and will dissapear after engine starting. The car service due was reseted.

Please do rate my response. Thanks!

Feb 21, 2011 | 2005 Peugeot 405

2 Answers

Dashboard symbol, car with lock above, is illuminated


sounds to me like you have a bad transponder in your key or reciever in your steering collumn, this is just a guess since you have not given us much to go on, year make and model of the car....
however my 08 shelby cobra did something similar after my keys went thru the washing machine...had to buy a new key

Feb 03, 2009 | 2007 Ferrari F430 Spider

1 Answer

Turning over no fire , key immoberlizer light stopping on


you may have a bad crankshaft sensor that would keep it from firing

Jan 12, 2009 | 2000 Jeep Grand Cherokee

1 Answer

New car key or rip the dashboard out????


new key is cheeper if you dont have exper. with removing dash. try taking a magnet a fishing it out

Aug 10, 2008 | 2006 Fiat 124

Not finding what you are looking for?
2011 GMC Canyon Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...