Question about Cars & Trucks

Open Question

Peugeot 206 has abs, stop and handbrake light on dash

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: renault megane 1.4 16v

could be a sensor will need to hane a fault code read to detrmine where the fault is

Posted on Feb 08, 2009

ginko
  • 19396 Answers

SOURCE: fuse box diagram peugeot 206

Check the website below:

Peugeot 206 Fuses.

Posted on Mar 28, 2009

  • 127 Answers

SOURCE: Torque setting for peugeot 206

hallo
If you have normal 1.6 liter 206:
max bolt lenght:176,5mm
20Nm and aditional 240°

1,6 liter 16valve engine
max bolt lenght:122,6mm
20Nm and aditional 260°

Marko

Posted on Sep 26, 2009

  • 165 Answers

SOURCE: My Mercedes ML 270 cdi ABS etc lights and gearbox.

  • you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.

Posted on Nov 17, 2009

  • 1 Answer

SOURCE: peugeot 206 cc fan belt change

hi ive a peugeot 206cc 02 reg, the STOP light keeps flashing ive checked the normal oil and water but alls ok so whats the problem still runs fine and temp stays where it should??? any tips??

Posted on Dec 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to disable abs light


The ABS light normally illuminates to indicate that the ABS module is out of parameter, which may indicate a POTENTIALLY DANGEROUS CONDITION. Usually, replacing the ABS module will cure the condition, and the ABS warning light will turn off.

Jul 18, 2014 | 2001 Peugeot 206 1.6

1 Answer

No brake lights when hand brake is on ?


remove the console from the handbrake and you will see contact there.its possible you have to adjust the hight,adjust whit ignition is on.
so you can see it come on if not bin broken.

Mar 03, 2014 | Peugeot 206 Cars & Trucks

2 Answers

Where is the brake light switch located on a peugeot 206 car


above the panel under the dash on a support bracket above the brake pedal ,twist and turn to remove

Sep 12, 2012 | 2001 Peugeot 206 1.6

1 Answer

Hi I have a peugeot 206 02 gti my abs light has come on and it sometimes flashes up and says ABS fault does this mean I need to replace dics and pads?


yes more then likly the pads have a wire on them and when the pads waer down it compleates a circuit and the light comes on pads are easy to do but you will need to wined the plungers back in to fit new pads.
hope this helps

Apr 29, 2012 | 2001 Peugeot 206 1.6

2 Answers

I have been having a clunking sound from my peugeot 206 for a week or so now and this morning it did it again then when i went to put the handbrake back on its really high what has happened the handbrake...


Problem will be with the rear brake shoes. Very likely one of 2 handbrake cables corroded and snapped.
Access to handbrake is under the plastic centre console - then under flap in carpet. Should be a ballance bar that should be equal 90 degrees. If it's not - replace both handbrake cables. DIY job -but you need a 2ft breaker bar for the Hub nuts.

Sep 02, 2010 | Peugeot 405 Cars & Trucks

1 Answer

Rear clunk in Peugeot 206, 2002


you may have a problem with a sticking handbrake
usually what happens is one of the brake shoe linings comes off and gets stuck when the car is stopping
the noise your hearing in the brake releasing

Nov 17, 2009 | 2006 Peugeot 604

3 Answers

Flashing red stop light to dashboard


i have vauxhall vivaro van got starting problems could be glow plugs but now i have a flashing stop light on what looks like a picture of a engine

Oct 25, 2009 | 2006 Peugeot 604

2 Answers

Peugeot 206 cc fan belt change


hi ive a peugeot 206cc 02 reg, the STOP light keeps flashing ive checked the normal oil and water but alls ok so whats the problem still runs fine and temp stays where it should??? any tips??

Aug 28, 2009 | 2005 Peugeot 405

2 Answers

I have just bought a peugeot 206 Hdi and the coil light dosn't go


glow plug light should just flicker as not needed until -6 stop light stays on when off until started

Apr 04, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...