Question about Toyota Dyna

Open Question

Truoble hino truck heavy equipment k13c.if engine start no accelerate,plusing low power

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
old marine
  • 2012 Answers

SOURCE: Engine goes to low power

I'm guessing when the engine light comes on, the computer is going into a default mode -- enough to keep the engine running, but not efficiently or with power. You need to get the error codes checked to determine what is going bad. It may be a throttle position sensor (TPS), or a crank or cam position sensor, which feed critical information to the computer.

Posted on Feb 25, 2009

Ad
  • 11 Answers

SOURCE: low engine power warning came on and the would not

undew ground on battery for 5 minutes let computer reset itself and try.its a free diagnostic.usually they do this when intake or head gaskets are gone.yours might just be a comp glitch.

Posted on Aug 08, 2009

  • 6 Answers

SOURCE: i have a kia rio 2003 automatique. power loss

hows yr mileage? try cleaning the automatic transmission fluid (ATF) by using vacuum method.. it can consume upto 8 litres of ATF, normally ATF replacement is 4 litres, with vaccum will be more than 6 litres.. if itsnot helping try carbon clean, ask yr mechanic or kia service station

Posted on Sep 14, 2009

  • 2 Answers

SOURCE: 1996 Dodge Ram won't start, compression is low

you need ti check your fuel pressure out and also do a no load test on your altenator because that might not be producing enough electrical energy to start the truck

Posted on Oct 08, 2009

emissionwiz
  • 77169 Answers

SOURCE: Has anyone have engine specifications for a Hino '88 EH700 diesel truck engine

We do not have this information, contact the manufacturer if possible,

Posted on Sep 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes a rattling noise in my engine when i hit the accelerator?


"Rattling" is normally due to one of two things:
  1. On heavy acceleration, rattling is usually due to low octane fuel.
  2. If at all times, it can be due to low oil pressure.

    Rattling can also occur if the engine timing is way out specs. This will normally be accompanied by a substantial loss of power on acceleration.

Aug 04, 2014 | 2002 Toyota Camry

1 Answer

What is the hino jo5dt engine valve clearance


http://www.hino.com/trucks/story_810.php

Jo5DT diesel engine. (no year?)

second ever too ask an not one answer ever
even google , shows, ZERO.
well , time to buy the FSM book and read it up.
or go to hino and ask.?

May 08, 2014 | Cars & Trucks

1 Answer

Hino truckk13c engine start no accelerate plusing low power


run fault codes if it is set up that way . or if pre electronic check for air leaks in the fuel system . Check that the vent on the fuel tank is not blocked creating a vacuum in the system. Check that you are getting full throttle when the accelerator is fully depressed. With the engine stopped have some one press down on the pedal and you may be able to still move the lever on the pump . If so adjust the setting till it hits the stop. The accelerator cable may be one the way out and needs replacing

Nov 24, 2013 | Cars & Trucks

1 Answer

I have a 1995 ford f250 5.8 gas first thing in the morning I have to shoot ether to get it to start after that starts right up idles a little ruff under heavy acceleration it sputters backfires and wants...


Sounds like your fuel pump starting to die. It is not getting enough gas under heavy acceleration which is 100% fuel pump slowly dying. At start up it might not be building up enough fuel pressure to feed the system but the shot of ether and engine cranking helps pressure the system just enough for the fuel pump to trickle the gas and run the engine at low rpms.

Nov 14, 2013 | Cars & Trucks

1 Answer

I'm having a problem with my Hino Dutro Truck ...DPR system. i cannot fix it and the engine signal finally appears on the dashboard. some told me it will need a forced regeneration from your neare


some one told me how to fix dpr appear on the dashboard
also appear the engine check on the dashboard too for this
problem the car is very low power to speed

Sep 02, 2012 | Toyota Dyna Cars & Trucks

1 Answer

Daftar nama suku cadang Nissan terano


Kami menjual Spare Part (Suku Cadang) dan Komponen (Component) khusus untuk Truk (Heavy Duty Truck merek Nissan Diesel, Hino, Volvo, dll meliputi model Bus, Cargo Truck, Trailer, Semi Trailer, Low Bed Truck , Logging Truck, Mixer Truck, Dump Truck dan Tank Truck. Untuk bagian Engine, Transmission, Transfer, Cover & Disc Clutch, Steering, Axle, Differential, Compressor, Pump, Electric,dll. Kunjungi web kami untuk detailnya. Informasi lebih jelas, silahkan hubungi :
Mobile : 081382119888 & 081288639888
Phone : 021-44455887 & 44455889
Fax : 021-85904666
Email : marketing@tractor-truck.com
Website : http://www.Tractor-Truck.Com

Jul 30, 2012 | Mazda Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...