Question about 2000 Chrysler Cirrus

Open Question

1998 chrysler cirrus, transmission vacuum hoses

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: vacuum hose connection for 1987 chrysler conquest

if you have the 2.6 turbo I have a vacuum diagram for that car or I could take a pic of mine so you can see what goes wear

Posted on Aug 23, 2008

t955i
  • 30 Answers

SOURCE: what kind of transmission fluid should i use for a

9.2 quarts of GM Dexron VI ATF or equivalent

Posted on May 02, 2009

Molson02536
  • 3854 Answers

SOURCE: 1999 chrysler cirrus transmission will not shift

It sounds like it may be you speed sensor at the transmission which is also called Vehicle Velocity Sensor (VVS), The sensor or the wire harness may have gone bad and needs to be replaced, but it's a good thing to have your car scanned at Auto Zone since they scan free of charge. I just want to make sure it is the VVS and not the transmission Control Module (TCM), Check the fuse under the dash and under the hood and look for any blown fuse like the TCM fuse. Good luck and hope this helps, keep me posted

Posted on Jun 24, 2009

  • 880 Answers

SOURCE: where is thermostat in a 1995 chrysler cirrus LX

A tee is located to the right hand side of the intake manifold, on top you should see the coolant system cap, its silver in color and is about 2-3 inches in diameter. This tee is the thermostat housing, it goes to your radiator and engine block, remove it from the block and you should see the thermostat. Remember when replacing the thermostat, the spring side goes into the block! 2.0L and 2.4L it is under where the upper rad hose hooks to the engine. 2.5L it is under where the lower rad hose hooks to the engine.

Posted on Dec 29, 2009

ZJLimited
  • 17970 Answers

SOURCE: how do i program new remote keyless entry for my

No way, this keyless entry remote (for 1997-2001 Chrysler CIRRUS Keyless entry remote) must be programmed to your vehicle before it will work. This can only be done at a professional automotive locksmith shop. If you are unable to find a locksmith, the dealership will be able to program it for you instead. There are no programming instructions available for this keyless entry remote. It can only be done at the locksmith or dealer with special equipment.

zjlimited_0.jpeg


Hope this helps (remember to rate this answer).

Posted on Jan 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you change motor and trans in a 1998 chrysler cirrus from bottom of car or does it have to come out top


Dodge Automatic Transmission Removal - YouTube

? 11:05
https://www.youtube.com/watch?v=zuGO78R8BfU
Oct 27, 2010 - Uploaded by richpin06a
Dodge neon automatic transmission replacement. ... a chain block which means you have a lot more room under the car for working space to ... I didn't read the title and I thought I was watching how to change tranny oil. ... Then you can slid theengine a little to the pass side and you can pull the engine out.

Chrysler Cirrus Repair: Problems, Cost and Maintenance

repairpal.com > Cars > Chrysler
A guide to problems, costs, maintenance and repair for your Chrysler Cirrus ... CheckEngine Light Due to Pinched Leak Detection Pump Vacuum Lines ... 1998 Chrysler Cirrus ... This is typically found where the wires pass under the distributor. ... The carturns over but won't start can't smell gas even when you keep ...

Nov 30, 2015 | Chrysler Cars & Trucks

1 Answer

Why doesn't my transmission engage when i shft into gear on a 98 cirrus


Check that the shift cable is connected (top of the transmission)

Sep 03, 2014 | 1998 Chrysler Cirrus

1 Answer

Why won't my 1998 chrysler cirrus shift into gear?


I'm not familiar with YOUR Chrysler, BUT... my brother' father-in-law had a Buick [about 1998 model] that would NOT shift into any gear UNLESS the brake pedal was FULLY DEPRESSED!!!!!

I could move the shift lever into any of the indicator positions, but the transmission would not engage if my foot was not firmly on the brake pedal while selecting a gear position!

Sep 03, 2014 | 1998 Chrysler Cirrus

1 Answer

ABS light on a 1998 chrysler cirrus comes on only after the doors lock when driving down the street,why?


This is the short story.The transmission sends a signal to the ECM that sends a signal to the BCM (This is what locks the doors) The ECM also sends that signal to the ABS. When the ABS doesn't sense a signal from the wheel sensors, the ABS light comes on. Have the codes checked. Let me know. Randy

Sep 26, 2011 | 1998 Chrysler Cirrus

1 Answer

2.5 v6 1998 chrysler cirrus : where is the coolant drain plug? please help


some radiators don't have a drain plug, the easiest way to drain the radiator is to remove the bottom radiator hose from the radiator, this is best done when the engine is cold so as not to burn yourself......hope this helps......cheers.

Aug 29, 2011 | 1998 Chrysler Cirrus

1 Answer

I am replacing my transmission on my 1998 chrysler cirrus. When replacing it do i have to replace anything else in order for it to work?


is this a used transmission? if so make sure the fluid is red and the fluid doesnt smell burnt. remove the transmission pan and see if there is any metal in the pan before installing a used transmission.

Jul 11, 2010 | 1998 Chrysler Cirrus

1 Answer

My 98 chrysler cirrus is lesking water and im told


First open the hood of your car and check where the leak is coming. Thermostat gasket is one source but
it could also come the radiator, radiator hose, or the
water pump. Check all these items, and you can do
the repairs by replacing the defective parts. Except for
water pump that really needs a mechanic to replace the
bearings and the mechanical shaft seal.

Oct 09, 2009 | 1998 Chrysler Cirrus

1 Answer

1998 Chrysler Cirrus LXi refuses to start. Battery OK. Dash light diagnostic does not happen. Only Odometer and transmission position lights come on with key in ingition position. No click or any sound...


try the start sensor,that could be you problem,and another thing try to check the fuse panel too,the one inside the car and the one under the hood,good luck

Sep 15, 2009 | 1998 Chrysler Cirrus

1 Answer

Are the transmissions the same for a93 3.3l plymouth voyager and95 2.5l chrysler cirrus.


No, the cirrus is a 4 cylinder and the van is an 8 they won't bolt up the same. some of the vans had the same tranny as the cirrus but not the 3.3. Sorry

May 12, 2009 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...