Question about Toyota 4Runner
Replace headlight bulb on Toyota coaster bus
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Most headlight retaining rings and trim bezels have very sharp
edges. Wear gloves. Never pry or push on a headlamp; it can shatter
Fig. Fig. 1: After removing the parking lamp screws, push on the grille clips to release the grille from the truck
Fig. Fig. 2: Remove the grille from the truck and set aside
Fig. Fig. 3: Remove the headlight bezel which is secured by screws
Fig. Fig. 4: Be careful when removing the headlight bezels, they can be sharp
A good kitchen or household magnet placed on the shank of the screwdriver will provide enough grip to hold the screw during removal.
Fig. Fig. 5: Pull the light out, then unplug the wiring harness from behind it
Posted on Apr 07, 2009
they are usually changed from inside the engine compartment. you should be able to gain access to the bulb behind each headlight bazel. the socket often has to be turned to remove it. be careful not to touch the new bulb with your fingers as that will shorten it's lifespan. you may have to remove the battery if the burnt out bulb is on that side.
Please take a moment to rate this solution... thanks
Posted on Apr 15, 2009
You can and it is not difficult, there are two bolts holding the top of the headlight to the body just over the radiator and a couple of screws holding the indicato in place, but you can access the back of the light fitting without doing so . It is a bit of a squeeze on the battery side.
Posted on Mar 08, 2010
If you have the HID bulbs, and there is moisture in the bottom of the assembly, the high voltage box at the bottom will not work. this requires removing the whole headlamp, removing the circuit board from the bottom and drying out. I have done mine twice before finally finding how water was getting in at the top seam of the lamp assembly. You will have to dis-assemble part of the wheel well and bumper cover to gain access to all the mounting bolts. Best of luck
Posted on May 02, 2010
I have similar issue with my 03 Camry XLE. I replaced the left side headlight bulb and the light still not coming on. Thanks in advance for the help.
Posted on Aug 05, 2010
Tips for a great answer:
Nov 06, 2015 | Toyota Cars & Trucks
Dec 17, 2013 | Toyota Coaster Cars & Trucks
Feb 05, 2013 | Cars & Trucks
Jan 17, 2013 | Cars & Trucks
Aug 16, 2011 | 1985 Toyota Passenger
Jan 22, 2010 | Toyota Passenger Cars & Trucks
Oct 04, 2009 | 1985 Toyota Passenger
286 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: