Question about 2004 Hyundai Elantra

Open Question

What is 2010 hyundai elantra starter recoil - 2004 Hyundai Elantra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 740 Answers

SOURCE: 2004 hyundai elantra starter

You culd be having more than one problem. First if you are having problem putting the car in park. The car may not actually be fully in park and therefore the neutral safety switch is active and telling to car you are in revers or in gear. If this is true then your car won't start for safety reasons. Try putting it in Neutral and see if it starts then. Ormay have a neutal safety switch that is bad. Can you hear the starter click when you turn the key to start?

Posted on Dec 08, 2008

  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

  • 1 Answer

SOURCE: Where is a Hyundai Elantra starter located?

check on the under, backside of the transmission...

Posted on Feb 08, 2010

  • 564 Answers

SOURCE: Hyundai Elantra GLS 2003 starter does not work

it can if you have the proper tools and a little patience its not very hard at all it may be a little snug i cant remember off hand where the starter is located on that car but its relatively an easy fix.

Posted on May 21, 2010

ZJLimited
  • 17970 Answers

SOURCE: Where is my starter and how do I change my starter?

2000 Hyundai Elantra 2.0L MFI DOHC 4cylRemoval & Installation

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Speedometer and shift control cables Starter electrical connectors Starter motor
  3. 2e15922.jpg

    Fig. Exploded view of the starter-XG 300 and XG 350

To install:
  1. Install or connect the following:
    Starter motor and torque the bolts to 25 ft. lbs. (34 Nm) Starter electrical connectors Speedometer and shift control cables Negative battery cable
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Air intake assembly Speedometer cable Shift cable Starter wiring connectors Starter motor
To install:
  1. Install or connect the following:
    Starter motor and torque the bolts to 20-25 ft. lbs. (26-33 Nm) Starter wiring connectors and torque the battery cable nut to 88-140 inch lbs. (10-16 Nm) Shift cable Speedometer cable Air intake assembly Negative battery cable
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Air intake assembly Speedometer cable Shift cable Starter wiring connectors Starter motor
To install:
  1. Install or connect the following:
    Starter motor and torque the bolts to 20-25 ft. lbs. (26-33 Nm) Starter wiring connectors and torque the battery cable nut to 88-140 inch lbs. (10-16 Nm) Shift cable Speedometer cable Air intake assembly Negative battery cable
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Speedometer and shift control cables Starter electrical connectors Starter motor
To install:
  1. Install or connect the following:
    Starter motor and torque the bolts to 25 ft. lbs. (34 Nm) Starter electrical connectors Speedometer and shift control cables Negative battery cable.

All Others
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable and wait at least 3 minutes Speedometer cable and shift cable from the transaxle Starter motor wiring Starter motor bolts and the starter
To install:
  1. Installation is the reverse of removal. Tighten motor retainers to 20-25 ft. lbs. (27-34 Nm).

Hope helps (remember rated this).

Posted on Jul 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2010 hyundai elantra. When I push the accelerator, I hear a screeching noise. Then it stops. What is this and do I need to replace something?


Have the accessory drive belt ( Alternator ) checked for proper tension. It may need adjustment if it is loose causing this noise

Jan 19, 2016 | 2010 Hyundai Elantra

1 Answer

I have a 2009 elantra and when doors r locked and I hit the starter the car lights blink twice and doesn't start! It was a factory install by Hyundai . The car is an automatic . What do I do? Thanks


I would return it to the installer

My 2012 Hyundai Elantra Wont Start - CarGurus

www.cargurus.com > Questions > Hyundai > Elantra

CarGurusJul 30, 2013 - My 2012 hyundai Elantra GLS would not start this morning. ... I hit my door unlock on mt Key fab and the doors unlocked fromt here I proceeded start my car.... it and it wont turn over just makes a light click. not like a battery issue. .... But if Istart from the zero position on the starter it doesn't start on the first try ...

No horn / No lights when I lock my car - Hyundai Genesis ...

www.gencoupe.com/.../244433-no-horn-no-lights-when-i-lock-my-car.h...

Mar 30, 2014 - 16 posts - ‎8 authors
I do not know what could have caused this but when i lock my car... ... lock yourdoors with your key fob(might have to hit the lock button twice) ... The alarm/horn should start beeping. ... 2010 Hyundai Genesis Coupe 2.0T R-spec in Karussel White.... My lights flash when I lock it, but the horn doesn't sound.

2013 Hyundai Elantra Engine Won't Turnover, Won't Start ...

www.carcomplaints.com/.../Elantra/.../engine_wont_turnover_wont_start...
The 2013 Hyundai Elantra has 19 complaints for engine won't turnover, won't ...

Jan 04, 2016 | Hyundai Cars & Trucks

1 Answer

Starter


u may just need to titen connections on batt or motor----starter cud be failn-cud test it under load--batt cud be old and not holdn 12.6 volts--------ignition switch on steering colum mite hav issues

Jul 07, 2013 | 2010 Hyundai Elantra

1 Answer

I have a 2010 hyundai elantra and it is leaking water from under the dash when it rains


A 2010 Elantra?... it's still under warranty. Take it in to the Hyundai Service Dept and have it diagnosed & repaired under warranty.

Jun 28, 2011 | 2010 Hyundai Elantra

2 Answers

Where is the starter located on a 2006 hyundai elantra


LOOK UNDER AIR FILTER.ITS BOLTED TO SIDE OF ENGINE NEXT TO TRANSAXLE.

Apr 11, 2010 | 2006 Hyundai Elantra

1 Answer

2010 hyundai elantra Manual trans won't start.


Check engine block ground.
Check starter.

Feb 19, 2010 | 2000 Hyundai Elantra

2 Answers

2000 hyundai elantra alarm goes off where is the


There is NO kill switch on the 2000 Elantra... HOWEVER, there is a thing called the Key Fob (keyless remote entry system). There is, however, a system in place called the 'starter kill' circuit and it is activated when the burglar alarm goes off.... it's called the burglar alarm relay and it is activated to prevent the engine starter system from being used. There are three ways to get the engine started in such a circumstance... 1. use the key fob to 'disarm' the system... 2. put the key in the ignition and turn it to the 'RUN" position and wait until the alarm stops (horn stops beeping and the parking lights stop flashing), then the engine will start.... 3. pull the starter relay from the UnderHood junction box and bypass the starter circuit (key in ignition and in the 'RUN' position), jumper the starter solenoid circuit to energize the solenoid to start cranking the engine -- it should start then.

Oct 03, 2009 | 2000 Hyundai Elantra

Not finding what you are looking for?
2004 Hyundai Elantra Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...