Question about 2005 Volkswagen Jetta

Open Question

2005 vw jetta check engine code p0544

Car runs fine and then sometimes. When I accelerate it bucks into 2nd gear

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

j_del
  • 1586 Answers

SOURCE: 2000 VW Jetta VR6 My

You may have a bad coil pack - try moving two of them around and see if the misfire follows the coil pack or stays at the same cylinder. If it follows the coil pack, get a new one. If it stays in the same cylinder, inspect your spark plug wires and make sure the plug is gapped correctly.

Posted on Aug 09, 2008

junkman1249
  • 552 Answers

SOURCE: 2001 Jetta Manual Transmission misses 2nd gear

throw out bearing

Posted on Dec 05, 2008

  • 17 Answers

SOURCE: Struggling to Accelerate immediately after starting engine

Definitely not the fuel pump. A fuel pump will either work, or it wont. It could be a fuel filter, though unlikely, again if it was clogged there would be nothing. Could be spark plugs/wires, a faulty coil pack, Could also be a handful of sensors (o2, MAF, are a few that come to mind). Does it have a manual transmission? If so can the car be started without engaging the clutch (in neutral)? If so check the 2 clutch sensors attached to the clutch pedal.

Probably a sensor. Go to Advanced Auto parts and have them pull the code. Then google it. Or check out Forums.vwvortex.com

Posted on Jul 07, 2009

cj5470110
  • 41 Answers

SOURCE: 03 VW Jetta 1.8 Turbo- Check Engine Light- Diagnostic test: 2181

get a new coolant temperature sensor.

the orginal black ones are faulty.

make sure it is the green topped one.

also do a normal tune up with spark plugs, clean the maf, maybe replace coils packs.

Posted on Jul 11, 2009

  • 194 Answers

SOURCE: CODES P0134 AND P0135 ON 96 JETTA

P0134- O2 sensor Circ, bank 1, Sensor 1 no activity detected

P0135- O2 sensor heater circ, bank 1 sensor 1 malfunction

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to test crank sensor 2005 vw jetta 2.5


Call Auto Zone, Advance, Napa... give them the code, and go from there... Have you cleaned out your Idle air control valve ?

Aug 08, 2014 | Volkswagen Jetta Cars & Trucks

1 Answer

2002 vw Jetta gets stuck in 3rd gear


Transmission Speed Sensor would be my guess.

Jun 26, 2013 | 2000 Honda Accord

1 Answer

2006 VW Jetta code U0100


This problem is with ecu / ecm= engine control computer. These are a common and horrible problem on vw's, particularly on tdi's. The signs in a tdi are when car dash lights come on, but no glow plug light,trans gear lights flash, but car still tries to crank. And hopefully ecu has enough power to out out code u0100= no communication with ecu. Unfortunately the ecu will need to be replacd. The ecu is located under the hood, near and under the wipers. Used ecu with same codes run $50-200. New $1000. If get used one make sure has a return policy. codes must match production quarterly year.

Apr 14, 2013 | 2006 Volkswagen Jetta

1 Answer

I have a 2005 VW Jetta 2.0 and the Check engine light comes on and stays on then shuts off for half a day then comes back on.


TAKE CAR TO ANY AUTO PARTS STORES, THEY WILL CODE SCAN CAR FREE SEE WHAT TROUBLE CODE CHECK ENGINE LIGHT IS FLASHING.

Jun 19, 2011 | 2005 Volkswagen Jetta

2 Answers

Sluggish engine pontiac g6


Sounds like a transmission issue, have the car scanned for ant transmission related codes. Most transmission shops will check to make sure your transmission is working 100% free of charge. With what you have described, almost sounds like you don't have 1st or 4th gear and your transmission is running on 2nd and 3rd gear. Easy fix if the 1st-4th solenoid needs to be replaced, or the wire harness has gone bad. Start with getting your car scanned and let me know if your transmission is starting on 2nd. Good luck

Jan 28, 2010 | 2006 Pontiac G6

1 Answer

VW Jetta 2005 engine indentification needed


The dealer gets there build info via computer link to the manufacturer data base for paticular car, you can be 99.99% it is correct.

Oct 17, 2008 | 2005 Volkswagen Jetta

Not finding what you are looking for?
2005 Volkswagen Jetta Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...