Question about Cars & Trucks

Open Question

Pontiac montana versatrak rebuild proceedure

I'm looking for detail on rebuilding the rdm in my pontiac montana wither awd versatrak. Please help!

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 55 Answers

SOURCE: replace thermostat 2003 pontiac montana

yes but with the right shaped wrenches and tiny hands it can be done without removing the exhaust crossover pipe

Posted on Oct 16, 2008

  • 2920 Answers

SOURCE: 2002 Pontiac Montana Thermostat replacement

check the coolant level fiirst...if that is low it wont give you any heat.....to change the thermostat you have to follow the top radiator hose to the engine.at the send of it you will see a clamp take it loose...then you will see the thermostat housing its held in place by 2 bolts . once you remove them you have the thermostat....make sure you clean all the old gasket material off both the housing and mount.also make sure you get a new gasket.

Posted on Jan 29, 2009

tse22
  • 103 Answers

SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana

On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

Posted on May 12, 2009

  • 15 Answers

SOURCE: 2003 pontiac montana leaks condensate water in the drivers floor

Bet the drain is clogged with leaves. Look under the blower motor under the hood. Can almost be that the cowling has been filled with leaves at one time or another. Got to clean that stuff out every now and then.

Posted on Jun 20, 2009

  • 534 Answers

SOURCE: pontiac montana wiper reterned in up right after

While wipers off in parked position, remove wiper arm and re-position arm to correct stowed position.
Re-tighten any wiper arm attachment nuts/screws etc.
Check wiper attachment arm for damage or cracks at the spigot mount. Replace if damaged.

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2001 Pontiac Montana transmission will not shift into overdrive


sound like Modulator elect fault.... worth doing this first lot cheaper than tranny rebuild

Nov 09, 2013 | 2001 Pontiac Montana

1 Answer

00 pontiac montana wipers stay up?


I would bet these are controlled by some type of motor relay or wiper control module. I would browse a Haynes Manual (www.haynes.com) and see there is a part that could be easily acquired new or used from a salvage yard.

Dec 15, 2011 | 2000 Pontiac Montana

1 Answer

2004 Pontiac Montana - problems with my speedometer, gas and temperature gauges ... sometimes they work, sometimes they don't work. This has been going on for months. Fuses were checked and are fine....


Unfortunately, GM really screwed up the 2003-2006 instrument panels and there have been thousands of problems but not recalls so far. You might want to consider a complete rebuild of your instrument cluster. There are multiple on-line places that you can send your instrument panel into and they will completely rebuild your instrument cluster and replace the dashboard lighting also. Most of them charge in the $200.00 range for this service.

http://gmgaugerepair.com/vehicles/ is just one of the many rebuild services available

General instructions on how to remove your instrument panel - http://circuitboardmedics.com/files/instructional/instrumentclusters/general.pdf

Aug 11, 2011 | 1999 Pontiac Montana

1 Answer

2000 Pontiac Montana . Goes into gear hard when it shifts. Has 140000 miles on it.


It sounds like the pressure control solenoid inside the transmission. With that many miles I would suggest going ahead and rebuilding it. You need to remove the transmission from the van anyway to replace the solenoid. I have rebuild several of these, be sure to put in a shift kit, it makes a big difference. I've rebuilt them before and wasn't happy with the way it shifted, so I pull it back out, put in the kit and that did the trick. So, needless to say, I always put the kit in the first time. Although, I do know a guy that changed his filter and added some Lucus oil treatment for the transmission to the new oil, and he says he hasn't had that problem sence........makes me wonder.

Mar 07, 2011 | 2000 Pontiac Montana

1 Answer

EXPERIENCING PROBLEMS WITH THE STARTING OF 2002 PONTIAC GRAND AM.ICAN'T AFFORD A NEW STARTER AND WAS TOLD I COULD REBUILD IT.I NEED THE INFO TO DO SO PLEASE.


you can rebuild it. the kits are orderable from your auto parts store but are about the same price as a rebuilt starter after you turn in your core. i would try looking online for the starter you need there are lots of warehouses that sell over stocked or common parts like that for less than your local parts store.

Jan 30, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

Where is the 2-3 shift solenoid located on the 2004 pontiac montana and how much is the replacement part and repair job


The solenoid is inside the valve body, If you remove the pan, the filter, you are looking at the valve body. You can remove it, replace the solenoid, but it is no guarantee that it will fix the problem. It could be a number of things, lost ground, low fluid. the part is about $75, and the repair is fairly simple, but a tranny shop will tell you it is shot, you need a rebuild, and they want $1400 . So, if you know someone who can change the fluid, they can change the solenoid. But remember, it is no guarantee. i just did mine, didn't work. Hope this helps.

Aug 11, 2010 | 2004 Pontiac Montana

1 Answer

Can I drive my AWD 2002 pontiac montana without the rear wheel drive shaft?


Sounds like a prob I seen with a Jeep.......Yes, but I would be very careful. If it breaks a u-joint it could get hairy !!!!!!!!!

Dec 19, 2009 | 2002 Pontiac Montana

3 Answers

2000 pontiac montana wont go into 4th gear


I would be interested in knowing if the thermostat is sticking open. Most Overdrives are prevented from engaging until the coolant temperature is over 177 degress F. Check you temp gauge...does it read Low? If so, change the t'stat, and see if that fixes your problem, or, if that does not help, get a complete transmission FLUSH, BEFORE you go out and get a rebuild. You just might save a ton of money.

Aug 29, 2009 | 2000 Pontiac Montana

1 Answer

Rear wiper stopped working on 2004 Pontiac Montana Minivan AWD


Have you checked all fuses? Refer to owners manual for location.

Jan 21, 2009 | 2004 Pontiac Montana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...