Question about 1996 Mitsubishi Mirage

1 Answer

Heater and Defroster not blowing air

Heater blower works in all speeds but very little air coming out of floor heater and defroster. Dash vents have good air flow but air is not warm.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 97 Answers

Check vent flaps inside the blower unit....

Posted on Nov 24, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 356 Answers

SOURCE: 2002 eclipse heater blows cool air

Check your antifreeze level and if low then add antifreeze until the radiator is full and the overflow tank is up to the correct level. that should solve your problem. If it isn't that, chances are your thermostat could be stuck open which isn't allowing the coolant to warm up properly.

Good Luck

Posted on Dec 19, 2009

pittmanc
  • 194 Answers

SOURCE: heater blows cold air

the heator core has gone out this is a divise that uses hot coolent from the engine to heat the air that blowes tru your vents it is located behind the glove box some times it's tricky to reach look under the hood to find 2 hoses running side by side in to the fire wall on the passenger side to pin point the location

Posted on Dec 05, 2008

heimlich
  • 1978 Answers

SOURCE: 2003 Galant heater just stopped

There is an electric motor that turns heater core on and off. It's located under the dash to the left of the glove box. Some dis-assembly required. The part will cost about $120 to $180. part number is #MR958603. I saved money by purchasing it on line. It is a stocking part at most Mitsubishi dealers. Once you pull the glove box out and remove the bottom half of the dash all the way across, you should be able to gain access to the motor to replace it. Caution: if you do not put everything back in correctly and tie/tape it all back down carefully in the correct places you will have lots of under the dash noises when you are done.

Posted on Nov 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to repair


i'd think that the vent adjuster knob/slider is not working correctly strip out the heater panel around the control knobs and check the vent direction is working properly either stiff operation so a little wd40 on the cable would probably do the trick or some thing causing the vent itself to not move

May 01, 2014 | 2004 Ford Crown Victoria

1 Answer

1996 Montero Heater Blower not working


I assume your heater setting is electric control, if so either your defrost and floor heat switch failed or wire problem. For the air not hot, check the heat control valve on the top of the hose it should be in front of the firewall. I don't know your car is using mechanic valve or electric control valve. Anyway check there first. Good luck.

Nov 24, 2013 | 1996 Mitsubishi Montero

1 Answer

Blower heater only bows on feet and defroster


Usually a problem with one of the blend doors under the dash.

Sep 06, 2013 | 2001 Nissan Quest

1 Answer

2002 ford explorer blower selection controls broken


Faulty door actuator motor or vacuum leak at heater harness under dash. commonly disturbed when installing stereos

Mar 11, 2010 | 2002 Ford Explorer

1 Answer

What is a blender/ it is suposed to a part of the heater area


The "blender" would refer to the blend actuators that change the flow of air from floor to vent to defrost or combinations. Properly working blend doors will allow you to direct air to the dash vents, the floor, the defroster, the floor and defroster or the floor and dash vents. If it is not working the heater will still work but you will hae no control oer where the air flows.

Dec 19, 2009 | 1999 Jeep Grand Cherokee

1 Answer

A/c blows cold but comes out of the defroster instead of dash


check vacume lines to and from heater switch

Aug 23, 2009 | 1983 GMC Jimmy

1 Answer

Defroster won't blow air


It sounds like the heater control panel is'nt opening the defroster door
under the dash. You need to check cables or vacuum lines under the dash to see if any came off the diaphrams or levers.

Feb 03, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Heat wont blow through heater or defroster vents


Had the same problem. believe it or not i changed the gas cap and got heat all around. something about pressure.

Dec 05, 2008 | 1993 Chevrolet Corsica

Not finding what you are looking for?
1996 Mitsubishi Mirage Logo

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...