Question about 2001 Ford Explorer

Open Question

It rotates b ut wil not crant - 2001 Ford Explorer

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

It spinsover but will not crant


Nov 24, 2013 | 2001 Ford Explorer

1 Answer

05 kia sorento water in gas tank dumped gas and drained fuel pump put a gallon an a half gas back in tank the kia still want crant what do i do next

Are u sure u getting gas to the enging , u have to make sure u getting gas . Or used the quick start and spray little bit in the throttle body , this is where the air filter is and the hose that lead to the throttle body. If it start. A little then u know it is gas problem .

Oct 31, 2013 | 2005 Kia Sorento 3.5

1 Answer

Vibration when front driveline is on.Take it off no vibration.

The pinion bearing has escessive preload. When this happens there excessive vibration.On 4x4 the front and the rear drive shaft has to rotate at the same speed. you are mainly locking up, the pinion is not moving freely

Feb 29, 2012 | Cars & Trucks

2 Answers

What does the crank sensor look like?

I've attached a photo. It's under the timing cover near the crankshaft.

Oct 18, 2010 | 2006 Kia Sorento

1 Answer

My 1995 Mitsubishi MityMax Will turn over again and again but wil not fire. Could this be the fuel relay (which I'm unaware of its location), or what???? Anyone, please help me ! Thanx !!

I don't think there is a tougher system to troubleshoot on your car than the charging/starting system. This is due to the fact that there are many things that can go wrong and it's tough to test some components without special equipment. Let's go over some possible situations and their possible causes.

1-open your cup duster putter check your rotor if it is not broking and rotating when turn to start the

Car if it is rotating that is good

2 check your one of your wire if you still don't have spark

Sep 26, 2010 | 1990 Mitsubishi Mighty Max

1 Answer

No tail lights on my 05 nissan navara and crant find a fuse for it

fuse should be in engine compartment fuse box. I cannot access the manual, as this car is not in our database (Europe only?). There is also a relay. The relay should click when you step on the brake. If not, replace the relay. If you have more questions, please reply.

Sep 10, 2010 | Nissan Pathfinder Cars & Trucks

1 Answer

I have a 89 toyota 4x4 V-6 and it wont start i just put a new starter in it wont crant over battery is good it only starts everynoy and then

i have a 1989 toyota pickup 4x4 3.0 v6 changed the starter and only starts if its warm out brand new batt. new starter. help me with problem

Sep 07, 2010 | 1989 Toyota Pickup SR5

1 Answer

Rebuilt engine 5.7 l 1998

I broke down and purchased a new crank shaft sensor . It cost $15000 hated to spend it because everbody told me they just don't fail , and why would it when it worked fine before the motor was rebuilt. IT FIXED IT.

Feb 03, 2009 | 1999 Chevrolet Silverado 1500

3 Answers

My car won't star on

Turn the key to the ON position for about 15 mins. then turn the back one stop. After that, try to start the car again. If that doesn't work turn the key all the way back to the OFF poistion for a second or two and then try to start the car again.
My daughter had this issue and I found this solution on another site and worked perfectly. They says this can happen if you attempt to start the car to quickly. It will enage the security system. They recommend turning the key to the ON position first and wait until the instrutment gauges re-set before attempting to start the car.

Hope this helps you out. Good Luck !

Aug 02, 2008 | 2003 Pontiac Grand Am

Not finding what you are looking for?
2001 Ford Explorer Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides