Witt cranks and runs for 3-5 seconds & dies. I can hear the fuel pump running. Checked fuses and relays.
SOURCE: cranks but won't start fuel pump not coming on
put a small amount of fuel in the intake near the throttle plate then crank and see if it fires, if it does then it's a fuel problem, if it does not fire then pull a plug wire and put a philips head screw driver into the plug wire hold it 1/4 inch away from a good ground then have someone crank it over, you should see spark and it should be blue, if not then you have a ignition problem a bad coil or cam sensor but need to know what you found out on the two tests I told you first to give you a direction to go.
SOURCE: 2007 Jeep Wrangler Unlimited Crank-No Start. Replaced FP.
Hey Tim take a look at this, will this help ?
SUBJECT:
No Engine Crank Or No Engine Start Due To Electronic Lockup Of The WCM / SKREEM
OVERVIEW:
This bulletin involves the replacement of the Wireless Control Module (WCM), and if
equipped, the replacement of the Electric Steering Column Lock (ELV). The WCM is also
referred to as the Sentry Key Remote Entry Module (SKREEM).
MODELS:
2007
SYMPTOM/CONDITION:
The customer will experience a no engine crank AND a no engine start condition. Also, the
remote keyless entry (RKE) system will not operate. This condition may be due to an
electrostatic discharge (ESD) from the ignition key into the Wireless Control Module
(WCM), causing the WCM to electronically lockup. This condition may occur more
frequently in dry and/or cold weather conditions where a sufficient electrostatic charge is
more easily produced. This condition is corrected by the replacement of the WCM
DIAGNOSIS:
1. With the condition present (i.e. the vehicle in the no crank / no start condition), connect
the StarSCAN® scan tool to the vehicle.
2. Turn the ignition switch to the “ON” position, and power up the StarSCAN®.
3. If the WCM is electronically locked up, the StarSCAN® will display the WCM as being
“off bus”.
4. If the no crank / no start condition is present, and the WCM is “off bus”, then reset the
WCM by temporarily removing the IOD fuse (with the key out of the ignition switch),
wait for 10 seconds and then reinstall the IOD fuse.
5. With the IOD fuse reset having been performed, verify that the vehicle will now crank,
start, and run.
6. If the condition is temporarily corrected by performing the above steps, and if the part
number of the WCM is earlier than the part number of the WCM listed in the part
reference table in the Service Bulletin Parts Required Section below, then perform the
Repair Procedure.
SOURCE: 1998 gmc 2500 sle 5.7 wont stay running
this is in fact the right answer check the oil guage in the truck it should read about 375.
SOURCE: passat 96 tdi , only runs for 2-3 seconds
i have 2 keys for my passat.with 1 key the engine runs perfect and with the other key the engine runs 2-3 seconds
SOURCE: my car will crank but won't stay running, i
Could possibly be the anti theft system. This system can actually turn off your fuel injectors 1-5 seconds after starting. http://vatspasslockpasskeysecurityhelp.yolasite.com/
1,238 views
Usually answered in minutes!
×