Question about 1998 Chevrolet Tahoe

1 Answer

Not getting gas

Getting gas to the throttle but not in side

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 5,408 Answers

Sounds as if fuel injector is not getting pulse. Could be bad fuse, low fuel pressure, bad ecm, other.

Posted on Dec 01, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a ford e 350 van and its showing a electronic throttle control signe and i cant give it gas to accelerate


The TPS throttle pisition sensor .It moves everytime the gas pedel moves .
Its a ware part on the side of the throttle body although it could be a bigger problem this is a good place to start with out getting to techinacal.
Its on the end of a shaft that runs through the air horn look at the throttle cable were it attaches to the throttle body the part that moves is were it is

Apr 11, 2015 | Ford Cars & Trucks

1 Answer

My 1998 200sx stopped accelerating while getting on freeway.


Could be the cable that actavates the throttle plate on the intake..
The cable comes from the gas pedel and pulls on the throttle plane in the intake manifold.. opening the plate to let air flow through to the engine. On the other side from the cable is a plastic sensor with wires attached to it this is the Throttle position sensor.. if this is disconnected or broken the computer cannot receive the single that you are pushing on the gas pedel.. very rare for the throttle position sensor to break completly.. best posibility broken cable.. open hood find cable connected to throttle body, have someone in car push pedel see if it moves. Good luck.

May 11, 2014 | 1988 Nissan 200SX

1 Answer

No gas coming out of the carb


on cool motor, remove fuel line to throttle body, turn switch to accessory position fuel should flow freely. no flow check filter located on frame rail. or defective fuel pump. pressure should be(if checked with good guage)45-55 psi. if all checks out throttle body jet clogged with gunk or you have broken-damaged throttle body wires. all of this i have found on 2.8 liter engines.-------jawstech goodluck hope this helps.

Nov 25, 2011 | 1993 Chevrolet S-10 Blazer

2 Answers

Gas pedal is hard to depress


Do you baby your car ...if so usually the throttle body gets caked up with gunk i would recommend to take off the TB and clean it ...this should solve your problem ...

May 25, 2011 | 2003 Buick Regal

1 Answer

Where is the throttle located on a 2002 chevy trailblazer?


"Throttle" is the gas pedal. If you're looking for the throttle body, it's towards the drivers side firewall. Has a 3" rubber hose attached to it. Need to take off the plastic box on the very top of the engine to get to it. But is very easy to get to.

Dec 22, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

Need location of TPS sensor . Autozone employee told me that the code that was reading the computer was for the TPS sensor replacement. I don't have an idea where it is


The TPS is located on the opposite side of the throttle cable on the throttle body. If you don't know what the throttle cables are, get a friend to sit in the van and push the gas pedal down until you see something moving. it will be on the opposite side of the movement

Nov 15, 2009 | 2003 Ford E150

1 Answer

My gas pedel gets stuck half way down some times


The throttle position sensor is most likely bad or it just may be the throttle cable but I think it is the Throttle position sensor it is located near the throttle valve follow the throttle cable to the end this is where the throttle valve is and the Throttle position sensor is located near the throttle valve on the opposite side it will have a plug going to it and it is held on with two torx head screws purchase the tools and replace.

Nov 03, 2009 | 1998 Buick Century

2 Answers

Car stuck accelerating


pedal may not be stuck but cable or linkage are have professionly check could be a dangerous

May 31, 2009 | 2004 Dodge Stratus

1 Answer

1995 impreza starts but low rough idle


Sounds like the TPS (throttle position sensor) at the throttle body there is a black box on the opposite side to the cable mech, looking at it from front of car place a multimeter into where the 4 wires enter. between pin 1 (nearest to you) and pin 2 when the throttle is closed (no foot on the gas) it should read 5volts if not losen the 2 screws that lock it (this requires a very long screwdriver) and twist it until it reads 5v.

Dec 12, 2008 | 1995 Subaru Impreza

Not finding what you are looking for?
1998 Chevrolet Tahoe Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...