Question about 1996 Pontiac Grand Am

1 Answer

How hard is it to change 23 shift solenoid in 1996 grand am model 4T60E trans

Codes P756 and 758 come up on scanner.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Should be easy it's located on the top of the transmission by the shift lever.

Posted on Nov 25, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 158 Answers

SOURCE: 1993 grand am transmission 4T60E

Not exactly sure of what you are referring to, but I'll guess. If the spocket you are trying to remove is the one under the large clutch plate (4th gear), you'll have to remove the axle clip in the differential, then pull out axle, 4th clutch hub, and then the sprocket will come off. Did i guess right?

Posted on Apr 15, 2009

  • 1 Answer

SOURCE: 1-2, 2-3 Shift solenoids on 2001 Grand Prix GT

I just did this today just lower the subframe it was plenty of room and didn't have to take it out

Posted on Feb 28, 2010

  • 90 Answers

SOURCE: Our 2005 Pontiac Grand Prix is hard shifting. The

The codes mean that the Electronic Pressure Control Solenoid is going bad. The computer detects that the shifts are taking longer than 0.65 seconds. Then the computer commands maximum line pressure to avoid burning out the clutches, hence the hard shifting. My 2002 Grand Prix had the same problem, and I had great luck just installing a shift kit to speed up the shifting and haven't had any further issues.

Posted on Nov 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 blazer 4l60e trans just rebuilt. Hard 1-2


Sounds like full pressure apply from pcm. Must check for full 12v at trans connector. Also check all ground twice. That is a hard trans to install and things tend to get left loose.

Sep 11, 2014 | 1995 Chevrolet Blazer

1 Answer

HOW TO REMOVE 4T60E TRANSMISSION FROM A 96 Z34 MONTE CARLO?


You don't have to pull it to replace the TCC. Remove the pan and you can access the TCC solenoid. 40b12bb6-08f8-4f1c-b959-9bfe6f7b08fb.gif

Aug 06, 2014 | 1996 Chevrolet Monte Carlo

2 Answers

My jeep shifts hard when it goes into overdrive why ?


Really need more information for your problem, but without that I can suggest you add a can of transmedic to the trans. oil,then after 1k miles,change the trans. fluid and filter using a very good quality trans fluid.

Jun 13, 2014 | 1996 Jeep Grand Cherokee

1 Answer

06 pontiac grand prix shifting hard off a dead stop


If all gears are shifting hard, may have a code p1811 set-trans adapt long shift. When this code sets it commands full line pressure causing hard shifts. Usually the pressure control solenoid is at fault. You need to have it scanned for codes.

Nov 21, 2012 | 2006 Pontiac Grand Prix

1 Answer

Where are the shift solenoids for 1994 Berretta 4t60e transmission located?


buy a hanes or chilton book for your car and it should be able to show you

Jul 24, 2012 | 1994 Chevrolet Beretta

1 Answer

Trouble code p1784 on dodge grand caravan


found this on another page.....
Originally Posted by vasau viewpost.gif The vehicle came in with 2 trouble codes and complaint on a transmission shifting.
P1775 Solenoid Switch Valve Stuck in TCC.
P1784 LR Pressure Switch Circuit.
After clearing these 2 codes the van ran normal for about 20 minutes without any issue, but after, the problems came back with no codes.
LR Pressure Switch is always in "Open" position. Must be closed at Park, Rev and Neutral.
Could anyone explain to me how the switch works. Is this the solenoid pack or the LR Pressure issue?The L/R pressure switch should be closed in P/N only. The switch should open when put into REV if the trans is not in limp-in mode. All switches will stay CLOSED if the trans is in limp-in mode. Disconnect the trans 8-way connector at the solenoid pack. Key on scanner hooked up apply 12 volts to the L/R pressure switch pin in the 8-way connector and watch for the switch to change from open to closed. If it does change the SSV may be stuck in the TCC position. You will have to remove the valvebody and inspect the solenoid switch valve to know for sure. The pressure switch itself is in the solenoid pack. If you have an old solenoid pack changing it is easier and quicker than inspecting the valvebody. Perform your diag for fault P1784. I believe the pressure switch is also closed in 1st gear also. Hope this helps.

Jan 17, 2011 | 1996 Plymouth Grand Voyager

1 Answer

Our 2005 Pontiac Grand Prix is hard shifting. The diag codes that came up are trans codes P1811c and P1819c. Does anyone know what these codes mean? I'm having an impossible time finding them. Thanks in...


The codes mean that the Electronic Pressure Control Solenoid is going bad. The computer detects that the shifts are taking longer than 0.65 seconds. Then the computer commands maximum line pressure to avoid burning out the clutches, hence the hard shifting. My 2002 Grand Prix had the same problem, and I had great luck just installing a shift kit to speed up the shifting and haven't had any further issues.

Nov 27, 2010 | 2005 Pontiac Grand Prix

1 Answer

4T60E transmission in a 1996 Buick Century won't shift from 2nd to 3rd gear, possible cause?


Shift solenoid ,manual shift valve, blockage in 3rd gear circuitry, defective band and clutches.

Mar 31, 2010 | 1996 Buick Century

1 Answer

I need the diagram's transmision of Grand Caravan 1996 liter 3.3 please, Becose error code P1782


782 code is trans is 2-3 shift problem. This is inside the Trans Solenoid. This sits on the trans above the trans pan. $200 part includes gasket

Dec 29, 2009 | 1996 Dodge Grand Caravan

1 Answer

I took trans out of 92 trans port with 3.8 engine and installed in 1995 grand am with 3.1 engine and it will not shift from 2nd gear . is internal wiring different? Both had 4t60e trans .


yes very much sorry would need to change computers and other **** the tranny is set up for a larger engine and different RPM ranges

Oct 07, 2009 | 1995 Pontiac Grand Am

Not finding what you are looking for?
1996 Pontiac Grand Am Logo

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...