Question about Chevrolet Cars & Trucks

Open Question

Location of ignition coil, 2001 Chev. Blazer, 4.3L, 4WD

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 436 Answers

SOURCE: 2001 Chevrolet Blazer:

these 4x4 units are controlled by a module in passenger kick panel. water leaks onto module and after time is corrodes the connectors and the unit. check for this and repair where needed

Posted on Sep 11, 2009

Ad
GM Elec
  • 1000 Answers

SOURCE: 99 chev blazer, service 4wd light is on. Simple

There are a couple of fuses you will want to check. They are located in the under hood fuse box. The TBC ( truck body controller) and ATC (automatic transfer case) fuses.
If both are good, take the truck to your local Auto Zone and ask them to scan the vehicle for "trouble codes". Write the codes down and respond back.
Below is a diagram of the under hood fuse box and the fuse locations.

961db47.jpg

Posted on Oct 10, 2009

  • 35 Answers

SOURCE: where is the 4wd actuator located?

on the front diff

Posted on Jan 10, 2010

  • 1 Answer

SOURCE: 1992 Chevy Blazer Ignition Diagram

trying to remove the ignition from my steering column having problem getting the turn signal switch from the column

Posted on Sep 29, 2010

  • 1 Answer

SOURCE: need how to and location to replace knock sensor

Im looking for the same part location on a 2002 chevy blazer. It might be under the distributer cap.

Posted on Nov 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of coil pack in 2001 chev 4x4 s-10 truck


on pass side of the intake mid ways back its next to the ignition module. ull see a black lil box next to an alum lil box with fins on it, thats the black box that the plug wire goes into

May 06, 2014 | 2001 Chevrolet S-10

2 Answers

What are the to coil packs on a set of spark plug wires on a 2001 4.3 chev blazer for and what plugs do they go on


Your Coil Pack Is Separate And Plugs Into The Middle Of Distributor Cap.Follow The Middle Wire To Coil Should Be On Passenger Side
Easy Quick Change Out. Cost Is Around $40

Mar 11, 2013 | 2000 Chevrolet Blazer

1 Answer

1999 chev blazer won't start new fuel pump


So, do you hear the pump buzz on, when key is on? If that's good, then check your ignition circuit: check for spark at a plug. Use insulated pliers, hold end of plug wire 1/4 inch form engine bolt or ground source. When cranked, you should see a bright blue spark. Yes? Try another plug wire, too. No? Try another plug wire. If you have NO spark, could be your coil, coil pack, crank position sensor, ignition module. I would recommend using a diagnostic flow-chart to go through the ignition circuit. That way, you are not replacing unecessary parts_Expensive! Of course, if you have spark at plugs, your ignition circuit is good! Then you have to look further, like your injector circuit. Good luck.

Oct 30, 2011 | 1999 Chevrolet Blazer

2 Answers

Trying to locate the ignition module for chevy blazer s10 1994


Ignition module sits in the ignition distributor, remove distributor cap, there will be two elec. harness plugs, the one with two wire's is for the pick up coil, the other one is for the ignition module, just unscrew module out of distributor and install new one.

Sep 23, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

Location of turn signal module in 1999 chev blazer ls


For 1999 Chevrolet Truck Blazer 4WD 4.3L SFI 6cyl the Flasher is located front seating area, passenger side, behind dash, under access panel, mounted in fuse panel in glove compartment behind.

Good luck (remember rated this).

Jul 19, 2010 | 1999 Chevrolet Blazer

1 Answer

What setting should i be on for the four weel drive for a 1999 chev blazer


Should always use 2WD on dry pavement

In snow or mud, 4WD H

4WD L is for pulling power at very low speed

Sep 24, 2009 | 1999 Chevrolet Blazer

1 Answer

Where is the ignition module if i do decide to change it. I am gettimg some sputtering specially on start up


Your vehicle does have an ignition module. It's located under the ignition coil pack. (the 3 ignition coils) It's not cheap to replace. AND it's a bad guess as being the cause of your sputtering problem. Charlie

Jun 01, 2009 | 2001 Chevrolet Venture

1 Answer

Need how to and location to replace knock sensor


Im looking for the same part location on a 2002 chevy blazer. It might be under the distributer cap.

May 30, 2009 | 2001 Chevrolet Blazer

2 Answers

1999 chev blazer 4x4 system


I have a 1999 chevy blazer that stuck in 4 wheel drive. How do you get it out.

Nov 23, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

270 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...