Question about 2002 Pontiac Montana

Open Question

02 pontiac montana starter wiring

Need to find out where the wires for the starter go. one person took starter out and another is trying to replace it and cant figure out the wiring situation

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 393 Answers

SOURCE: Installation (wire diagram) for remote starter on a 2001 Pontiac Sunfire

try going to diy rattler.com

Posted on Nov 15, 2008

  • 7 Answers

SOURCE: Pontiac Montana starting problem

All 4 power wires go together on the large center stud on the solenoid.
The purple wire goes on the small stud.
The purple wire supplys the trigger signal when the key is turned to the start position.Since your solenoid is clicking when the key is turned to start this is working properly.
I would check battery connections and then check power connections on solenoid again.Make sure all connections are clean and tight.

Posted on Dec 03, 2008

landsend
  • 1066 Answers

SOURCE: need to replace thermostat on pontiac montana van.

public library...Chilton or Haynes auto repair manuals or collisionrepairadvice.com     make sure you bleed the system

Posted on Apr 03, 2009

  • 3 Answers

SOURCE: 2000 pontiac montana power window|locks doesnt

I had a 99 with the same problem, and suggest you check under the passenger side front carpet. Remove the flat door kick plate, lift up the carpet on the front passenger side floor and you will see a large wiring harness running along the floor, wrapped in black tape. Water and salt gets into this harness and will rot out several wire splices that you will see. Look for wires that run from 2 wires down into one (under black tape.) These are spliced together, and rot out. There was several large gauge wires/splices(windows up and down) and I think 2 very thin wires/splices (lock/unlock) . Even if the wires look connected, give them a good tug, they will come apart and be green with corrosion. This is a very common problem and worth the effort to check out. Repairing these splices fixed both the power windows and locks at the same time. Good luck

Posted on Aug 15, 2009

dttech
  • 4803 Answers

SOURCE: plus we cant find a wiring diagram for the 2003

Hi Julia,
Need a wiring diagram for your 2003 blower motor circuits? I would be happy to send them to you. I cannot post them her on the FixYa site due to size and copyright restrictions. If you click on my profile picture, go to my page and click the "pro Services tab Click on any of the services listed (it doesn't matter, you will be connecting with me no matter which one you click) Sign up for email support and I will send you a link to download the diagrams you need.

Posted on Oct 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the starter on my 2001 pontiac montana


Disconnect the positive battery cable, remove the wires from the starter solenoid, remove starter. I can usually sneak it out of there without removing to much of anything else.

Aug 08, 2014 | 2001 Pontiac Montana

1 Answer

Wiring schematic


That's a pretty thick book available from the dealership. Online sources will only give you partial diagrams

Jan 28, 2014 | 2002 Pontiac Montana

1 Answer

Can't remember where wires go on starter motor on my Mercedes w203 C200 CDI 2004


Your listing shows a 2000 Pontiac Montana...your question relates to the Mercedes? On the Pontiac, there are only 2 wire connectors to the engine starter motor...They use different sizes to match the connecting wires...

Nov 01, 2013 | 2000 Pontiac Montana

1 Answer

Pontiac Montana 2006 won't start just clicks but


it sounds like the starter motor could be worn out, or could be as simple as the main pos wire is bad or corroded

Jan 18, 2012 | 2006 Pontiac Montana

1 Answer

01 pontiac montana 3400 motor no power going to starter, have replaced starter and checked all fuses and breakers. checked at starter with test light ,power on one side but not other. nothing on key when...


there is a starter relay by the battery atachted to the radiator suport if the batt was changed resintly it may of been knock off the retainer and pulled wires out of the connector try that and is the security light on ?

Jan 22, 2011 | 2000 Pontiac Montana

1 Answer

2000 pontiac montana Occasionaly, when turning the key to start, it will be dead dash lights will illuminate, but no life to engine to start it What's up?


check starter wiring for loose nuts, bad connetion. n what not. clean up terminals if needed n see if it turns over if not. check for power coming frm the yellow wire, or the smaller one. with the key held in start position, in no power you will need a starter solinoid. if you do have power go grab a starter n put it in,

Dec 16, 2010 | 2000 Pontiac Montana

1 Answer

Where is the starter on the 2000 montana


Fowwow the large red wire from the battery and it will lead you to it. It will be on the lower part of the engine near the flywheel.

Mar 27, 2010 | 2000 Pontiac Montana

1 Answer

Changing the starter solenoid on a 2000 Pontiac Montana


On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

May 12, 2009 | 1999 Pontiac Montana

1 Answer

Pontiac Montana starting problem


All 4 power wires go together on the large center stud on the solenoid.
The purple wire goes on the small stud.
The purple wire supplys the trigger signal when the key is turned to the start position.Since your solenoid is clicking when the key is turned to start this is working properly.
I would check battery connections and then check power connections on solenoid again.Make sure all connections are clean and tight.

Nov 06, 2008 | 2000 Pontiac Montana

Not finding what you are looking for?
2002 Pontiac Montana Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...