Question about 1999 Jeep Cherokee
I had the same car.... what mileage.... 200K?
TPS errors. (its real its a real measured error)
this error is catastrophic, , meaning, not just a tad off,
the FSM covers this in details.
clock spring, the Air bag clock spring? has nothing to do with this.
or do you meant the throttle return spring, (my guess?)
the TPS output pin was discovered to have an illegal high voltage
on the output (you can be sure it idid)
TP Sensor indicated more than 4.50v for 700 ms.
caused by a bad TPS ground wire, or the output pin cut.
or the TPS internals are cracked in half (bad inside) (i have photos)
its bad TPS or bad wires to it. simple huh?
it will not be a bad ECU. as is on the list; it will not.
The jeep has great cheap TPS to buy ofter market,
on other cars not, and can cost $300 , for them
i connect my potable scope and watch the TPS output while i drive.
and find out if it is really truly bad.... hell the part, costs more than my
be happy its not new car with throttle by wire, !!!
or the big V8 , whole new throttle body for $1000
recap. bad TPS, bad wires.
the tps on most cars are calibrated.
if you just thrown on a new TPS and not calibrate it, that is
a big failure.
here are the steps
1 key off
2 remove TPS.
3: put back new.
The TPS is mounted to the throttle body. The throttle shaft end of throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. (If sensor will not rotate, install sensor with throttle shaft on other side of socket tangs). The TPS will be under slight tension when rotated.
adjust the TPS for
0.26 volts at minimum throttle opening (idle)
the FSM says it auto calibates
if the new TPS errors,. set it to 1/4 volt at idle.
reset ECU , all DCTs using scan tool
pull battery for 5min neg. lug (backup radio codes first)
put back lug
start engine, drive 25miles or till CEL comes on (failures)
Posted on Nov 24, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.
Posted on Mar 26, 2009
Changing the heater core requires complete removal of the dash panel and plenum box. To do this you have to remove the steering wheel, steering column, evacuate and recharge the refrigerant system and drain the radiator. I would only consider changing the heater core if it is physically leaking into the passenger compartment. If the problem is heat transfer to the HVAC system only, the problem is more likely with the blend doors. Check heatertreater.net for pictures and diagnostic information.
Posted on Jan 10, 2010
Tips for a great answer:
Feb 03, 2016 | Jeep Cars & Trucks
Oct 09, 2014 | 2000 Jeep Grand Cherokee Laredo
Jul 02, 2014 | 2000 Jeep Cherokee
Jun 18, 2017 | 2000 Jeep Cherokee
Jul 26, 2010 | 2000 Jeep Grand Cherokee
Oct 19, 2009 | 2003 Jeep Grand Cherokee
Sep 25, 2009 | 2004 Jeep Grand Cherokee
Sep 21, 2009 | 1999 Jeep Grand Cherokee
Sep 02, 2009 | 1994 Jeep Grand Cherokee
Feb 04, 2009 | 2007 Jeep Grand Cherokee Overland
141 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: