Question about Cars & Trucks

Open Question

My 1996 S10 2.2 keeps blowing battery side ECM fuse y

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 85 Answers

SOURCE: truck wont start keeps blowing the ecm batt fuse

You have a short (bear wire) somewhere. Trace the wire and find it.
Have a great evening

Posted on May 01, 2009

Ad
ghost4548
  • 776 Answers

SOURCE: 03 hyundai santa fe blows ecm fuses after car is warm up and you

There is obviously a short circuit somewhere. Best solution, take vehicle to nearest Hyundai Service Center, pay diagnostic fee. They will give you an estimate of repairs (parts, labor, tax, time-frame, etc.). This way you'll find out EXACTLY what the problem is and what's required to fix it.

Posted on May 31, 2009

centralvalle
  • 386 Answers

SOURCE: ecm fuse keeps blowing

just fixed this problem, change your fuel pump module, fuel sending unit shorts out on fuel level swing arm blue wire... unfortinately you must replace it as unit because of the design, fuel pump and tank guage fuel level sending unit are a one peice item, fuel tank has to come out to change unit, about a $ 700.00 repair too... fuel pump module runs about 350 to 700 $ depending on aftermarket or factory, try to find one with a lifetime warranty even if it is $ 50.00 more worth it..labor is about $ 250 to $ 400 depending on shop labor rate... definate problem though I ahve no doubt, common problem on GM... please rate my help, thanks...

Posted on Aug 06, 2009

wilsodfarm
  • 986 Answers

SOURCE: blown ecm fuse

unhook the ecm and check if the fuse does not blow,you will know if it is the ecm,Hope this helps

Posted on Sep 06, 2009

  • 64 Answers

SOURCE: the ecm fuse

Hi, this could be caused by a short circuit in the ECM or it more commonly found a short circuit in the alternator. Disconnect the battery wire from the alternator, make sure that the wire does not touch any part of the body or engine. Replace the fuse and see if it still blows the fuse. If the problem is solved, replace the alternator, if nor you will need to test the wires for a short circuit.

Posted on Nov 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 94 Buick centry and the ecm fuse keeps blowing out. New battery and starter. What would cause it to happen


A short in the ECM , does it blow the fuse right away ? or does the vehicle start then it blows the fuse ?A short in the wiring going to the ECM could do it also ! Disconnect the connector at the ECM Pull the fuse an check the wire with a ohm meter ! starter has nothing to do with, has a short to ground somewhere on that ECM power feed circuit .You need to find a wiring diagram for that circuit. Connector 2 black 24 pin connector , A-2 pink wire . first you need to find correct side of the fuse pin without power , with volt meter , one side will battery voltage ,you don't want that one ! put black lead to ground an the other to the wire an see if there is continuity. Hope this isn't to long winded an I hope it helps !

Jan 31, 2015 | 1994 Buick Century

1 Answer

O2 daewoo lanos keeps blowing ecm fuse


The Ecm fuse is located in the passenger side footwell...take off the small cover there and you will its fuse number 5

Jul 29, 2012 | 2002 Daewoo Lanos

1 Answer

ECM I fuse keeps blowing in my 1996 1 ton gmc sierra 4x4 with a 454 v8 engine whats causing it


For the ECM 1 fuse to open you obviously have a short to ground , start with the injector disconnected and see if ECM 1 fuse still blows.If it does disconnect crank sensor, also inspect wires for the injectors or any rub through wires here is a diagram cansmo_178.gif

Sep 09, 2011 | 1999 GMC Sierra 3500

1 Answer

MY 96 SUBURBAN 2500 7.4L SUDDENLY DIED WHILE DRIVING. AFTER I COASTED TO A STOP I TRIED TO RESTARTING BUT NO LUCK. HAVING HAD THE FUEL PUMP REPLACED BEFORE I KNEW TO LISTEN FOR THAT SOUND OF THE PUMP...


The key is to find out what is causing the ECM fuse to always blow. With just the key on try and see if any codes are set in the ECM. If not, try a new ECM. If the fuse still blows, then disconnect all accessible electrical for everything, including radios, accessories, relay boxes,etc. except the ECM. If the fuse still blows, then probably something wrong with the wiring to the ECM. If it doesn't blow then start hooking up things one at a time until it blows again. Once it blows, that is your problem.

Aug 24, 2017 | 1996 Chevrolet Suburban

1 Answer

Gages dont work, 20 amp fuse under hood keeps blowing. turn key motor turns but dont start


Is it the ecm fuse. Check the o2 sensor wires. On this model sometimes they rub on the rear driveshaft and blow fuses.

Jul 25, 2010 | 1996 Jeep Grand Cherokee

1 Answer

Ikeep blowing the ecm fuse as soon as i turn on the ignition and when i hoo up the positve cable to the battery i get a big spark


CHECK FOR IGNITION WIRES SHORT TO GROUND.I HAVE SEEN A BAD FUEL PUMP BLOW ECM FUSE.REMOVE THE FUEL PUMP FUSE DISABLE FUEL PUMP AND SEE IF FUSE KEEP BLOWING.

Sep 01, 2009 | 1994 Chevrolet Cavalier

1 Answer

1996 GMC 1500 Pickup. Keep blowing 20A ECM-B fuse. Replaced Ign Mod,Coil,Cap/Rotor & pickup. Any Ideas Out There? Afraid to go any futher...dont want to ruin these new parts!


if you keep blowing a fuse there's a good chance it's not a faulty part but a short in the main harness most likely under the dash where all the connectors tend to get brittle over time and short out constantly. also check the ecm connection there is a 60 pin type.

May 19, 2009 | GMC Sierra 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...