Question about 2006 GMC Envoy

1 Answer

Car alarm goes off when I use the key to open doors or start engine on my 2006 GMC Envoy. Problem started when I installed new battery.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 170 Answers

Not familiar with the envoy, but most all GMC trucks have a alarm reset button under the dash by the steering column to reset after battery problems. Why did you change the battery? It may also be your starter has shorted out which will set off the alarm. Good Luck

Posted on Nov 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2002 GMC Envoy

If your 2002 gmc envoy or sierra will not even turn over with a kown good battery try starting it in nuetral then go back to park and try starting again. There is a park nuetral safety switch that can malfunction. Turn the key on then shift into nuetral, then turn fully to start.
 

Posted on Dec 17, 2008

  • 362 Answers

SOURCE: Fuse Box Location 2006 GMC Envoy

Under the rear seat, drivers side.
Black box you will need to remove the cover.
Lone99star
Please rate this solution.

Posted on Feb 10, 2009

  • 101 Answers

SOURCE: 2006 GMC Envoy and the A/C fan wont work in number 5 position

replace the resistor 4 the blower motor that should slove that hope this helps

Posted on Mar 05, 2009

  • 6982 Answers

SOURCE: My 2006 GMC Envoy won't start and the battery is good and all the fluids are full, how would I locate the starter to check to see if that was the problem?

ne side starter is mounted against the face of the transmission on oof the engine (usually on the right side) Under the car. There should be 12v at the main lead and 12v at the small (trigger) terminal when the key is turned to the start position. If no power there, check neutral switch and ign switch. You also need to check and verify 12v at the battery and that all connections are clean and secure at both ends of each cable.

Posted on May 20, 2009

  • 15 Answers

SOURCE: rear seat fuse box in 7 seater 2006 GMC envoy denali

Rear fuse box is under the seat bottom, rear seat (middle row) on the driver's side. There is a plastic cover over the top of it that snaps into place.

Posted on Jun 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm keeps going, car locked or unlocked


Hopely this trick is useful.

1. Open the window.
2. Disconnect the battery.
3. Close the door. (Keep the window open)
4. Turn the ignition key on.
5. Find the hood sensor in engine bay area. (It looks like push button)
6. Press the hood sensor and reconnect the battery. (Keep pressing the sensor)
7. Ask someone to start the engine (Keep pressing the sensor)
8. After the engine start, you can release that sensor.
9. Now your alarm vehicle was deactivated.

This trick is effective for common mitsubishi car which not using immobilizer.

Mar 08, 2015 | 2006 Mitsubishi Grandis 2.0

1 Answer

2006 GMC Envoy car alarm goes off when I open doors or start engine. This happened after installing new battery. It had the same problem when I bought it in 2008. I forget how it was solved.


U need to reset security system (pass lock II). Turn key to on right b4 cranking but don't start and let security light flash for about 10-12 mins until it stops and then turn key back off, repeat procedure two more times don't actually turn key far enough to start during first two 10-12 min cycles, third cycle though after flashing stops turn the rest of the way forward for it to start. This should then reset security and solve problem sometimes only takes two cycles to reset. Good luck, hope this is helpful & solves problem.

Nov 23, 2013 | 2002 GMC Envoy

1 Answer

Just installed new ecm on 04 gmc envoy, now engine wont start. everything else works. what should i do?


when ever you replace ECM computer, you must take out your CHIP , to put it into your new ECM. did you do this ?????? if not your engine will not run ,even with GOD turning the key .

Feb 01, 2013 | 2004 GMC Envoy

1 Answer

2006 Toyota Sienna battery replacement causes alarm to go off


if you dont have the keypad to shut the alarm off, or put the key in the door first and unlock the car, then you are going to have to get the alarm disconnected

Nov 24, 2012 | 2006 Toyota Sienna

2 Answers

Lost set of keys, alarm was on car locked. Found spare key only, it will open door, alarm goes off, but the key won't start engine. It will turn in ignition, but dead! It's a Chevy HHR 2006! HELP


Close the doors. Lock the doors using the buttons on the key fob. Use the fob to again unlock the doors. The key should then work the ignition. If this will not work, you will have to tow your vehicle to the dealer and buy a new key and/or fob and have it programmed to the vehicle.

May 13, 2012 | 2006 Chevrolet HHR

1 Answer

2006 GMC Envoy.. Changed the battery, and now the A/C will not blow out the front vents. Works on defrost and on the floor, and in the back. What's the deal?


the deal is that your a/c doors are now out of calibration. disconnect battery for 1 minute, hook battery back up. now turn key on, DO NOT START THE ENGINE, let it set for 2 minutes, now start engine, it should now work.

Aug 03, 2011 | 2004 GMC Envoy

1 Answer

My 2006 GMC Envoy won't start and the battery is good and all the fluids are full, how would I locate the starter to check to see if that was the problem?


ne side starter is mounted against the face of the transmission on oof the engine (usually on the right side) Under the car. There should be 12v at the main lead and 12v at the small (trigger) terminal when the key is turned to the start position. If no power there, check neutral switch and ign switch. You also need to check and verify 12v at the battery and that all connections are clean and secure at both ends of each cable.

May 20, 2009 | 2006 GMC Envoy

1 Answer

Car won't start. Believe kill switch is engaged.


Do you have a chipped key {small black thing in the middle of the key} if not you need to take your registration into the dealer and order a new key.

Apr 03, 2009 | 2006 Dodge Charger

1 Answer

Ignition key 2004 envoy


I had same problem. I would sometimes also leave the door open with lights on inside for 5 mins - then I could not start car, and key would not release.

I had a bad cell in the battery. Replaced the battery and all worked fine.

Mar 22, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
2006 GMC Envoy Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...