Question about 1998 Pontiac Bonneville

1 Answer

I have a 2000 Pontiac Bonneville ssei I was driving home with no trans problems what so ever.put the car in park went in the house got up the next morning started the car put in gear and felt nothing car has no forward or reverse at all no movement what so ever even when reving engine way up

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

Check your transmission fluid level, add fluid if necessary or have the fluid and filter changed.

Posted on Nov 23, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
localwonder
  • 6784 Answers

SOURCE: car won't drive forward or in reverse

this is the speed shift solenoid and a possible faulty transmission filter as well. the best thing for this issue is to pull the tranny and check for filter clogs and change the shift solenoid.

Posted on Mar 10, 2009

  • 28 Answers

SOURCE: car will not shift out of park and yes the brake is being pressed

Shifter assemblies are a common problem with these vehicles (floor shift models). An audible click should be heard in the shifter area when the brake pedal is depressed (if not, you may have an electrical issue in the btsi curcuit, see a qualified repair facility). Hope this helps you, good luck

Posted on Jul 29, 2009

loxmith
  • 21 Answers

SOURCE: 1994 pontiac bonneville.car starts but stops after

This car uses a key with a transponder chip in it. The ignition reads the value of the chip thru 2 small contacts just inside the entrance of the keyhole. These contacts are known to get dirty, wear out, or become totally disconnected from the wire they are hooked to. Use electrical cleaner in the lock cylider and run the key in and out a few times to clean the lock. This is your temporary fix. The next item you may want to try ,is having another chip key made. If this doesn't work, then you will need to replace the ignition cylinder. You can try "Plastichead Keys" for these parts. They can be reached at plasticheadkeys@aol.com.

Posted on Aug 03, 2009

  • 1 Answer

SOURCE: Serpentine belt diagram for a 2001 Pontiac Bonneville SSEI

these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact goldenvegasart@gmail.com

Posted on Aug 03, 2010

tinytimae108
  • 4 Answers

SOURCE: Everytime I put my car i park it goes into reverse.

Ive been having the same problem with my Ford Taurus, its probably the parking gear is broken

Posted on Nov 19, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Pontiac Bonneville I was driving home with no trans problems what so ever.put the car in park went in the house got up the next morning started the car put in gear and felt nothing car has no...


I think you have a shifter cable problem. Engine off. Put the shifter into gear back and forth if under the hood at transmission cable if it moves. There is an adjusting system on the cable could be stripped or not lock.(It pop up then free cable action).

Hope it helps.

Feb 22, 2018 | 2000 Pontiac Bonneville

2 Answers

Looking for the PCM for a 2000 pontiac bonneville. please help. irritated and hot here.


The pcm or power control module is located on the drivers side of the engine.
The pcm relay is # 4 on the power distribution box in the engine compartment.
Also in the power distribution box in location # 6 is a 10amp mini-fuse for the
power train control. good luck!

Aug 04, 2011 | 2000 Pontiac Bonneville

2 Answers

Where is the oil pressure switch on a 2000 pontiac bonneville ssei located?


It is on the oil filter housing, let me verify that in the service manual. I will get back to you if it is not in that location

Jan 19, 2011 | 2000 Pontiac Bonneville

1 Answer

I need a new PCM computer. I have a 2001 Pontiac Bonneville SSEi. Can you tell me where the PCM is located?


Powertrain control module is inside air cleaner housing in left side of engine compartment, )

Nov 23, 2010 | 2001 Pontiac Bonneville

1 Answer

My 2000 Bonnie SSEI 3.8 Code is p1133 manufacture air/fuel metering came up twice. When fisrt starting out to drive away the car spitter & sputter or even dies. Once its warms up in a couple of minites...


sounds like a map sensor or the fuel (air/lean rich)
sensor you will need to speak with a mechanic and have them put their machine on ,it gives more info than the basic code reader

Jun 09, 2010 | 2000 Pontiac Bonneville

1 Answer

Looking for used transmission for my 1995 Pontiac Bonneville SSEI


with the amount of time it takes to change the trans are you sure that is a good idea??? but then installing a rebuilt yourself without a qualified mechanic voids the warrantee, not much of a choice is it?? just wanted you to get the facts

May 11, 2010 | 1995 Pontiac Bonneville

1 Answer

98 pontiac bonneville ssei misfiring at 30-45 mph. or when i try to get it to perform.


just fixed a car with a similar problem. check your crankshaft positioning sensor, then replace the plate that the coils sit on, it has went bad. the coils should be fine but that plate tells it when to fire.

Aug 10, 2009 | 1998 Pontiac Bonneville

1 Answer

O2 SENSORS


#1 Under vehicle, center, below seating area, next to catalytic converter, mounted on exhaust pipe.

#2 Under hood, center, rear engine area, above exhaust pipe flange, mounted in exhaust manifold.

Easy to access.

Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 02, 2009 | 2000 Pontiac Bonneville

2 Answers

Pontiac Bonneville(2000) oil pressure sending unit


The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.

Jan 24, 2009 | 2000 Pontiac Bonneville

Not finding what you are looking for?
1998 Pontiac Bonneville Logo

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...