Question about Nissan Cars & Trucks

2 Answers

Location Thermostat location of the thermostat on 1993 nissan Quest

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 818 Answers

Follow the top radiator hose toward the motor-it is clamped onto the thermostat housing- unbolt it and thermostat should be inside it- cheers Denny

Posted on Nov 23, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 176 Answers

You have thermostat for a/c and engine coolant, which one.

Posted on Nov 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pkthoege
  • 93 Answers

SOURCE: location of thermostat

dead center rear of engine behind water out let (elbow pipe) two screws

Posted on Nov 22, 2008

  • 1861 Answers

SOURCE: thermostat location

The thermostat is located directly under the distributor cap, on the end of the cylinder head. Easy to remove/replace. Drain the coolant, remove the 2 nuts that holds the housing on, and remove it. The thermostat stays in the cyl head, just pull it out. Note that the "Wiggle-Valve" must be placed at the 12 oclock/straight up position. Hope this helps, in lieu of a picture.
Thanks for choosing FixYa!

Posted on Nov 25, 2008

  • 4 Answers

SOURCE: thermostat replacement

If you look at your radiator, there a big hose that comes out of the radiator on the left side. Follow it to engine and it will lead you to the thermostat. Hope this helps....

Posted on Jan 24, 2009

c17hydro
  • 2984 Answers

SOURCE: where is the location of the thermostat on a 2001 Nissan Frontier

on the nissian frontiers the thermostat is most likily in the lower radiator hose if you look from under the vehicle you will likily see a round housing with three bolts or nuts just follow the hose up from the rad

Please don't forget to rate!

Posted on Mar 20, 2009

michigan man
  • 3533 Answers

SOURCE: need to find location od thermostat on 93 camry

try these websites www.autozone.com and www.alldatadiy.com and you should be able to get the information you need.

Posted on Jun 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the thermostat location on my infinity j30 1993


Chris, 1993 infiniti J30 thermostat location. Follow large radiator hose to intake manifold by water pump, at the end of the rad hose is the thermostat housing. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to Replace the Thermostat in an Infiniti J30 eHow
Thermostat Replacement Write Up
Infiniti Thermostat Replacement

Aug 28, 2016 | Cars & Trucks

1 Answer

Thermostat housing help


Try this. It's a later model but shows you how to locate, remove and replace. http://autorepair.about.com/library/faqs/bl721g.htm

Good luck

Apr 12, 2014 | 1993 Nissan Quest

1 Answer

Thermostat location


You'll probably need a repair book. It should be behind a housing on the side of the block behind the belts.

Jul 19, 2013 | 1999 Nissan Quest

1 Answer

Where is the thermostat located in a 01 nissan quest


the thermostat is usually in the housing where the top radiator hose connects onto the motor.....cheers.

Sep 03, 2011 | 2001 Nissan Quest

1 Answer

How to replace a thermostat on a 1999 Nissan Quest?


1999 Nissan/Datsun Truck Quest Mini Van 3.3L SFI 6cyl

The thermostat is located in the thermostat housing, which is mounted to the coolant crossover tube. The bypass hose is connected to the thermostat water inlet on one end, and to the intake manifold water outlet on the other. The thermostat is not located in the intake manifold water outlet, where the upper radiator hose is connected.

8bcd510.jpg

Fig. Thermostat water inlet sealant application


Hope helps.

Sep 13, 2010 | Nissan Quest Cars & Trucks

1 Answer

Thermostat


It should be located where the lower radiator hose connects to the engine, and there you should find the thermostat housing. Be sure when installing the new thermostat that the spring side of the thermostat is installed towards the engine.

After you change the thermostat you might have to remove the upper radiator hose from the radiator to pour coolant back into the block, or the engine might not have any coolant getting into it until after the thermostat has opened up, and by then it would be too late and the engine will over-heat. Also, be sure to bleed the trapped air from the cooling system by using any bleeders in the cooling system.


1785030.jpg

Jun 20, 2010 | 2000 Nissan Sentra

1 Answer

My van is over heating and i think my thermostat is bad.i need a location for were it is on the engine


The thermostat is located in the thermostat housing, which is mounted to the coolant crossover tube. The bypass hose is connected to the thermostat water inlet on one end, and to the intake manifold water outlet on the other. The thermostat is not located in the intake manifold water outlet, where the upper radiator hose is connected.

202a57a.gif
  1. Drain the radiator and recycle the engine coolant.
  2. Remove the upper radiator hose bracket bolt and remove the bracket.
  3. On 1993-98 3.0L engine models:
    1. Remove the bolt from the A/C high pressure line bracket at the front of the engine.
    2. Remove the two A/C accumulator/drier bracket bolts.
    3. Position the accumulator/drier and A/C line out of the way.

  4. Remove the bypass hose clamp and remove the hose from the water inlet.
  5. Remove the four water inlet bolts and remove the inlet.
  6. Remove the thermostat from the inlet.

To install:
  1. Clean and dry the water inlet and thermostat housing mating surfaces.
  2. Apply a continuous bead of RTV silicone sealant 0.08-0.12 inch (2.0-3.0mm) wide to the water inlet mating surface.



NOTE The water inlet must be installed within 5 minutes of applying the sealant.

  1. Install the thermostat in the water inlet, with the jiggle valve at the topmost (12 o'clock) position.
  2. Install the water inlet to the thermostat housing. Install the bolts and tighten them to 12-15 ft. lbs. (16-21 Nm).
  3. Install the bypass hose to the water inlet, using a new clamp.
  4. On 1993-98 3.0L engine models:
    1. Install the accumulator/drier and tighten the bracket bolts to 45 inch lbs. (5 Nm).
    2. Install the A/C high pressure line bracket and tighten the bolt to 45 inch lbs. (5 Nm).
    3. Install the upper radiator hose bracket and tighten the bolt to 34-48 ft. lbs. (46-65 Nm).




NOTE Allow the sealant to dry for at least 30 minutes before adding coolant.

  1. Fill the cooling system. Run the engine and check for leaks.

Sep 10, 2009 | 1999 Nissan Quest

1 Answer

Thermostat location


The thermostat is located directly under the distributor cap, on the end of the cylinder head. Easy to remove/replace. Drain the coolant, remove the 2 nuts that holds the housing on, and remove it. The thermostat stays in the cyl head, just pull it out. Note that the "Wiggle-Valve" must be placed at the 12 oclock/straight up position. Hope this helps, in lieu of a picture.
Thanks for choosing FixYa!

Nov 25, 2008 | 1993 Toyota Corolla

2 Answers

1993 nissan quest


the thermostat will be directly connected in the radiator hoses, If you follow the output of the radiator to the engine, there should be a spot where the hose connects to a metal piece that houses the radiator (this should be connected directly onto the engine.) This piece will have a bolt on both sides of it and to remove it you will just need to take off the bolts. You should take off the hose first to make sure the thermostat is in this piece and you didn't find some other device. When you take off any hose, it will probably start draining the fluid, so have a bucket or something to catch it. The thermostat just sits inside this device but take not of how the old one is sitting because you don't want to put it in backwards. You may also have to replace the gasket if you wreck it when you take this device off. Overall, it is pretty simple. If you already bought a thermostat, you are just looking for a metal piece that is a little bigger with two bolts on the sides holding it on. Please let me know if you have any trouble or have another question, thanks.

May 16, 2008 | 1996 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...