Question about 2006 Toyota Tundra

Open Question

2006 tundra makes a clicking noise when put into gear

Makes clicking noise when put into gear, after engine gets warm noise stops

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: 2001 toyota tundra stalls when put in gear

If the engine stalls abruptly on your Cirrus, as if some one clamped it, then I would suspect that the 'lock-up' function on the torque converter of the transmission is in the lock-up position. That means it is the same as popping the clutch on a conventional transmission car, which cause the same stall. If you can't drive the car, I would call around to several independent transmission shops to find one that is familiar with the Chrysler 41TE transmission and that appears to be honest. Ask if they have a diagnostic readout box to communicate with the transmission control computer. If they do then have the car towed there and let them try a readout. If they get a code 38 or 0740 (depending upon what year model you have there) then that would show that the lock-up is the problem. If you are lucky the problem will be with a solenoid switch or valve in the box on the side of the transmission which can be corrected easily without removing the transmission. Because this possibility (along with about 6 other causes) is worth pursuing, I would want a shop that is not going to talk you into a "rebuild" without first looking into all the possible reasons for the lock-up condition so you aren't "taken for a ride".
So ask friends if they know a good honest shop and check them out as to how well they understand the Chrysler transmission. You may end up at a Chrysler dealer, but insist on their trying all the other possible causes before authorizing removal of the transmission which is a very expensive repair and may not be necessary.

Posted on Jun 29, 2008

Ad
bschilz
  • 2049 Answers

SOURCE: 2002 tundra oil pressure fluctuates

Assuming you have made sure your oil level is full, I would replace the oil pressure sending unit. The sending unit is located right next to the oil filter on the lower left side of the engine. If I recall it's right on the filter attachment housing. You'll see the sending wire attached to it.

That is the fastest, cheapest and most likely solution.

Posted on Sep 01, 2009

  • 6468 Answers

SOURCE: Key on engine off. I hear a humming/buzzing noise coming from underneath the 2006 toyota tundra I climbed underneath; the noise is localized to the transmission pan, and w I put my hand directly unde

there are actuators in the transmission that control pressure and shifting

Posted on Aug 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 Elantra engine starts making diesel like noise as the car gets to 10mph when slowing and stops just as the car stops.


jack it up and put it on jack stands then start it up and put it in gear that way you can listen to where the noise is coming from, i think that it is probably the cv axles

Dec 14, 2016 | Cars & Trucks

1 Answer

Engine clicking


Most likely lifters rattling. Under torque? How are you with your past maintenance?

Nov 23, 2013 | 2006 Toyota Tundra

1 Answer

Transmission making a noise?


From the manual:
The automatic transmission dipstick has a yellow handle.
Before checking the fluid level:

* The car must be parked on level ground
* The engine must be idling
* The gear selector must be in Neutral or Park
* The parking brake must be set

Oct 21, 2012 | 2007 Volvo S80 3.2

1 Answer

My air conditioner in my 2006 ford freestyle is blowing warm air. If I speed up it will cool a little and then when i turn off my car there is a clicking noise coming from the dash


I had the same problem with my ford, it turned out to be a door in the dash that switched between heat and a/c, the clicking noise is the gears flaping the door but not being able to open, if your heat works fine but not a/c this is the problem. BTW this part is very hard to get to without removing your dash.

Jun 26, 2012 | 2006 Ford Freestyle

2 Answers

Humming sound at 40 mph when i let off the accelerator 2006 toyota tundra then goes away after a few seconds


Could be a Wheel Hub Brg Assy, on front

If you remove the caliper & rotor .You may
feel the bad bearing by hand

No other test than what your hearing around 35 to
40mph.

Jun 26, 2012 | 2006 Toyota Tundra

1 Answer

Grinding noise


I am going to guess a bad vacuum line some where in the 4x4 hub system.

Operationally vacuum holds the IWE ( Integrated Wheel Ends ) out, and once vac is removed the spring engages the IWE.

I get the bad vacuum line ( or vacuum box ) from the fact that the problem happens after vacuum has been applied to the IWE to pull the spring out. I would also guess this does not happen when in 4H or 4L.

Here is a vacuum block diagram of the IWE vacuum system
e000ccf.jpg

It could also be the IWE vacuum solenoid, there is a TSB on this ( right click save as ).
http://my.voyager.net/~sscully/file_tsb06_08_15.pdf

Jul 20, 2010 | 2006 Ford F-150

1 Answer

2006 Pontiac Wave jumps out of gear.


it might be the start up gear or the transmission or engine might need to check the oil. i think that the transmission needs replacing.

Apr 29, 2010 | 2006 Pontiac G6

1 Answer

When cold out the engine makes noise and when you put it in gear it gets louder until it warms up.


everything is a fraction smaller in cold weather,as the car warms up everything will return to its normal place, just let the car warm up for a couple of min without reving the engine

Jul 04, 2009 | 2003 Kia Sedona

1 Answer

When engine is started, heater door makes clicking noise for 20 seconds and quits. When engine is shut off, heater door makes clicking noise for 20 seconds and quits. Door makes clicking noise when heat is...


Your air temp control blend door actuator is failing, that is the part u call a heater door, it is a gear driven miniature drive, the gears are jumping teeth making the noise, it will stop working very soon.

Apr 24, 2009 | 1998 GMC Blazer

Not finding what you are looking for?
2006 Toyota Tundra Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...