Question about Mercedes-Benz E-Class

1 Answer

Injector pump leak

Hi i have a merc cdi 220 cdi ,if i dont use car for a day or so then when i do start car it swings for more than 30 seconds then eventually starts and wen i look under the car it leaks diezel from somewhere in engine but im not sure y .the car runs perfectly well accepts for delayed start and diesel leak please advise

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Mercedes-Benz Expert
  • 102 Answers

This will almost certainly be the plastic fuel pipes connected to the fuel pump replace both of them this is a common fault the rubber o rings on the pipes harden and leak make sure you prime the diesel filter after replacing these pipes the engine can be difficult to start on this model once air is allowed in the system

Posted on Dec 07, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: car started making noise and the wheel became hard to turn

Is the belt on the power steering pump tight or loose does the pump makes a huming noise when turning steering all these are causes of hard to turn steering belt need to be (tight) on pump and pump must not be huming when turning steering add fluid if needed and play with steering to see if help if not need to replace pump

Posted on Nov 12, 2008

  • 67 Answers

SOURCE: poor starting problem bmw 318 ti

WARNING! Always wear protective eyewear, gloves and necessary clothing before inspection or work begins. Never crank an engine over when you are near the battery or engine. A battery is filled with explosive gasses that can ignite when extreme heat or a spark is present. A battery could have residual acid on the outside casing so use caution when handling a battery and the surrounding area. Use baking soda to neutralize any suspected acid residue before work begins.

You can check the car battery using a multimeter or voltmeter an electronic one is preferred , connect the black wire to the negative side (-) and the red to positive , WARNING :DO NOT CROSS THE RED AND BLACK WIRES OR SHORT CIRCUIT THE LEADS OF THE BATTERY OR MULTIMETER YOU CAN GET SERIOUSLY HURT!!!!! you should also get a spare watering can and fill it with water ,  (dont reuse for other purposes for safety) and remove those little tabs (usually around 4 or more) and fill it up very little in each tab/cap make sure you DONT fill it to the top. The good condition of a battery is 12.5 and 12.8 volts on the multmeter and when the car is started it
(not driven just started) should around 14V which shows that your alternater (acts as battery charger when driving) is working properly.

Posted on Nov 14, 2008

  • 46 Answers

SOURCE: power steering leak

Depends on the part to be replaced. The pump is pretty straightforward with the correct tools and costs about $60 to $100 if you do it yourself (I own an Intrepid, similar to the LHS and I work on it a lot) . If it's a metal hose, this is going to be about $30 to $50 or more and will need a flare nut wrench, along with other hand tools. If this is attached to the steering rack, you may have to move other parts out of the way. This is not a hard job either, but could be time consuming and be careful not to cross thread the fittings.

Posted on Jan 03, 2009

  • 180 Answers

SOURCE: Leaking Transmission Fluid

Dead center could be trans. line or front pump seal.

Posted on Jan 09, 2009

  • 1 Answer

SOURCE: no kick down on merc

please check whether you put "W"(Winter mode) instead of "S" .....

Posted on Apr 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Merc Vito van cuts off after 5 minutes from starting it in the morning and will start after 10 seconds and will not cut off again unless I am on the motorway.


If it's not broke, don't fix it. I know of some companies that it's set in the computer to shut off if hasn't been moved in 5 minutes or so. But if it doesn't cause you any personal/physical discomfort, let it be.

Sep 25, 2014 | Cars & Trucks

1 Answer

Hi I have a Merc E class 270 cdi and the trunk(boot) opens automatically when I turn of the ignition. any got any idea if there is an option or fault? Thank in advance Lado


look to see if the trunk activation button is stuck down..if you dont use it.. disconnect it if need be..if it becomes an issue or pull the fuse for it..

Dec 08, 2013 | Mercedes-Benz Cars & Trucks

1 Answer

Remove engine cover on 2006 mercedes c220 cdi coupe


how to change starter motor merc 220 cdi avntgarde step by step

Jul 27, 2012 | 2006 Mercedes-Benz C-Class

1 Answer

Car fumes merc e class cdi replaced fuel injectors engine has been cleaned down fumes still there effects the mouth throat constant headache driving me mad


Get the exhaust checked, if it is leaking the exhaust gas'es will be coming in the car. most garages can check an exhaust for you.

Hope this helps

regards
dan

Jan 25, 2010 | 2005 Mercedes-Benz E-Class

2 Answers

Can u set the injector timing on a sprinter van using a dial gauge in the no 1 injector at the rear of the pump and if so what are the settings please


hi, yes you can,cant remember exact figure think its 0.9mm, use the bolt above where the spline enters the block to adust the timing by ear-give merc a ring for the exact dial gauge setting as it is different for each engine.

Nov 08, 2009 | 1993 Mercedes-Benz Mercedes Benz 300 Class

2 Answers

The mercedes ml320 start but goes off after a second


hello,good day,your pump is working,good ,your injector nozzle receive or getting a signal from your engine module,maybe your crankshaft sensor need tobe check,poor contact or sensor is defective,ty

May 23, 2009 | 2007 Mercedes-Benz ML320 CDI

2 Answers

No kick down on merc


please check whether you put "W"(Winter mode) instead of "S" .....

Apr 01, 2009 | 2007 Mercedes-Benz C-Class

2 Answers

Merc E270cdi - starting problems after the 3rd stop evrytime. Starts up again after leaving it for 30mins and restarting.


2001 merce270cdi draining in air in fuel system.replaced diesel filter and seals on fuel pump all main dealer parts

Nov 02, 2008 | 2002 Mercedes-Benz E-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...