Question about 2008 Dodge Avenger

1 Answer

2008 Dodge Avenger. The check engine light was on. Had it reset at Autozone. They said it was the Power Control Module Code. I drove the vehicle for a while. One day acted like a dead battery. When I

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert that hasĀ over 10 points.

  • Contributor
  • 11 Answers

Well it seams that Power disconnected, I mean do you have any security device kind of remote security device , it have power shut down from there for security reasons... so check it from there ...
best of luck if you have any further problem feel free to mail me

Posted on Nov 22, 2013


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 561 Answers

SOURCE: New battery but still acts dead - Does computer need to be reset?

do not suspect computer.
1 the new battery may not have been charged from the store so would need to be charged before use, charge new battery on a charging set and see if this resoves the problem. *or use slave leads and start from a second vehicle)
2 your alternator may not be charging the battery so after a while it will just die. use a volt meter and check that volage is increaseing to your battery when the engine is running.
if not suspect alterantor defective and may need replacement.

Posted on Nov 13, 2009

  • 1 Answer

SOURCE: 1998 Dodge Avenger Battery drained.

I'm not sure where you got your alternator tested, but recently I was in the same situation with my 1998 avenger and the alternator was at fault

Posted on Jan 11, 2011

  • 4803 Answers

SOURCE: 2003 grand caravan 3.3l engine,155k

Sounds like a dead battery and possibly a malfunctioning charging system to me. Trust me, I have seen weirder tings happen as the result of a shorted cell in a battery. It needs to be tested with a battery tester that can test the impedance of the battery cells. Please note that an old-fashioned battery "carbon pile" load tester cannot do this.

I have even seen engines that would crank normally and not start because the shorted cell was giving reverse polarity feedback to the computer system during cranking. Just because your lights are coming on, does not mean that your battery is in good condition or that it is fully charged.

I have also seen many Engine Control Modules and Body Control Modules replaced by mechanics that failed to properly test the charging system before making such a judgement. Module failures do happen, but they are RARE.

Please also review the following articles:

My Car Won't Turn Over

What Else Could Be Wrong?

Posted on Aug 19, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Turn signal fuse dodge avenger

Not a fuse TIPM - an electronic module , totally integrated power module . Defective TIPM Is Causing Dangerous Power Problems in Chrysler Vehicles

Oct 08, 2016 | 2008 Dodge Avenger

1 Answer

I need to find the exact location of the starter motor relay for a 2008 dodge avenger

Starter Activation Is Controlled By Totally Integrated Power Module--Left Side Of Engine Compartment.
Can Be Checked With Scanner (buss lines) Has Solinoid On Starter

Feb 18, 2015 | 2008 Dodge Avenger

1 Answer

Turn off check engine while abs control module is not connected

have vehicle checked for trouble codes any autozone or parts store most will check it for free .You should than have an idea what is still wrong. If you feel this was helpfull please leave good feed Back

Dec 23, 2014 | 2008 Hyundai Tucson

1 Answer

Where is the cluster lights fuse in a 2008 dodge avenger?

In Totally Integrated Power Module (left side of engine compartment) Fuse 14--10 amp

Oct 20, 2014 | 2008 Dodge Avenger

1 Answer

P0700 and 0760 code for dodge avenger 2008

Hi Leetroy, I'm glad to help! The P0760 code you have is: Transmission Solenoid Pressure Switch Assembly. The problem could be in the wiring, it also could be the solenoid assembly itself or it could be the engine control module (PCM). It will need to be checked out to verify which part is bad. Hope this helps and have an awesome day Leetroy.

Apr 09, 2014 | 2008 Dodge Avenger

1 Answer

I have 2008 dodge avenger engie light is on with code reading p2004 how can i fix it

Here is the definition for the code. You'll need a shop manual to troubleshoot and fix the problem.

P2004 CHRYSLER Description The Powertrain Control Module (PCM) detects that the position feedback of the manifold flow valve position sensor is not within range of adapted value learned during inplant initialization or after volatile memory reset.
Read more:

Jan 27, 2013 | 2008 Dodge Avenger

3 Answers

I have a 2008 dodge avenger, after I finished making oil change the engine light went on. What would it be the probvlem?

The oil change light is usually mileage related, and just needs to be reset. It does not know if oil was actually changed or not. Check your owners manual, or stop by a quick lube place for directions on how to reset it. This is not a problem.

Dec 12, 2010 | 2008 Dodge Avenger

1 Answer

2008 Dodge Avenger check engine light appeared after car had been towed by the rear end (front wheels on ground) front wheel drive vehicle. Why? Also, how was car able to be towed without being in neutral?

A dignosic tool needed to check for the fault. Autozone if you have one will be able to chk it for you or some parts store in your area may able to do that

Aug 17, 2009 | 2008 Dodge Avenger

1 Answer

Idoling too fast

Zip into autozone for a free scan & the trouble code should tell you what part to buy while your there. Is that vehicle out of warranty?

Mar 29, 2009 | 2008 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides