Question about 1996 Nissan Maxima

1 Answer

My 2001 nissan maxima wont start when its been sitting for more then 4 houres

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Nissan Master
  • 1,116 Answers

You have electric power drain,either it is you battery very old and one of the shells inside the battery is short. Check also your boot light might stays on even you closing it down.

Posted on Nov 22, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 nissan maxima

I have the same issue with my 2004 maxima.The service techs said it was the timing chain tensioners .Since they are hydaulic and they powered by the oil in the car .It is recommended to purge the the engine every time the noise starts to come back. I brought some an it really freaking work because I started to run it into a tree and go buy a toyota

Posted on Aug 16, 2008

johnny5846
  • 379 Answers

SOURCE: location of a o2 sensor 2001 nissan maxima

bank 1 refers to the side of the engine that #1 cylinder is on , and sensor 2 refers to downstream , after the catalytic converter. , this link shows bank 1 on a 2001 nissan maxima V6 being on the firewall side . if you had a 4 cylinder it would be downstream after the catalytic converter .

http://www.autozone.com/N,26200242/shopping/specsSelect.htm



Posted on Jan 04, 2009

  • 416 Answers

SOURCE: 2001 nissan maxima gle crank no start code p1320...please help

Primary ignition fault. Reasons: Bad distributor cap (most likely) or ignition control module/ignition coil.
Hope that helps
Good Luck

Posted on Mar 18, 2009

  • 135 Answers

SOURCE: 2001 nissan maxima air condition fan not working

If the ac fan is not coming on the ac is inop. the compressor is bypassed. Check fuses and relays first.

Posted on Aug 04, 2009

  • 5 Answers

SOURCE: Air conditioner noise in 2001 nissan maxima

this maybe the motor on the fan or the bearings in the fan wearing out or the bearings in the a/c clutch

Posted on Sep 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It turn over but wont start


Do you have a check engine on? If so take it to auto zone they can read your code for free and tell you what's wrong.

Oct 03, 2016 | 2004 Nissan Maxima

1 Answer

My son has a 93 nissan maxima it starts an runs about 5 minutes then stalls . it will do this 4 or 5 times then you have to let it sit about an hour before it will restart it has a new fuel pump a month a...


Check Fuel Pressure anyway

Have a gauge on it when the motor runs or when your on the street
Tie the gauge to a wiper so you can see it

Have to find out what your loosing when it shuts off

Fuel
Spark

Aug 13, 2014 | 1993 Nissan Maxima

1 Answer

I replaced the battery to a '95 nissan maxima and also disconnect the alarm but it wont start a few hours after disconnecting the alarm


Hi, My advice would be to look for a wire going to the distributor then remove the wire that is part of old alarm system, you should only have one wire going to the distributor. Plugs should not be problem as it started at the dealers. Please leave me feed back Malcolm Campbell, crossflowspeed@hotmail.co.uk Thanks.

Oct 10, 2017 | 1995 Nissan Maxima

1 Answer

2001 nissan maxima se keeps blowing the ecm 1 fuse


Did you find the prolbem? Im having the exact same problem you have. Mine is doing it after it died and I replaced the starter but now it wont start and the fuse eng cont 1 keeps getting burned out instantly

Jun 25, 2010 | 2001 Nissan Maxima

2 Answers

Location of a o2 sensor 2001 nissan maxima


bank 1 refers to the side of the engine that #1 cylinder is on , and sensor 2 refers to downstream , after the catalytic converter. , this link shows bank 1 on a 2001 nissan maxima V6 being on the firewall side . if you had a 4 cylinder it would be downstream after the catalytic converter .

http://www.autozone.com/N,26200242/shopping/specsSelect.htm



Jan 04, 2009 | 2001 Nissan Maxima

1 Answer

2004 nissan maxima


check the ignition module and crank sensor

May 27, 2008 | 2004 Nissan Maxima

Not finding what you are looking for?
1996 Nissan Maxima Logo

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...