Question about 2006 Peugeot 206 1.4

Open Question

Peugot 206 diesel how do i change the complete fuel filter housing

Have to use manual prime pump every time to get fuel through to start car

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 55 Answers

SOURCE: car wont start on 206

you must fill the fuel filter housing with diesel to eliminate air pocket. if you don't have diesel, fill it with automatic transmission fluid. it will smoke for a few seconds, but it will run so fuel pump can catch up. don't touch throttle for a few seconds till you know that it is running on diesel and the tranny fluid is all used up.

Posted on May 24, 2009

Ad
venexcsd
  • 1185 Answers

SOURCE: dissconnected fuel pump on peugot 206 gti

Is there voltage at the terminals ?

Could you have crosswired the connections

Does the pump body vibrate when the ignition is switched on

Go to the engine end of the pipework and undo the fuel line where it comes onto the injection system get someone to hold a cloth over the end of the pipe and switch the ignition on, does fuel flow , if not you may have an airlock in the lines and will need to bleed it out by either undoing the connections one at a time starting at the one from the fuel tank to the pump

Crude way is to **** on the end of the pipe but expect a mouthful of petrol if it kicks in.

Nearly forgot is it a diesel, if so there is a prime button on the fuel lines in the engine bay which can be used to draw fuel through

Posted on Jun 17, 2009

  • 205 Answers

SOURCE: Fuel filter

There is no need to change it frequently. If there is a loss of engine power or if throttle cuts out then may be its the time to change fuel filter. It is recommended by peugeot to change fuel filter (but depends on fuel purity) after every 36000 miles.

You can clean it yourself
Dipp the whole filter body in carosine oil tank and leave it in there for about 20-30 minutes
Pour some petrol in filter with the help of plastic piped and apply a slight air pressure (use a piece of pipe to blow) in the reverse direction (marked with arrows) of fuel supply to clear residue and heavy oil composite that clogged in filter.
Repeating the cleaning process 2-3 times will clean the filter to reuse it without the need of a new one to buy.

Posted on Jan 09, 2010

  • 9 Answers

SOURCE: Peugeot 206 diesel starting problem! help!!!

check heater relay,ecu,glow plugs,maybe air going back into the tank,goodluck

Posted on Mar 19, 2010

alicantecoli
  • 22219 Answers

SOURCE: need an english manual for

have one but i cannot upload a PDF document ,have a look on a few torrent sites like the pirate bay and see what you can find,

Posted on Mar 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just had my car filters changed now it won'tstart


If fuel filter has been changed suspect lack of fuel to engine, Diesels sometimes have a manual priming pump to over come this problem, the cars diesel pump will not easily self prime., although some GM engines are designed like this. Always fill fuel filter bowl with clean diesel when re assembling. A after market manual pump with non-return valve is often fitted as an addition to overcome this difficulty.

Jan 30, 2015 | Cars & Trucks

1 Answer

Bmw diesel wont start


I'm guessing that you got an air lock in your fuel system as a result of your changing the fuel filter... I certainly don't know about a BMW diesel, but in most semi-truck engines, there is a priming pump just for the purpose of getting the air out ... and the fuel into.... the fuel system. I've even been known to fill the filters with diesel fuel before screwing them onto the base.. This is risky because of the possibility of allowing some foreign, unfiltered debris to get into your pump and/or injectors, just because of your putting unfiltered fuel into your filter... Check and see if there is some kind of priming pump close to the filter. Also, a possibility is that you may have an electric fuel pump.... as to where all you may need to do is loosen a fuel fitting on the pressure side of the pump and filter.... and allow the electric pump to purge the system of air.. I confess to my lack of knowledge on your BMW.... but, I do have some basic understanding of most diesel systems... Good luck..

Jun 24, 2014 | 2004 BMW 320d

1 Answer

Ran out of diesel, added diesel but now it wont start 2007 Chev 2500


Hello and welcome. you will have to perform the bleed procedure using the fuel prime on the fuel filter housing. there is a pump on top of the fuel filter assembly, on the passenger side of engine.

Open the vent valve screw (1) by turning the screw counterclockwise several full turns.




Operate the priming pump (1) by repeatedly pumping until a small amount of fuel seeps from the vent valve. Allow the pump to fully return upward between pumps. When fuel is present, the filter is full of fuel and the system is primed.
Close the vent valve screw.

6a966a0.gif
9c0dad5.gif

Jul 01, 2010 | 2007 Chevrolet Silverado 2500HD

3 Answers

2003 Duramax Diesel loosing prime and will not start until I lift the hood and pump the prime plunger on the fuel filter housing.


duramax diesel trucks do not have a lift pump. start with the simple things make sure your fuel filter is tight and check the shreader vlave on the fuel rail if that don't help check the filter housing for a leaks arround the heater element or a crack in the housing itself

Apr 25, 2010 | 2003 Chevrolet Silverado 2500HD

2 Answers

Chevrolet 2004 Silverado 2500HD 6.6 wont start


try priming the fuel filter, ther is a pump and bleed scew above the filter, pump a few times hold the pump down open screw and se what comes out air or diesel? keep doing this until its diesel

Mar 04, 2010 | 2004 Chevrolet Silverado 2500HD

2 Answers

Ford F250 turbo diesel cut out and died as left house this morning, cold morning. Will not start, not even a cough. Have new fuel filters, need location of the filters, anything else I should check?


if you have the 6.0 then the filters are located on top on the motor right beside your oil filter and under the drivers side on the fuel pump, check to see if you have diesel in your bowl where the fuel filter is, no diesel in there your fuel pump might be dead, check fuses to fuel pump and check relay on the passengers side kicker panel, check your owners manual

Nov 25, 2009 | 2005 Ford F 350 Super Duty

1 Answer

Dissconnected fuel pump on peugot 206 gti reconnected now it wont start


Is there voltage at the terminals ?

Could you have crosswired the connections

Does the pump body vibrate when the ignition is switched on

Go to the engine end of the pipework and undo the fuel line where it comes onto the injection system get someone to hold a cloth over the end of the pipe and switch the ignition on, does fuel flow , if not you may have an airlock in the lines and will need to bleed it out by either undoing the connections one at a time starting at the one from the fuel tank to the pump

Crude way is to **** on the end of the pipe but expect a mouthful of petrol if it kicks in.

Nearly forgot is it a diesel, if so there is a prime button on the fuel lines in the engine bay which can be used to draw fuel through

Jun 17, 2009 | Peugeot 405 Cars & Trucks

3 Answers

Car wont start on 206


you must fill the fuel filter housing with diesel to eliminate air pocket. if you don't have diesel, fill it with automatic transmission fluid. it will smoke for a few seconds, but it will run so fuel pump can catch up. don't touch throttle for a few seconds till you know that it is running on diesel and the tranny fluid is all used up.

May 24, 2009 | 1991 Peugeot 405

2 Answers

My 206 1.9 diesel wont start


a diesel engine can only cutout when overheating, loss of diesel fuel and air leak in the fuel system. if you know how to bleed or ask somebody to bleed right after it stall, then start the car, if it starts immediately then it is sucking air.

May 09, 2009 | 2006 Peugeot 505

1 Answer

Truck ran completely out of fuel.


is there a primer valve on the pump? it would unscrew and then pull out if it had one. take a look around the injection pump. but i belive that uses an electric lift pump it should not need to be primed there may be something else going on here.

Mar 15, 2009 | 2006 Dodge Ram 3500 Truck

Not finding what you are looking for?
2006 Peugeot 206 1.4 Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...