Question about 2010 BMW 318ti Compact

1 Answer

Starting coil pack

The car don't want to start

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • BMW Master
  • 46,580 Answers

Run fault codes to determine the faulty sensors.

Posted on Nov 22, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Coil pack not working

It could be your crank angle sensor

Jul 13, 2013 | Audi 100 Cars & Trucks

1 Answer

Can a bad coil pack stop a car from starting

Absolutely! Just had to put a coil pack on my Sis-in-law's car(2007 Taurus),and THEN it went bad and had to do it again. don-ohio

Jan 16, 2012 | 2001 Ford Taurus

1 Answer

2002 windstar 178,000mi starts rough stalls when engaged just Replaced SPARK PLUG #1 3 days ago

why did you only replace the don`t could be a fuel problem,some of these had problems with the coil packs and or the wiring to the coil packs not working as intended.check these out.

Aug 05, 2011 | 1999 Ford Windstar

1 Answer

Engine runs rough seems like it stutters but still has a good amount of horse power

A tune up may help, plugs, wires, fuel filter, air filter, if this don't take care of the problem could have a bad coil pack, you can check the coil pack, get some vacuum hose and cut 6 pieces about 3 inches long, put a piece of hose in the plug wire and the other end of hose on the coil, do all 6 wires, do one at a time so you don't get them mixed up, start engine, take a test light hook to ground and touch probe to each piece of vacuum hose, this will short out that cylinder, you should notice engine change, if no change, that coil may not be firing.

Jun 23, 2011 | 1995 Chevrolet Lumina

1 Answer

Last week my car would not start i check all the plugs and 1 and 4 where wet and 2 and 3 where dry i clean them all put back together and started the first time and now its doing the same wont start

Locate the 1-4 cylinders coil pack. Have that coil pack checked at the parts store. If there's only one coil pack for all four cylinders, then have the whole coil pack tested. If the coil pack checks out OK, then have the ignition module tested and replace if necessary. If you don't have a parts store that can test them for you, then give me a response and I can tell you how to check them using a test light and an ohm meter. I hope this information has been helpful and thank you for using

May 29, 2011 | 1995 Mazda MX-3

2 Answers

Fuel but no spark. Coil pack is fine.

Have the ignition module tested, if thats good then try a crank sensor,

Feb 26, 2011 | 1992 Chevrolet Cavalier

2 Answers

Changed coil pack that wasnt firing started fine

check the fire to the coil pack if it's present then check the pulse to the crank sensor

Jan 14, 2010 | 1999 Pontiac Firebird

1 Answer

My intriped cannot start

try coil pack or crank sensor

Oct 01, 2009 | Cars & Trucks

Not finding what you are looking for?
2010 BMW 318ti Compact Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers


Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides