Question about 1997 Chevrolet Astro

Open Question

97 astro van brake bleeding

Bleeding

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: How do you remove an ignition switch key cylinder

There are one or two little pins in the igniton switch that you need to have pushed in while switch is turned and pulled out.

Posted on Sep 09, 2009

  • 743 Answers

SOURCE: 97 astro van awd there is a clicking in the front

Have it put on a rack, and spin the wheels, but don't spin them over 30mph, and go under vehicle and see if the noise will direct you to the problem.

Posted on Oct 21, 2009

  • 1 Answer

SOURCE: Timing on an astro van

No it can not it is run by the cars computer. If the distrubitor cap is on wrong than that can cause multiple misfire

Posted on Dec 02, 2009

  • 1 Answer

SOURCE: looking for location of bcm on 97 astro van dash

The BCM is located immediately above the heater controls inside the dash on my 2004 Astro. I know it controls the headlights and locks but not gauges. Haynes says the gauge fuse supplies it power....but I'm not going to bank on that one.

P/N 15081796 from Napa $115

Good Luck

Posted on Feb 11, 2010

rah1964
  • 92 Answers

SOURCE: how to bleed the brakes on a1999 chevrolet venture

Start with brake in the rear that is the farthest away from the master cylinder ( if your master cylinder is on drivers side start with passenger rear,pump up brake pedal until hard have someone else open bleeder valve until air or fluid squirts out,while holding brake pressure even if goes to the floor dont release pedal until bleeder valve is tightened or you will **** air back into the line,do this several times making sure you get a full stream of brake fluid and no air,continue to other rear wheel and then proceed to front wheel furthest from master cylinderand then final wheel. if you still don't have brakes change master cylinder and bleed all brakes again.

Posted on Jul 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Astro van transmission problems


the bands are too tight.. they need adjusted if they arent fried already..

Dec 29, 2013 | 2001 Isuzu Rodeo

1 Answer

On a 1996 custom astro van how do you bleed breaks


make sure all bleeders are broke loose then retighten start from the passenger rear wheel have somone pump the brake pedal then hold break the bleeder loose. do this until fluid is clear. then move to driver rear and do the same. then move to passenger front. then drivers front. always start from furthest wheel from the master cylinder and move your way closer. hope this helps!

Aug 07, 2010 | 1991 Chevrolet Astro Extended

1 Answer

1996 astro van brakes are mushy. Is there a


I have the same Astro and the same problem. It has surprised me to learn that it is the read drums that are the culprit - shown to me by my local Les Swchab. For some reason they build up with dust and do not grab properly. So the solution would be to use a rear brake shoe that is superior to the type that Les Schawb uses!!! A type that produces less 'dust'.

Feb 22, 2010 | Chevrolet Astro Cars & Trucks

1 Answer

Looking for location of bcm on 97 astro van dash


The BCM is located immediately above the heater controls inside the dash on my 2004 Astro. I know it controls the headlights and locks but not gauges. Haynes says the gauge fuse supplies it power....but I'm not going to bank on that one.

P/N 15081796 from Napa $115

Good Luck

Nov 23, 2009 | 1997 Chevrolet Astro

1 Answer

I have a 93 chevy astro van the brake light came on found a broken rear brake line repaired line bled entire system brake light still on rear brakes do not funtion light still on.


try pressure bleeding the brake call around if you have a muffler man near you they are about the cheapest also make sure your master cylinder is good and the brake sensor are good try these websites www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Nov 06, 2009 | 1993 Chevrolet Astro

1 Answer

Timing on an astro van


No it can not it is run by the cars computer. If the distrubitor cap is on wrong than that can cause multiple misfire

Apr 14, 2009 | Chevrolet Astro Cars & Trucks

1 Answer

97 chevy astro can awd


drop down relay in trans

Jan 22, 2009 | 1997 Chevrolet Astro

Not finding what you are looking for?
1997 Chevrolet Astro Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...