Question about 1989 Cadillac Sedan DeVille

Open Question

Car door chime sound module

It slowly went silent. I called around for a new one but could not find one

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my My 98 or 99 (sic)Ford Escort chime to indicate I left my lights on?


The warning chime sounds if the parking lamps (13200) or the headlamps (13008) are left on after the key has been removed from the ignition switch lock cylinder and either front door (20124) is opened. There is a chime module that controls this .
The safety belt warning chime (10D840) (also called the central processing unit or CPU) is an audible warning system and timing circuit. The system components include:
  • Timing circuit safety belt switch.
  • Dome lamp switches.
  • Safety belt warning indicator switch which is an integral part of the front safety belt buckle end (61203).
  • Ignition switch (11572).
  • Headlamp switch.
The warning chime sounds and the safety belt warning indicator illuminates when the ignition switch is placed in the ON position and the LH front safety belt is not buckled.
Key In Ignition Warning
The warning sounds if the key is left in the ignition switch lock cylinder when either door is opened and the ignition switch is in the LOCK or OFF position.
Don't any of chimes work ?
  • The Headlamp on Reminder Chime Is Inoperative/Does Not Operate Properly
  • Circuits.
  • Fuse junction panel.
  • Warning chime module.
  • GO to Pinpoint Test D .
Let me know ,mite work this out !
Don't

Apr 29, 2015 | Ford Escort Cars & Trucks

3 Answers

Navigator Door Chime goes off when car off and I open the door. Radio system stays on & interior lights go off when door shuts.


All this comes from the GEM module,You will need to repair the driver door lamp switch located in the door lock assemble.

Mar 15, 2012 | 2003 Lincoln Navigator

2 Answers

Does the bcm control the alarm in a 2006 monte Carlo? I can't seem to get the alarm to go off. I've also noticed that I have no chime and turn signal sounds. I just recently purchased this car and...


The no chime and turn signal has nothing to do with the alarm. You have a issue with power supply to turn flasher and door chime. The alarm consist of The door ajar switch,body control module,front door lock switch,power door lock switch. You need to check your fuse for turn signal and the door chime

Feb 22, 2012 | 2006 Chevrolet Monte Carlo

2 Answers

The warning chime on my 2004 Jeep Grand Cherokee continues chiming when the door is closed and the key is in the first position from off. I tow this unit behind a motor home and need to leave the key in...


The chime is active because the sensor on one of the doors keeps reporting it as open - this is a defect in the sensor, located inside the actual lock. You cannot disable the chime, it's an integral part of the Body Control Module. To fix that the door will have to be dismantled and the sensor replaced, a job for a repair shop.
Until you reach one you can disconnect the battery and lock the doors manually.

May 17, 2011 | 2004 Jeep Grand Cherokee

2 Answers

Where is the door chime on a1995 mercury grand marquis


It's the same as the lights left on and the key in door open its called the generic eletronic module and it's in the dash to the right of the steering collum. Why do you want to know as all kinds of things are run by this device and it costs plenty. If it keeps chimbing and you want to stop it all kinds of things don't work with it unplugged ( interior light's cruise control, air conditioner and heat,Radio,Automatic headlights. Daytime running lights) If its saying the doors open, it is! Just because it looks closed doesn't mean that they are the most likly is the driver door and the switch is in the door latch that holds the door closed. The switches rust break fall off or get disconnected. worset problem is the wire from the switch breaks in the door hinge area and the wire will need to be found and replaced or repaired. The modules seldom fail unless submererised in water or the battery hooked up backwards or jumped off wrong battery cable removed while the engine in running but alot of this other stuff will work wrong too.

Dec 05, 2009 | 1995 Mercury Grand Marquis

1 Answer

No sound from radio / now car totally dead


Its you antenna module above your headliner. It controlls your remote for keyless entry as well as your am/fm reception via an amplifier. GM part number is 12233252 for updated and revised version around $100 bucks online.

Jun 15, 2009 | 2003 Cadillac CTS

2 Answers

Possible ignition switch problem? 99 Explorer


key chime sounds if the little tab is grounded where the key contacts it. The theft light is supposed to blink when the system is armed to let you know it is armed. That's normal.

What do you mean by auto door locks won't unlock? The remote doesn't work? the door lock/unlock button on the door trim panel? Do they lock ok? Or, just unlock doesn't work?
-----------------------------------------------------------------------------------------------

NOTE: The generic electronic module/central timer module (GEM/CTM) is connected to the ISO link and is diagnosed through the data link connector (DLC) with New Generation STAR (NGS) Tester.
There are five warning chimes and lamps the GEM/CTM controls: headlamps operating without the ignition on (chime only), door ajar (chime and lamp), key-in-ignition (chime only), driver seat belt warning (chime and lamp), and message center.


Audible Warnings Warning Condition Lamp Duration Audible Duration Audible Output Safety Belt 60 Seconds 6 Seconds Chime, 60/Min. 740 Hz Key In Ignition — Continuous Chime, 120/Min. 740 Hz Headlamps On — Continuous Chime, 240/Min. 740 Hz Door Ajar Continuous 1 Second Single Tone, 1000 Hz Message Center (Tone Request) — 1 Second Single Tone, 1000 Hz
When the is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled.
The will turn on for 60 seconds or until the driver safety belt is fastened. Both the chime and the lamp turn on at the same time.
If the safety belt is buckled before the ignition switch is turned to RUN or START, from OFF or ACC, neither the chime nor lamp will be activated.
Anytime the is changed to RUN from START while the safety belt warning indicator is activated, the safety belt warning indicator will remain activated until either the timing sequence has been executed or the safety belt is buckled.
When at least one door is ajar and the key is in the RUN position, the door ajar cluster lamp is activated and remains on until all doors are closed. A warning tone will sound once any time the key is in the ignition switch and any door is open.
The key-in-ignition warning will sound when the driver side is opened with the key in the and the in OFF or ACC. It will continue to sound until the key is removed, the is closed, or the is in RUN or START.
The headlamp-on reminder chime will be activated if the headlamps or parking lamps are on, the key is not in the ignition switch, and the driver door is opened.
A single tone will be provided each time a ground signal is received from the message center. A one-second tone will sound for warning indications from the message center. A 100 milli-second tone will sound for each message center button depressed.
------------------------------------------------------------------------
  1. NOTE: The generic electronic module (GEM)/central timer module (CTM) must be reconfigured upon replacement. Refer to the New Generation STAR (NGS) Tester help screen on the configuration card to program the Tire Size, Axle Ratio.
    The power windows system and rear window defroster system are (GEM) controlled systems.
----------------------------------------------------------------------------------------------
  • All Windows Operate With the Ignition in the OFF Position
  • Circuitry.
  • Accessory delay relay.
  • CHECK the accessory delay relay; REFER to Component Test. If OK, REPAIR circuit 400 (LB/BK). If not OK, REPLACE the accessory delay relay. TEST the system for normal operation.


-------------------------------------------------------------------------
report back

May 06, 2009 | 1999 Ford Explorer

3 Answers

98 VW Beetle-Door Ajar Chiming while driving


Your door lock module is bad. There are two ways to fix it. #1 is to replace the module. Various places online sell new ones for $160, while you can get them used for around $50. #2 is to replace the switch, which costs around $3-9, but then you have to remove the door lock module, remove the old switch, and mount/solder the new one in. You can also pull the door lock module and cut the wires going to the switch which will tell the door that it's always shut, and it will stop your dinging. That one's free, assuming you can get to the DLM.

Mar 18, 2009 | 2000 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...