Question about 2003 Nissan Altima

Open Question

What does recall code R0606 means in nissan altima 2003

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2003 nissan altima 2.5s transmission rough shift

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Posted on Oct 02, 2008

SOURCE: 2003 Nissan Altima?

Where is the sensor placed on the car?

Posted on Oct 07, 2008

  • 1 Answer

SOURCE: 2003 Nissan altima alternator

how do yow remuve alternaotor on a 2003 nissan altima

Posted on Jan 05, 2009

localwonder
  • 6784 Answers

SOURCE: whate is code 1400 and 400 in nissan altima 2001.

P1400 DPFE Circuit Low Input
P0400 Exhaust Gas Recirculation Flow Malfunction

These codes represent a fault in the Auxiliary Emission Controls. Here's a brief describing of the EGR valve. The EGR stands for exhaust gas recycling valve. During cruising speeds, the valve opens allowing exhaust into the intake manifold. The purpose of this is to cool the temperature of the combustion inside the cylinder as the spark plug fires. This in turn, lowers emissions. If the EGR is stuck in either direction(open/closed), it can effect the idle of your vehicle and can stall it out at times. it can also trip the engine light as well. Good rule of thumb is to clean out the carbon out of the intake manifold thoroughly before you install a new EGR. this will prevent the engine light form coming on once more. if the carbon build up is high, chunks of it will jam the EGR, causing it to fail over and over.


Please rate and god bless.

Posted on Mar 26, 2009

localwonder
  • 6784 Answers

SOURCE: sensor recalls for 03 nissan altima

No recall information on that situation at this time. if you suspect this, you can contact the dealer and provide your vin and they can look up a new or non released recall for your vehicle. If this recall has just been released, it will take some time to circulate though the recall system. at this time, nothing is showing up on our systems on a recall for the crank and cam sensors.

Posted on May 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced the fuel pump and filter on a 2000 Nissan Altona it's shooting fuel from the pump but not near the filter what can cause this


Nissan fuel pump recall : Nissan Altima Common Engine ...

repairpal.com > Problems > Nissan > Altima
Nissan issued a recall on the fuel pump for premature failure. ... I am in need of a newfuel pump and scared to drive my car and its leaking ... pump and fuel filter located and how can i access them if i wan to replace th. ... 2000 Nissan Altima.

Fuel pump and fuel filter - 2003 Nissan Altima - RepairPal

repairpal.com > Questions > Nissan > Altima > 2003 Nissan Altima
Mar 25, 2009 - Where is the fuel pump and fuel filter located and how can i access them if i wan to replace them?

Fuel Pump Replacement Cost for Nissan Altima - RepairPal ...

How To Replace Fuel Filter on Nissan Altima 2001 - YouTube? 6:46https://www.youtube.com/watch?v=Vwg2wm13ilMOct 25, 2011 - Uploaded by roluardoHow To Replace Fuel Filter on Nissan Altima 2001 ... How toreplace a 2002 Nissan 3.5 Maxima Fuel Filter 2000-2004 pt 1 - Duration: 14:20.fuel hose replacement. Car fuel leakage. fuel pump ...? 5:30https://www.youtube.com/watch?v=BPGaxxkK71cApr 4, 2014 - Uploaded by LearningZoneHere I am going to illustrate the fuel hoses (fuel lines)replacement for Nissan Sentra ... Fuel pump leak fix - quick and cheap - Duration: 11:16.

Jan 13, 2016 | Nissan Cars & Trucks

1 Answer

Why does passenger side low beam keep burning out?


2002-2003 Altima(L31) headlamp recall - Nissan Forum ' Nissan Forums

forums.nicoclub.com/2002-2003-altima-l31-headlamp-recall-t125981.ht...
Jul 14, 2005 - Owner notification is set to begin August 15th 05. ... I thought I had a bulbburn out, but was able to fix it by making sure the bulb ... I spent about $250.00 a few months ago replacing a headlight bulb! ... I know this is an old post, but my 02altima's passenger headlight keeps burning! it's the 3rd time this year!

Sep 16, 2015 | 2005 Nissan Altima 2.5

2 Answers

Nissan altima p0335 and p0725 is this a recall


I had the same codes on my 2003 Nissan Altima 2.5 SL


I replaced Crankshaft and Camshaft Positioning sersors and never had this problem since. Check my youtube videos how I did it:

http://youtu.be/7FsLBcuREYE
http://youtu.be/325s0pFQZtg

Apr 07, 2011 | Nissan Altima Cars & Trucks

1 Answer

Speed and crankshaft sensors problem. Need to find location and how to replace this parts. Check engine light is on because of this problem.


Recall Number: 07V527000 Dates Manufactured: JAN 2004 to OCT 2006 Number of Vehicles Affected: 653910 Date Owners Notified On: DEC 2007 ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR. Consequence of Defect:
IF THE INTERRUPTION IN THE SIGNAL FROM THE CRANKSHAFT POSITION SENSOR IS SO BRIEF THAT THE ELECTRONIC CONTROL MODULE (ECM) LOGIC DOES NOT HAVE TIME TO DIAGNOSE THE CONDITION, THE ENGINE MAY STOP RUNNING WITHOUT WARNING WHILE THE VEHICLE IS DRIVEN AT A LOW SPEED INCREASING THE RISK OF A CRASH. Corrective Action:
DEALERS WILL REPROGRAM THE ECM FREE OF CHARGE. CERTAIN MY 2006 ALTIMAS WHICH HAVE BEEN PREVIOUSLY REMEDIED UNDER RECALL CAMPAIGN 06V223 (NISSAN R0606) ARE NOT INCLUDED IN THIS RECALL SINCE THE REPROGRAMMING FOR 06V223 ALSO INCLUDED THIS REPROGRAMMING. THE RECALL BEGAN ON DECEMBER 31, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.

Feb 01, 2011 | 2005 Nissan Altima

2 Answers

Where is the crankshaft sensor located ?


The crankshaft position sensor (POS) is located on the oil pan facing the gear teeth (cogs) of the signal plate. It detects the fluctuation of the engine revolution.
After replacement, ECM reprogramming is required.
This vehicle may be subject to voluntary recall, CAMPAIGN I.D. # R0606, that involves the crankshaft position sensor:

Quote: Nissan has determined that on some 2003 - 2004 Altima and Sentra vehicles with the 2.5 liter engine the operation of the crank angle sensor is significantly affected by variations in temperature that occur due to the unique location of the sensor in the engine. Under certain driving conditions, these variations in temperature can be large enough to cause a brief interruption in the signal output from the sensor. If the interruption in the signal from the sensor is so brief that the Electronic Control Module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at low speed.

Jun 29, 2010 | 2004 Nissan Sentra

1 Answer

Where is a cam shaft poision sensor in a 2003 altima located


are u sure this code is not for the crankshaft position sensor, there is a recall for that from Nissan, they will replace it free of charge.

Sep 12, 2009 | 2003 Nissan Altima

1 Answer

My 2005 Nissan Altima loss power while I was driving down the street, the next day it cut off at a light, it takes a few seconds to start, but always starts


the 2.5 altima's had a recall on that problem about 2-3 years ago. Go to edmunds or progressive find the recall letter and the dealer will fix it free. well here you go:

section_opened.gif Recall ID # 07V527000 - ENGINE AND ENGINE COOLING Recall Date: NOV 14, 2007 Component: ENGINE AND ENGINE COOLING Model Affected: ALTIMA Potential Units Affected: 653910 Recall Details Recall Date: NOV 14, 2007

Model Affected: 2005 NISSAN ALTIMA

Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.

Consequence: IF THE INTERRUPTION IN THE SIGNAL FROM THE CRANKSHAFT POSITION SENSOR IS SO BRIEF THAT THE ELECTRONIC CONTROL MODULE (ECM) LOGIC DOES NOT HAVE TIME TO DIAGNOSE THE CONDITION, THE ENGINE MAY STOP RUNNING WITHOUT WARNING WHILE THE VEHICLE IS DRIVEN AT A LOW SPEED INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPROGRAM THE ECM FREE OF CHARGE. CERTAIN MY 2006 ALTIMAS WHICH HAVE BEEN PREVIOUSLY REMEDIED UNDER RECALL CAMPAIGN 06V223 (NISSAN R0606) ARE NOT INCLUDED IN THIS RECALL SINCE THE REPROGRAMMING FOR 06V223 ALSO INCLUDED THIS REPROGRAMMING. THE RECALL BEGAN ON DECEMBER 31, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.

Potential Units Affected: 653910

Notes: NISSAN NORTH AMERICA, INC.

Jun 15, 2009 | 2005 Nissan Altima

1 Answer

Sensor recalls for 03 nissan altima


No recall information on that situation at this time. if you suspect this, you can contact the dealer and provide your vin and they can look up a new or non released recall for your vehicle. If this recall has just been released, it will take some time to circulate though the recall system. at this time, nothing is showing up on our systems on a recall for the crank and cam sensors.

May 21, 2009 | 2003 Nissan Altima

1 Answer

2003 nissan altima it want start right away,after about 15 mins it will start. any ans.


Yes, there is a recall on the crankshaft sensor and an ECM reprogram. Take it to Nissan for the recall

Apr 06, 2009 | 2003 Nissan Altima

1 Answer

2003 nissan altima 2.5s transmission rough shift


Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Sep 25, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
2003 Nissan Altima Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...