Question about 2002 Lincoln Continental

Open Question

Remove the washer spray nozzle on 2002 lincoln continental

How do I remove the windshield washer spray nozzles?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 2005 Answers

SOURCE: No Windshield washer fluid spraying out, motor appears to not be working. need help locating fuse or how to replace the motor it's self.

first loosen and, remove one of the hoses that go to the sprayer then operate the wiper pump you should see the fluid come out of the hose. if it does not come out and, no sound is made from the pump check your fuses if the fuse is ok (find the fuse location in your user manual ) replace the pump motor you can get a replacement at an autoparts store. don't forget to replace the hose.

Posted on Apr 21, 2009

  • 52 Answers

SOURCE: front washer fluid does not pump, rear one does

Sounds like the pump is nacked. Or it may be a wiring earth fault. Find the wiring connector get a earth/Grong test light. Connect it to the positive and a good earth point on the car have some one work the stalk in the car and see if you got power if not it ll be the fuse, the pump or a busted wire in the line

Posted on May 13, 2009

  • 31 Answers

SOURCE: Lincoln LS 2003 Where is AC Freon/coolant Valve to fill?

Your radiator fluid is your coolant! Also the source of your A/C!

Posted on Sep 04, 2009

  • 373 Answers

SOURCE: 1997 lincoln Continental serpentine belt change

you need to find which pulley is the belt tensioner. use a socket and a breaker bar to lift the tensioner. once the belt loosen, slide the belt off one of the pulleys close to you. then slowly release the tensioner.

Posted on Oct 31, 2009

  • 3 Answers

SOURCE: lincoln continental cabin filter

I solved the problem by ordering the filter fro an online site that gave instructions:
instructions at this link are:
Turn on wipers until they are in an upright position then turn ignition off. Open the hood. The filter compartment is on the passenger side, directly beneath the windshield. Pull back weather strip and remove cowl. Slide the water shield toward the front of the vehicle then lift to remove. Replace filter and reassemble.

I have it out and am waiting for new filter.

Posted on Jan 10, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix a misdirected windshield washer

You can use a small sharp pick and insert it into the sprayer nozzle and gently move the nozzle in the direction needed. It may take a couple of tries to get it where you want it

Apr 06, 2015 | 2002 Ford F-150

1 Answer

Replaced washer pump and still no pressure

For front windshield, the hoses are usually easy to locate and replace. This is cheap hose so replace it. Other issues are that the spray nozzles can freeze if you don't have correct fluid in them. Most of these can also be replaced, but this may be harder depending on the location. I don't know on your car, but many modern cars have these attached to the wiper arms, so it may be very easy.

Jan 15, 2015 | 1991 Lincoln Continental

1 Answer

I just purchased a 2002 Saturn L100 for my son and when we tried to use the windshield washers, it only sprayed out of one of the jets on the driver side and just drizzled out of the passenger side. Any...

try two ideas . one use a wire from a wire brush and push in down the nozzle hole to clear corrosion blockage. Two is to take the hose off the back of the nozzle or where ever you can get it off and using a air nozzle blow compressed air back down the hose from the nozzle.

Jan 06, 2014 | 2002 Saturn L-Series

1 Answer

How to remove windshield washer pump

sounds like the spray nozzles are clogged you can usually remove them and soak them in soapy water or spray water through it with a sprayer on the end of a hose. if that doesn't solve it then you may have a cracked line or the pump that pumps it out may be broken but usually is the nozzles are clogged.

Sep 23, 2012 | 2002 Pontiac Bonneville

1 Answer

How to remove clogged windshield sprayer on 08 tundra

Normally it can be dirt that accumulates on the nozzle end and all that is needed is a thin sewing needle or a office pin to clear the nozzle while the washer is pressed to work. If there is no action you can also use a thin wire to be pushed into to clear off the dirt.Use a cleaning spray into the nozzle to remove any other dirt.

Mar 14, 2012 | Cars & Trucks

3 Answers

I think my van has a clogged windshield nozzle. The wiper fluid comes out but doesn't even squirt high enough to hit the windshield.

First try to clean out the squirter nozzles.Take a very small wire, sometimes a staple works great, and stick it into the nozzle to clear any debris.Then try to spray it again.If this didn't solve the problem and the debris is cleared, then you either have a weak or blocked pump, which is located on the washer reservoir itself.Hope I could help!!! Rate me accordingly!! Thanks!

Oct 06, 2010 | 2002 Chrysler Town & Country

1 Answer

I have a 2008 Grand Prix. Windshield washer is

follow the hoses to the hood or wiper arm (i dont know where your spray nozzles are)and disconnect hem and press the spray button. if it sprays your nozzles are plugged, if not its your pump motor.

Feb 16, 2010 | 2008 Pontiac Grand Prix

1 Answer

The fluid has stopped coming oput of the sprayers and I cannot hear a motor noise when trying to spray my windshield.

check the washer pump with the hoses from the nozzles removed. if the washer fluid comes out the nozzles are plugged. if not the pump motor is at fault

Feb 13, 2010 | 2002 Audi A4

1 Answer

I have a 2002 Trailblazer with windshield washer problem. The washer motor works, but no fluid is coming out. The problem first started with one of the nozzles spraying poorly. Now they don't work at all.

The nozzles are clogged. With a needle or pick, clear the blockages from the nozzles. Make sure you disconnect the hoses from the back of the nozzles before cleaning and reconnect them afterwards.

Jan 20, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

Front windshield washer nozzle

Use a thick needle (or tooth pick), partially insert into the nozzle and gently re-orientate the direction. Test a nozzle spray and repeat steps until desired trajectory is aquired.

Jan 15, 2010 | 2008 Subaru Outback

Not finding what you are looking for?
2002 Lincoln Continental Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts


Level 3 Expert

79077 Answers


Level 3 Expert

5677 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides