Question about Cars & Trucks
Often passenger side switches and motors go bad from none usage or too much. Try replacing the door switch. You may need to pull the door panel off to see what is going on with a meter to check for continuity. After removing door handle and switches many of the panels pop off using a flat blade screwdriver.
Posted on Nov 22, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
Posted on Dec 07, 2008
Sounds familiar - I pulled the rubber boot back and found the black wire was broken. I stripped the wires and put on a couple bullet connectors (terminators) and all is good. Just wish I would have seen this post before I took the door panel off... Oh well...
Posted on Dec 18, 2008
SOURCE: Power windows inop
a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs
Posted on May 05, 2009
if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
that go to door locks
Posted on Jul 20, 2009
Had the same issue - as gche37 noted the black ground wire is normally the issue.
Pull the boot back on the wire bundle in the door and you will probably see the broken wire. I then spliced a wire to the one running into the door. I pulled the black wire into the car, spliced to that and it worked (works) fine. Took about 15 minutes. I splices with a 12 ga braided wire
Posted on Feb 24, 2010
Tips for a great answer:
Jun 02, 2015 | 2004 Audi A6
Sep 24, 2013 | 2008 Audi Q7
Oct 24, 2012 | 2002 Buick LeSabre
Sep 11, 2011 | 2004 Saab 9-3
Nov 06, 2010 | 2002 Audi A4
Sep 10, 2010 | Audi TT Cars & Trucks
May 13, 2010 | 2004 Audi A4
Nov 07, 2008 | 2004 Volkswagen Jetta
May 31, 2008 | 2003 GMC Yukon
43 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: