Question about Cars & Trucks

Open Question

Vauxhall vectra c 2.0dti spanner light comes on loose power

If you unplug the barometer sensor the car is fine up to motorway speeds then limp mode kicks in if I plug barometer sensor back in on the motorway the car is fine until your back on town roads. Then the problem comes back.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: holden barina 2003

it means its due for service. If u wanna get rid of it without servicing the vehicle then as you start the car simultaneously push the ODOMETER reset button on the dash and it will wipe it. This will however just delay the point your car needs servicing.

Posted on Jun 28, 2008

Ad
  • 1 Answer

SOURCE: 2002 chrysler town and country wont leave limp mode

try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 to 200 dollars but it should fix your problem.

Posted on Apr 04, 2009

bonedivers
  • 1140 Answers

SOURCE: my transmission light comes on

Most likely fault is a ground. But could be anything electrical.

Posted on Jul 21, 2009

  • 4 Answers

SOURCE: 98 Catera goes into "Limp Mode" after warm up.

have you check you ignition coil packs.

Posted on Jul 21, 2009

  • 1 Answer

SOURCE: vauxhall vectra c noise when going over bumps

jack front of car up clean around the coil spring where it sits on the shock absober probably do this with your fingers and a screw driver to clean the grit out, then squirt some oil on he bottom of the spring and where it sits on the shock absorber do the same with tho other side.might have to repeat every 3 months especially in winter

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a vauxhall vectra 2,0 litre diesel design. The car is in limp mode. Wont rev above 3000rpm. It feels like the turbo isn't coming in. The engine management light is on const. Any ideas


need to be plugged in to diagnostic machine to give you the problem
car will stay in limp/home mode till its cleared with the machine..

Apr 09, 2016 | Vauxhall Cars & Trucks

1 Answer

Spanner showing on dash when engine running vauxhall vectra c


VECTRA CAR WITH SPANNER WARNING LIGHT This Vauxhall Vectra car with spanner warning light illuminates or flashes yellow. Light will illuminate for around 3 seconds when the ignition is switched on. If the fault light illuminates whilst the engine is running, this signifies a fault within the engine or gearbox electronics system. The system will switch to emergency mode where fuel consumption may increase and the vehicles drivability reduced. A Vauxhall workshop must be consulted. If the light flashes whilst the engine is running, this signifies a fault within the electronic immobiliser system and the engine will not be able to be restarted.

Oct 25, 2015 | Vauxhall Cars & Trucks

1 Answer

Vauxhall vectra fault codes


Check all the pipes under the bonnet as a loose or damaged pipe can cause the spanner to come on without a fault code.

Apr 01, 2014 | Vauxhall Vectra Cars & Trucks

1 Answer

My vauxhall vectra lacks power and is in limp mode. if i get the power then it starts misfiring. the car is a vauxhall vectra 2.2sri 2006.


Use a bottle of yellow HEET dry gas / GAS DRYER to remove any moisture problem in the fuel.

Clean / replace air filter.

Top off ATF to MAX level.

Jan 17, 2014 | Cars & Trucks

1 Answer

Engine speed sensor


are you sure it was the speed sensor.... speed sensor fail will also affect the abs.... now cam or crank sensor will put engine in limp mode.

Nov 29, 2013 | 2002 Nissan Sentra

1 Answer

Vauxhall vectra 2006 looses power


have you had the fuel regulator checked a leaking vacuum hose that controls this can make it do this or it is faling.

Jan 26, 2013 | Vauxhall Cars & Trucks

1 Answer

Igot a vauxhall astra 1.8 sri igot a light cum on the dash its a car with a spanner threw it when on the engine idles bad


This is your mechanical fault light and the lack of power is the car going into limp mode to protect the engine and its components.
Have a garage run a diagnostic check to find the fault code and the fault.
Hope this helps

Apr 18, 2012 | Vauxhall Astra Cars & Trucks

2 Answers

1997 isuzu wizard mu check light


Code 24 is a vehicle speed signal sensor fault, the sensor most likely does not provide a useable signal until about 25 MPH, when the computer doesn't see any signal after that speed it turns on the light. Make sense?

Sep 08, 2008 | 1997 Isuzu Oasis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...