Question about Cars & Trucks

1 Answer

Mercury Sable Problems

Latch for my mercury sable does not allow to open hood

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 38 Answers

While pulling release handle punch the hood near wiper side with bottom of your fist or have someone else do it if you can't reach it while pulling out handle,if you see front of hood lift in any way you should be able to open it then,but before closing it again you should spray the hood latch with a good amount of wd40,that usually get hood working normal again.

Posted on Nov 22, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: 2000 mercury sable drive belt

For VIN 2 FLEX Fuel:

4488d47.jpg For VIN U and S....with A/C:

c2b84a7.jpg PLEASE DON'T FORGET TO RATE!!!!

Posted on Apr 01, 2009

  • 1 Answer

SOURCE: Remove the right rear door panel in a Mercury Sable

Removed two screws from the perimeter of the door, one in the back edge and the other under the bottom. Remove one screw from the handle cup where the window switch is located. Placed some tape around the edge of the handle cup for protection against scratches and pried the cup out with a small putty knife. It is hard, but will pop out. Next I taped the paint around the door panel and used a flat bar to reach behind the panel and had enough of a gap to see the orange tabs and pried each one to remove the panel completely. The panel does not need to be lifted up to removed, just pull it straight off the door. A few tabs may still be holding, but will pop off with a bit of pressure.

Posted on Oct 08, 2009

  • 1114 Answers

SOURCE: got a code 1742 on my sons mercury sable

Okay this is a internal problem in the transmission you will need to remove side cover and oil pan of the transmission.This is a big job to do it safely you will need a hoist and engine cradel this a profesional job my advice to you unless you have done this before 2 or 3 times take it in for service this is a delicate job mistakes can resault in costly mancanical further repairs.Hope this helps,John

Posted on Dec 27, 2009

Testimonial: "seems like it should not be as hard as you say "

  • 163 Answers

SOURCE: fuel pump relay location on 98 mercury sable

its under the hood on driver side what the problem not starting check the trunk area for the fuel cut off switch poss bad or tripped did u get hit or someone bump ur car

Posted on Mar 28, 2010

alicantecoli
  • 22095 Answers

SOURCE: firing order for 99 mercury sable 3.9 v6

153624

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 mercury sable, need to pick my car up 2" from the rear cause it sags. Can I adjust the shocks that are on it ( motorcraft xf12-18080 ) are the one's on it now. ??


Sag? How To Fix? - Taurus & Sable Owners' Club

www.taurusowners.com > ... > Suspension, Handling & Brakes

Jun 19, 2010 - 20 posts - ‎6 authors
What causes this and is there anyway to prevent this from happening to my car? ... The springs tend to soften up with age and wear. ... strut in the knuckle. i had to do that in teh rear of my car after putting eibachs in it because it ... To do the mod, the tab (#2) is cut off the strut to allow the strut to be positioned ...

Mercury Sable Problems

forums.edmunds.com > Mercury > Mercury Sable

Mar 15, 2000 - 31 posts - ‎17 authors
I have a "clunking" noise in my 1999 Mercury Sable LS. .... in the sag (look under the drivers side of the car near the back of the front ... band up the cable and back into place on the bracket and my clunk ... #2 - Does anyone with an LS have these same steering problems in ..... Select Make; Model (optional).

Car & Truck Repair Questions, Solutions &


Dec 16, 2015 | Mercury Cars & Trucks

1 Answer

Where is the fuse box on a 1999 mercury sable not a ford


The Mercury Sable and the Ford Taurus are sister cars using the same platform. There are two fuse boxes, one under the dash on the driver's side and one under the hood.

Mar 05, 2015 | 1999 Mercury Sable

1 Answer

Why is the trunk popping open with a clicking sound mercury sable problems


I would get the remote checked at a parts store like Autozone. Could be trunk release button is stuck. Also try disconnecting the battery(neg terminal) and then see if trunk locks. The locks are made to work mechanically without electric. This way you would know if it is an electric problem or broken lock.

Aug 31, 2014 | 2003 Mercury Sable

1 Answer

Cannot open the hood. hood release doesnt work properly


have an assistant pull up on the hood while you pull the hood release. it might pop the hood loose. if so, spray the latch mechanism and the hood release lever with some lubricant spray.

Mar 12, 2011 | 2001 Mercury Sable

1 Answer

Car hood release latch isnt working for a 2003 mercury sable


it might need to be greased or it might be broken

Sep 02, 2009 | 2003 Mercury Sable

1 Answer

Hood release on 05 sable


on each side of core suport under hood are rubber bumpers if you unscrew them so they are pushing the hood up just a little and oil the latch real good it should work you may have to adjust this a few times to get it right good luck and let me knod if it works...

Jul 15, 2009 | 2005 Mercury Sable

1 Answer

1996 Mercury Sable hood release


there is a lever on the driver side just under the dash near the door and there is a safety latch under the hood once you pull the lever inside first

Feb 06, 2009 | 1996 Mercury Sable

3 Answers

Need the fuse box diagram for the 1999 mercury sable gs?


if you have an owners manual there should be one in there but if not it should be under the cover to the fuse box also there is one under the hood of the car as well

Dec 29, 2008 | 1999 Mercury Sable

1 Answer

Door latch frozen open


My 2000 Sable does it evey winter - all 4 doors. I have found spraying WD 40 into the latch on the door works quickly to allow you to close the door.

Dec 23, 2008 | 2000 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...