Question about Cars & Trucks
Wipers work but no fluid
There is a small pump should be located on the firewall it goes out a lot of the time depending on how old your car is.
Posted on Nov 22, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
hi first of all can you hear the motor working if not check the motor if you can you have a blockage either a traped pipe if you have been filling with washing liqiud or simular the jets can get blocked or a pipe has a break or come off yates210456
Posted on Oct 09, 2008
SOURCE: my front windshield wiper pump
First make sure you have water in washer reservoir, with ignition on reds (not started) then get someone to operate washer while bonnet is closed otherwise the wipers (may come on) may damage your bonnet (would also be a good idea to throw some water on your screen before commencing), listen for a buzzing noise, if you can hear that noise than your washer motor is ok, if not - if fitted with fuse check it and if fuse is ok than your motor needs attention. If motor is ok than while someone is operating the washer motor look under the car to see if there is any water leaking, if there is water leaking than the hose going from your washer bottle to your washer nozzles has come off somewhere, visually check this hose, usually small diameter and clear in colour, reconnect or replace it. If there is no water leak and you have full water and motor is working, than your nozzle, usually located on the bonnet or wiper arms are blocked, this mainly happens after polishing the vehicle. There are 2 main ways of cleaning these nozzles, easiest way is to get a fine pin and poke it several times, this will clean it 85% of the time, if it does not work than you need to find the hose that connects to it and pull apart at a join, closer to the nozzle the better, and give it short burst of compressed air, have to be careful not to pop the hose out at the nozzle as some of them are located in really awkard points, hope this helps.
Posted on Apr 12, 2011
Tips for a great answer:
Jan 28, 2011 | 2005 Scion xA
Jan 16, 2011 | 2004 Chevrolet Tahoe
Jan 05, 2011 | 1999 Mercury Mystique
Jan 03, 2011 | 1992 Honda Accord
Dec 25, 2010 | 2006 Renault R5
Dec 10, 2010 | Nissan Altima Cars & Trucks
Nov 09, 2010 | Chevrolet Colorado Cars & Trucks
Jun 07, 2010 | 1998 Saturn SL
Jul 02, 2017 | 2001 Volkswagen Golf
12 people viewed this question
Usually answered in minutes!