Question about 1993 Lincoln Town Car

1 Answer

My engine wont turn over

Message says check DLC charge system

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Take plug out and spin with wrinch. may full with coolant.

Posted on Nov 22, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 gmc envoy xuv , battery light stays on , replaced battery and checked alternator charging fine


You checked the charging voltage at the battery with a ? volt meter ? What was the voltage with the vehicle running ? 13.1 to 14.1 volts ?
BATTERY NOT CHARGING The IPC illuminates the battery not charging indicator in the driver information center when the following occurs:
?€¢
The PCM detects that the generator output is less than 11 volts or greater than 16 volts. The IPC receives a class 2 message from the PCM requesting illumination.


?€¢
The IPC determines that the system voltage is less than 11 volts or greater than 16 volts. The IPC receives a class 2 message from the body control module (BCM) indicating the system voltage


Charge Indicator Always On
Step
Action
Yes
No

1

Did you perform the Diagnostic System Check for Starting and Charging? yes or no
Go to Step 2 yes
Go to Diagnostic System Check - Engine Electrical no

2

  1. Turn ON the ignition, with the engine OFF.
  2. Observe the Charge indicator on the instrument cluster (IPC)
Does the charge indicator illuminate?
Go to Step 3
Go to Symptoms - Engine Electrical

3

  1. Turn OFF the ignition.
  2. Disconnect the generator connector.
  3. Turn ON the ignition, with the engine OFF.
Does the charge indicator illuminate?
Go to Step 4
Go to Charging System Test

4

Test the charge indicator control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6
Go to Step 5

5

Replace the PCM. Refer to Powertrain Control Module Replacement in Engine Controls 4.2L.
Did you compete the replacement?
Go to Step 6
--

6

Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 3

Aug 25, 2015 | GMC Cars & Trucks

2 Answers

1998 corvette will not start says reduced power


If the security light is blinking it will not start. The security system needs to be reset. You will have to have a fully charged battery to reset the system. With a full charged battery turn the ignition forward until the warning lights come on and leave the key in the on position for 15min. Turn key off and wait 10sec. then try and start.You may have to perform this procedure a couple of times, however, it is usually successful the first try. The reduced power light can be set by a low voltage/poor charge battery

Apr 12, 2015 | 1998 Chevrolet Corvette

1 Answer

Why doesn't it charge at idle?


It depends if the system is RVC/regulated voltage control. If so, there are about six modes of operation. One is, "fuel economy mode". In that mode, the targeted generator out-put is 13 volts and battery state of charge is greater than 80%. There are two other conditions.
Is there a battery discharge problem? Does the instrument cluster give charging system message or warning lamp?
Any charging system trouble codes? My info on your charging system is limited.

May 02, 2013 | 2010 Chevrolet Express Passenger

1 Answer

No data at DLC and theft light is flashing


Does the check engine light come on when you turn the key on ?

Jul 27, 2012 | Lincoln Continental Cars & Trucks

1 Answer

My 2002 gmc sierra 1500 died on me on the way to work last week.so i took it to an autozone and got it tested.it was the altenator.I got it replaced and went ahead and bought a brand new battery.After...


The charging system on your vehicle is controlled by the PCM powertrain control module . The PCM will send a message to the instument cluster on the class 2 serial data network to turn on the charging light if it see's or think;s there is a problem with the charging system . Should have a code stored . Have autozone check for codes.

Jul 13, 2017 | 2002 GMC Sierra 1500

2 Answers

Engine wont turn over getting starter disabled message


Most likely a security system issue. Make sure the battery is fully charged and you are using an original coded key. Even an original key can sometimes cause this to happen if the key is badly worn.

Jan 08, 2011 | 1999 Cadillac Eldorado

2 Answers

Battery was dead and tried to start after charging, starter solenoid clicked and engine turn over slowly without starting. Now engine will not turn over. Battery is charged have power to all accessories...


okay,think of it this way,you tried starting,engine turned slowly,no start.....then you charged battery,engine wont turn over(although accessories work)WHY WAS THE BATTERY DEAD TO START WITH.Try a jump start(another battery)if it starts then you know what im going to say.....

Nov 06, 2010 | 2005 Ford Explorer

1 Answer

Engine will not turn over at all and display panel gives two messages: Engine temp. sensor data error Charging system data error


Get it to a dealer and check it out. error code sensor faulty or overheating possible if not looked at. have you checked the oil level and check the oil colour, if not clear, if milky, possible head gasket failure.

Sep 21, 2010 | Ford Expedition Cars & Trucks

1 Answer

My check engine light just turned on randomly on my 92 subaru loyal. I have a DLC but don't know where to connect it. Help!


a DLC for OBD2 wont work on your car. only cars made after 1996. you may need a manual for your car, there should be 2 green connectors under the dash to connect, or they may be under the hood. then the light will flash codes out. Its been so long I cant remember.

Oct 09, 2009 | 1993 Subaru Loyale

Not finding what you are looking for?
1993 Lincoln Town Car Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...