Question about 1996 GMC Suburban

1 Answer

My truck gets stuck in 2nd gear and feels like racing motor

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Shift silinoid?

Posted on Dec 30, 2013

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bendarden
  • 984 Answers

SOURCE: i lost 5th gear and reverse in my 1998 gmc sierra

This is a test. I'll be right with you

Posted on Oct 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 toyota Camry manual hard shifting from 1st to 2nd gear


With the engine off see if the shift between 1st to 2nd feel,s free if not it could be the cable check the clutch is disengageing all the way it should go into reverse without crunching,other then that it could be a synchro ring worn check that the gearbox has the right oil in it.

Dec 20, 2015 | 2008 Toyota Camry

1 Answer

Reset transmission


i will assume that your car have an automatic transmission and to say the least your clutch is experiencing what we called sliding an experienced mechanic can help you solved the problem personally.

Sep 21, 2013 | Hyundai Motor 2002 Sonata

1 Answer

1995 Jeep Wrangler Auto Trans 1st to 2nd shift acts like it goes into neutral what could the problem be


When was the last time the transmission fluid and filter changed? I would have that serviced first. If it is an electronic transmission, the line pressure might also have to be reset.

Aug 15, 2017 | 1995 Jeep Wrangler

1 Answer

I have a 1999 Toyota Camry. It starts out in 2nd gear. I can shift into low and the low gear works, but when I shift to


THE 1 - 2 SHIFT SOLENOIDS NOT WORKING COULD BE STUCK OR FAILED CODE SCAN VECHICLE IF YOU SEE CHECK ENGINE LIGHT FLASHING FAULTY VSS SENSOR WILL CAUSE SHIFT PROBLEMS ALSO.

Nov 10, 2011 | Cars & Trucks

1 Answer

Can't get car in or out of gear


Throwout bearing will need to be replaced most likely. Otherwise cluctch plate or fork may have stuck

Aug 06, 2009 | Hyundai Motor 2002 Elantra

1 Answer

Automatic tranny gets hungup between 2nd and third gear.


possible governor problem;
this part or group regulates the fluid pressures during changing loads.

Jan 22, 2009 | 1995 Audi 90

1 Answer

2nd gear crunch


first of all you shouldn't be reving that high to change gears. that's too high. secondly if it's grinding only during the change from 1st to 2nd gear you may have a problem with the gears not being aligned anymore...ie synchronizers worn out, bearings worn out, etc. take to reputable transmission shop to get it diagnosed and repaired. it sounds like the synchronizers are a problem there. and you may have metal in your fluid now that it's been grinding which will affect the rest of the transmission. if you are speed shifting as in racing, you are not doing your transmission any good. you probably don't have a transmission built to do that if it's the original factory tranny... meaning you did a major NO NO to your tranny and are tearing it up speed shifting when it isn't built for racing.

Oct 13, 2008 | Hyundai Motor 1996 Elantra

1 Answer

1994 German Spec M3


You might have a bent fork in the tranny. I used to race a lot and had the same problem after trying to shift quickly repeatedly. After a while, it just wont grab the gear.

check out your tranny, it shouldnt be too bad of a problem.

Sep 10, 2008 | 1995 BMW M3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...