Question about Cars & Trucks

1 Answer

What would cause Volvo out drive to kick up when put in reverse. ( 1991 )

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 90 Answers

Check the mounts

Posted on Nov 23, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: My 1996 Volvo 960 2.9 ltr drives in all Position except reverse

I am not 100% but this should be a good place to start and it will cost you nothing. You need to get under the car. You will see that there is a thin long shaft that is theaded on the end. It should have a rubber gromet at the connector. I believe that your gromet is worn out or perhaps you need to simple adjust the threaded end to be tight as your shifter is traveling to far. I am not an expert, but I have been all over my 960 for the past 261K miles and 10 years of ownership.

Good luck.

Posted on Apr 08, 2009

  • 9 Answers

SOURCE: Transmission kicks in first gear and reverse/drive positions. Why

check for broken motor mounts. if it is a rear wheel/4 wheel drive, check your u-joints in your driveshaft. if the aforementioned is good, check the fluid level and condition in your transmission. last resort, if rear/4 wheel drive: check your rearend fluid level and condition.

Posted on Aug 14, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1991 th700r4 no reverse


Usually you lose 1st and revo so sounds like rebuild time.

Feb 27, 2013 | Chevrolet 1500 Cars & Trucks

1 Answer

My engine is jumping smells like smoke fluids are


sounds like a motor mount is bad. does the motor kick back hard when putting in drive or reverse? if so you need to change the bad motor mount.

May 06, 2010 | 1991 Nissan Stanza

1 Answer

Removing Driver's seat in a 1991 Volvo 740


4 bolts is fairly easy remove the rear first with the seat all the way forwards and then put seat all the way back then 2 in the front remove them ..tilt the seat back and if there is any wire harness disconnect them as well ...reverse process for re-installation

Sep 07, 2009 | 1990 Volvo 760

2 Answers

1991 Volvo 240 backup lights do not work


The 240 was always a bit susceptible to poor electrical connections in the taillights. Check all the connections at the taillights thoroughly and then work back through the wiring. The other major possibility is that the reverse-engaged switch (is engaged by gear shift) has failed. I can't remember off the top of my head, how to get at a Volvo's switch but a bit of poking around the gearstick should probably find it for you.
Hope this helps - please message me if you require extra info/help Sherwin

Sep 02, 2009 | 1991 Volvo 240

1 Answer

1991 Volvo 240 Overdrive arrow will not go off


You need to replace the overdrive relay located inside the center cosole on the right side about even with the blower switch.

Jun 06, 2009 | 1991 Volvo 240

1 Answer

Car stalls when i put it in drive or reverse,


Sounds like your vacuum assist brakes diaghram has sprung a leak. Pull the hose to the assist and plug it with a bolt or something. Then try it.

May 20, 2009 | 1997 Volvo 850

1 Answer

1991 volvo turbo idles fine runs ok but the exhaust manifold gets glowing hot after highway speeds. help


please stop driving you will ruin your motor.the problem you are having is a vacum leak. and that is causing your engine to run very lean.

Mar 11, 2009 | 1991 Volvo 740

1 Answer

Why does my 1991 chevrolet cavalier slams in the diff section when shifting the gear lever from park to drive and or reverse?


check your engine and trans mounts sounds like you have a bad mount allowing motor to shift up pop hood and look at engine while someone puts in gear see if engine comes up or kicks back it should only move slightly

Jan 26, 2009 | 1991 Chevrolet Cavalier

1 Answer

1991 volvo 940 sedan


Try the headlight relay. It is behind the kick panel directly in front of the driver. It might be shorting on the wiper relay which is in the same location. 

Sep 04, 2008 | 1991 Volvo 240

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...