Lost a credit card down the back of the coin tray, (the flat shelf over the ashtray). Can't see how to remove either to get in behind to retrieve the card. There is no lever to be seen. Furthermore, how would the ashtray get emptied?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
in the ashtray there is usually a metal ****** like a ash stubber press this down and then pull the whole tray towards you with it depressed it should come out, to replace just reinsert and close this will lock it back into place.
Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
Remove the floor console and the front console panel. On 1984-85 cars, if access to the back of the radio may be gained through other means, such as removing the "pocket" from the console, the console need not be removed.
Radio mounting on 1986-89 Accords
Remove the ashtray and ashtray holder.
On 1986-89 cars:
Remove the coin box, air vents and ashtray lighting bracket.
Remove the dashboard switches on the left and right of the steering wheel.
Lower the steering wheel to its lowest position. Remove the dash visor. This is a large, one-piece assembly which includes the center dash trim. It's plastic; don't break it.
Remove the two screws holding the radio at the rear of the unit.
Carefully push the unit out the front of the dash. When access is gained, disconnect the multi-pin connector and the antenna cable from the unit. Remove the unit.
Reinstall in the reverse order. Take great care not to damage the dash trim and instrument visor. Make certain the connectors are firmly and squarely installed. If applicable, be sure to enable the SRS.
this is a delicate job and care should be taken not to damage anything.ther is a woodgrain panel that needs to be removed.in order to do that get in and face the panel.between to the air vent and the panel there is a gap where you can enter a screw driver use a rag to prevent damage.apply force to lift panel.work all around to take panel out.you should de able to get to the ashtray.reverse install panel