Question about 2008 Dodge Avenger

1 Answer

Location of Spark Plugs

Where are and how to get to the spark plugs on a 2008 BMW 528i, 3.0L inline 6 cylinder N52K engine? Yeah, sounds silly, but I cannot find them.

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: location of spark plugs in 2005 dodge dakota

To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:

  • Spark plug socket
  • Ratchet
  • Torque wrench
  • Extension
  • Flat-tip screwdriver
  • Make sure the truck is cold!!!

Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.

At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.

Insert the socket, with extension into the spark plug hole.

Remove spark plug.

Check the gap on new spark plug, it should match stock.

tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).

repeat this process with all other sparks.

be sure that no dirt gets into the spark plug holes.



Posted on May 11, 2009

morse008
  • 1111 Answers

SOURCE: How do I replace the spark plugs on a 2001 Dodge

is it a shroud that covers all of them i know some models it takes a special plug socket to remove them its very thin in diameter so a special socket is used or if possible like i said if its a shroud remove this to gain access

Posted on Sep 07, 2009

  • 1 Answer

SOURCE: 2008 dodge avenger spark plug location and socket size.

  • 2008+ Dodge Avenger 2.4L 4cyl.
  • Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
  • Once removed you will see 4 black spark plug covers with one hex type screw holding each.
  • Remove Hex screw and place aside, pull upward to remove plug boot from plug.
  • To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
  • Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

Posted on Feb 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i figure out which cylinder is cylinder 6 on my Chrysler 300 m year 2000. The location is in the engine dealing with the spark plugs.


no 6 is the last in an inline engine and last in the left bank facing the engine in a v 6
or second from the front in the left bank facing the engine for v 8
probably has the number cast into the inlet manifold as well

Nov 18, 2015 | 2000 Chrysler 300M

Tip

Attention to spark plugs


Pay attention to what spark plug comes from what cylinder, and save the old spark plugs. The cylinders are numbered from 1 to 8 as follows: Front of car Left side - right side Cylinder Bank 2 - Cyliner Bank 1 5 - 1, 6 - 2, 7 - 3, 8 - 4, Rear of car. The reason for keeping track of the old spark-plugs is it can later provide important information to a person who knows how to "read" spark-plugs, if the engine ever develops a problem. Also it is good practice to put the coils back in the same places those were.

on May 19, 2008 | 1988 BMW M5

1 Answer

Spark plug wire order


give me engine type your vechicle has inline 6 what engine type do you have 325 325e 325i 528i 633csi 733i

Jun 21, 2013 | Cars & Trucks

1 Answer

Its a 1998 528i bmw that will start but wont stay running also there is a loud kind of backfire noise from one of the cylinders . the engine wont rev up proper even though i keep pressing the throttle...


The fact that you have a backfire noise that you can trace to just one cylinder makes it sound like a spark plug could be loose or broken. Pull out your spark plugs and examine them. On a '98, that eill mean pulling off the plastic cover, then removing the coils (need a 10mm socket, be careful with the ground wires) and then reach down in with a small spark plug socket on a long extension.
Also, look for a massive air leak on the intake. Take apart the air tubes from the air filter up to the throttle body looking for air leaks. You could also have a leak at the intake manifold gasket but you may need help to check for that.

Mar 25, 2011 | 2008 BMW 528i Sedan

1 Answer

What are the location of clyinder 1-6 on 96 sable


STANDING IN FRONT OF CAR TO THE LEFT ON PASSENGER SIDE CYLINDERS FACING YOU ARE 1 2 3 ON DRIVER SIDE CYLINDERS FACING YOU ARE 4 5 6 ALL THIS INFORMATION I GAVE YOU IS FOR THE 3.0L AND 3.2L DISTRIBUTORLESS ENGINE.WRITE BOTH NUMBERS I GIVE YOU 3 2 1 AND WRITE NUMBER 4 6 5 PUT NUMBER 321 ON TOP OF 465 THAT WILL BE SPARK PLUG WIRES LOCATION ON COILS.THEN ROUTE THEM TO THE CYLINDERS SPARK PLUGS.BESURE TO HOLD PAPER WITH NUMBERS I GAVE YOU NUMBERS STAND IN FRONT OF ENGINE SO YOU WONT MISLOCATE SPARK PLUG WIRES FROM COILS TO SPARK PLUGS.

Mar 06, 2011 | 1996 Mercury Sable

1 Answer

I would appreciate if u can show me are tell me how the spark plug wires go on a 2001 mercury sable i change the spark plugs and forgot how they go


FORD SABLE HAD TWO 3.0 ENGINES. ENGINE WITH CRANKSHAFT PULLEY FACING FRONT TOWARD RADIATOR AND GRILLE. CYLINDERS ON LEFT PASSENGER SIDE IS 1 2 3 CYLINDERS ON DRIVER SIDE THE RIGHT IS 4 5 6 GET PIECE OF PAPER WRITE NUMBER 321 AND WRITE UNDER THAT NUMBER THE NUMBER 456 STACK THEM NUMBERS ON TOP OF EACH OTHER THATS WHERE PLUGS WIRES LOCATION IS THE ROUTE THEM TO CYLINDER SPARK PLUGS NOW IF YOU HAVE THE 3.0 ENGINE TURNED SIDE WAYS.CYLINDERS FACING YOU 4 5 6 AND BACK CYLINDERS ARE 1 2 3 GET A PIECE OF PAPER WRITE NUMBER 456 THEN WRITE THIS NUMBER UNDER THAT NUMBER 321 WITH NUMBERS ON TOP OF EACH OTHER.LINED UP.THAT WILL BE YOUR SPARK PLUGS WIRES LOCATION.THEN ROUTE THEM TO THE CYLINDERS LIKE 1 TO 1 CYLINDER.

Feb 20, 2011 | Mercury Sable Cars & Trucks

1 Answer

What is the rigth way to connect the spark plug cables into a distributor of a cadillac catera 1997?


STANDING IN FRONT OF ENGINE FACING CRANKSHAFT.CYLINDERS ON LEFT SIDE ENGINE 1 3 5 AND CYLINDERS ON THE RIGHT SIDE OF THE ENGINE ON DRIVER SIDE IS 2 4 6 GET PIECE PAPER WRITE NUMBER 5 3 1 AND UNDER THAT NUMBER WRITE NUMBER 2 6 4 THATS COIL PLUGS WIRES LOCATION HOLDING THAT PIECE OF PAPER FACING FRONT OF ENGINE IS PLUG WIRES LOCATION ON IGNITION COILS TO ENGINE SPARK PLUGS. NUMBERS ON PAPER HAS TO LINE UP LIKE 5 OVER 2 AND 3 OVER 6 AND 1 OVER 4 NUMBERS I GIVE YOU WHEN YOU LINE THEM UP HOLD PAPER STANDING FRONT ENGINE.THAT IS CORRECT PLUG WIRES LOCATION ON SPARK PLUG COILS.

Feb 07, 2011 | 1997 Cadillac Catera

2 Answers

Changed the spark plugs and the old ones were covered in oil


i'm guessing that your car is a 4-cylinder. this is common for inline 4-cylinder engines. since the spark plug holes usually go through the valve cover, the valve cover gasket will leak and collect in the spark plug holes. to fix this you will have to replace the valve cover gasket.

Mar 23, 2010 | 2000 Saturn SW2

2 Answers

Cant locate spark plugs


If it is a 4 cylinder engine you should have 4 black thick wires going into four points in line, on a V6 engine there will be 6 of them, should be easy to find them now.

Dec 23, 2008 | 2002 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...