Question about Volkswagen Jetta

1 Answer

2002 vw jetta stalls when reversing automatic

I put it in reverse and as soon as I take my foot off the break it stalls. There is no noise and drives fine. Please help !

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Volkswagen Expert
  • 113 Answers

Internal problem in the transmission.

Posted on Feb 03, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

taran_2005
  • 10515 Answers

SOURCE: 94 Jeep Wrangler intermittently stalls when put in reverse, drive

Take the air inlet hose off where it enters the throttle body and take a look at the throttle plates. It is likely that they’re dirty and have a build-up of carbon deposits. That is the most common cause for stalling that we see in the shop for your vehicle. Sometimes all it takes is a good cleaning to cure the stalling problem. There is an idle speed setting on your Jeep, but to check and/or perform this service step requires the use of a computer scan tool for your vehicle. If the cleaning doesn’t help ask a repair facility to check and reset, if needed, the minimum idle speed on your Jeep.


Thnx.

Posted on Nov 27, 2008

  • 686 Answers

SOURCE: 2005 VW Jetta 1.8L turbo 4 cyl. VIBRATION :(

underinflated tires, wheels out of balance or wheel alignment. Heater blower motor bad and/or going bad

Posted on Feb 27, 2009

  • 168 Answers

SOURCE: how to remove transmission , how to replace reverse gear?

Are you sure that it is gone? make sure the all the bushing on the transmission are good it maybe that it is not able to go all the way in gear. If you do need to take it out get a good manual "Bentley" are the best it will show you the inside of the transmission too. Haynes are also good but not for working on the transmission it self

Posted on Mar 04, 2009

  • 14036 Answers

SOURCE: hi my vw golf 2000 1.6 make a cluncking noise when reverse

check engine to transmission mount.

Posted on May 05, 2009

  • 1 Answer

SOURCE: 01 VW Jetta Vibration Problem

Check the motor mounts. They might be worn or loose which can cause vibration felt when the engine is reved up or running at higher rpms than at idle.

Posted on Jan 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 VW beetle Transmission problems wont go into reverse.


automatic ---- probably the reverse servo/ solenoid has failed , wire problem or the TCM
run the fault codes and fix the problem unit

Mar 20, 2017 | Cars & Trucks

1 Answer

2002 vw jetta when i put in park it wants to go in drive, when I put it in drive it wants to go in reverse


I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure.
Best Manuals

Oct 26, 2016 | Volkswagen Jetta Cars & Trucks

1 Answer

Yellow foot light on dashboard of my 2002 Volkswagen Jetta


does it go away when you step on the brake to change gears (putting it drive/reverse from park, assuming it's an automatic)?

Aug 19, 2010 | 2002 Volkswagen Jetta TDI

2 Answers

I hace 02 pt cruiser. while in reverse engine shut down when foot is taken of gas


you might have some wire toughing the ground rabbing when put it in reverse the eng shiftting causing wires to stretch and might touching ground or hot wire

Jul 20, 2009 | 2002 Chrysler PT Cruiser

2 Answers

ASL on cannot get into gear, and brake light are out


To get the car out of park you have to put the shifter right in between neutral and drive and as soon as the car starts put it in drive. Keep your foot on the brake obviously. You can go to Reversve once you get the car started and in DRive.

May 11, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

2005 VW Jetta 1.8L turbo 4 cyl. VIBRATION :(


underinflated tires, wheels out of balance or wheel alignment. Heater blower motor bad and/or going bad

Feb 27, 2009 | 2005 Volkswagen Jetta

1 Answer

01 VW Jetta Vibration Problem


Check the motor mounts. They might be worn or loose which can cause vibration felt when the engine is reved up or running at higher rpms than at idle.

Jan 13, 2009 | 2004 Volkswagen Jetta

1 Answer

2001 jetta tdi automatic transmission will not shift into high ge


My 2002 Jetta TDI will not always go into reverse. When this happens I put it in 1st then back to reverse and many times it goes right in reverse. It happens whether it is cold or warmed.

Nov 23, 2008 | 2001 Volkswagen Jetta TDI

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...