Question about 2007 Nissan Navara 2.5
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I took my pathfinder to U-HAUL and asked them to check the towing lights. There was a pinched wire by my tail light and they cut it and changed it out for me, it was $5. I am so glad that I didnt take it to Nissan. My second step was going to be getting a new dimmer switch..but the guy who worked on my car said that wouldnt be the problem. He also told me that replacing a fuse that kept blowing out was dangerous and after the first time to get it checked out. Learn something new every day!!
Posted on Sep 12, 2008
SOURCE: tail light fuse keeps blowing
Terry: It's obvious I'm not dealing with a USA spec car, however, I had lived in the U.S. Virgin Islands and am quite familiar with the Bluebirds of the past. Nissan still uses the same basic circuitry designs as far as what circuits serve what. Here are the circuits to look at.
All lights which are switched on by the headlight switch. This includes the Cigarette lighter back light, radio light power supply, automatics have shifter back lighting as well as your climate controls and all dash lights. Your side marker lights are also served by this circuit. The dash lights go through a type of dimmer switch which essentially creates resistance, thus dimming the lights. Sometimes the clocks are tied into the circuits. Start with the simple things first and work your way in. There is a type of fuse called a circuit breaker which will plug into the fuse block in place of the fuse.
Get the same rating as the one you pulled out. DO NOT USE A JUMPER WIRE AND LET THE SMOKE OUT OF THE WIRES!
If the circuit breaker blows immediately, you have a serious short!
With the circuit breaker, if the short is not real bad, the lights will burn for a little bit before the breaker blows. Once it cools, it will close and the circuit will operate again. While it is in operation, you look for the lights that operate and the ones that don't. Check the ones that don't. Although it's rare for a bulb to cause a fuse to blow, it does happen.
I often find problems are due to radio installations or other types of installations. So if you don't have a factory radio or if you have some type of accessory which has been installed in the console or dash, this would be a prime suspect. Nissan's are not really known for electrical problems unless they have been in collisions. If your car has been in a collision, look in the area where it was hit. You may find a pinched wire or damaged insulation. I am not quite sure what model your car would compare to in reference to a US car.
The Bluebird's were 510's. Are the Maxima's now? What ever model it is, unless it has no sister model imported to the
USA, the odds are that the circuits are going to be real close if not identical! I hope I have been of some assistance. Let me know.
Posted on May 23, 2009
most likely you have a short in one of the bulb connectors or the hot wire from them is pinched on medal somewhere. Or you have water intrusion shorting one out. Inspect the bulbs. Leave both bulbs out. install fuse. Press brake pedal several times and hold. Inspect fuse. if its blown its the pedal switch that's bad or a pinched wire from there. If good put one bulb in. Test again,, then the next bulb. If you see something obvious fix it.
Posted on Jul 18, 2009
there is a short somewhere.put a test light in place of the fuse.
the light will glow bright.when the short is removed,the light will go dim
Posted on Jul 18, 2009
Tips for a great answer:
Mar 31, 2016 | Cars & Trucks
Mar 30, 2016 | 2007 Nissan Navara 2.5
Aug 21, 2014 | Cars & Trucks
Dec 28, 2012 | 2005 Nissan Pickup Navara
Jan 10, 2011 | 2005 Nissan King Cab
The Tail lights and Instrument lights are usually on the same circuit so both will go out if the fuse for the circuit blows. Check for a blown fuse for this circuit and replace if out. If fuse continues to fail, check the tail light or side globes for a faulty globe and replace if necessary. Also check for any chafed wires that could be shorting to the body causing the fuse to blow.
Dec 13, 2010 | 2000 Chevrolet Malibu
Aug 26, 2010 | Honda Accord Cars & Trucks
Sep 02, 2009 | 1997 Toyota Corolla
Mar 06, 2009 | 1991 Lincoln Town Car
Jul 28, 2016 | 2007 Nissan Navara 2.5
393 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: