Question about Cars & Trucks

Open Question

Honda crv front brake thumping sound - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: thumping noise when apply brakes 1990 Accord

yes my cv axles had to be replace cause of the same thing but when you replace one side you need to do the other side at the same time cause when 1 goes bad the other is not that far behind . i know from experience

Posted on Nov 21, 2008

  • 651 Answers

SOURCE: 2001 Honda Crv Bake light on dash is on

make sure your emergency brake is off all the way.

Posted on Nov 28, 2008

  • 57 Answers

SOURCE: 2004 honda crv brake won't release

Your emergency brake is a mechanical brake system that is indipendant of the regular hydrolic system. If the red brake light on the dash is on make sure it's the emerg. brake and not a problem with the fluid level or the calapers sticking. the best way to check the emerg. brake is to rase both rear wheels off the ground and spin them. If they spin, the emerg. brake is not locked up. If they don't spin, take the rear tires off and the brake drums. (you may have rear disk brakes.) check the springs to insure they are all hooked up properly. If there is no problem there, follow the parking brake cable to check for damage. The cable is like a brake cable on a bike, If the inner cable is binding inside the cable sleeve,the brake wont release. If you have rear disc, it's probly a bad calaper.The park brake cable is attached to the calapers. Rember if it wont run it's annoying but if it won't stop, it's deadly. DON"T experiment with brakes!!! If in doubt, take it to a pro.

Posted on May 12, 2009

  • 1 Answer

SOURCE: front end loud noise like an old bed clunk, honda crv 2000

its probably your sway bar end links, I had the same problem, I replaced both sides and the bushings and no more clunk noise

Posted on Sep 29, 2009

bunnydawg
  • 5158 Answers

SOURCE: 2004 Honda CRV - Front Brakes running hot!!!

either caliper seized ? also when you installed the rotors did you have them machined ?

Posted on Oct 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Shimmy upon acceleration honda crv


Check:

Motor Mounts
Transaxle Mounts
Front CV Drive Axles
Loose or Worn Front Suspension Parts
Steering Rack Mounts
Steering Rack Inner Tie Rods
Top Bearing Plates on Struts
Do Some Front Brake Work

Is it a Standard Trans ?
Clutch Could Be Worn

Oct 03, 2014 | Cars & Trucks

2 Answers

2006 Honda CRV makes screeching sound while turning corners


built into the brake pads is a small bit of metal that when the pads get to low to be safe , runs on the rotor and produces the squeal applying the brakes stops the vibration so the noise drops off

Jun 29, 2017 | 2006 Honda CR-V

1 Answer

Honda crv 2004 brake lights night lights


LOOK FOR BRAKE LIGHT FUSE OR BURNED OUT BULBS BAD BULB SOCKETS OR GROUNDING PROBLEM.

Feb 24, 2010 | 2004 Honda CR-V

2 Answers

Hi! My 07 CRV has ABS system. Because in MN


Grinding noise from your brakes means you need to inspect the brakes and change the brake pads. the wise thing to do. Good Luck

Feb 08, 2010 | 2007 Honda CR-V

1 Answer

I replaced the pads on my 2005 Honda Accord. I had


ABS only senses if the wheel is spinning or not.
"Thumping sound" sounds like a bad problem. I've not had thumping sound from my front brakes ever.
I don't know how a caliper could cause thumping.
Is everything installed correctly and do the brakes stop the car??

Jan 04, 2010 | 2005 Honda Accord

1 Answer

2004 Honda CRV - Front Brakes running hot!!!


either caliper seized ? also when you installed the rotors did you have them machined ?

Oct 19, 2009 | 2000 Honda CR-V

1 Answer

Front end loud noise like an old bed clunk, honda crv 2000


its probably your sway bar end links, I had the same problem, I replaced both sides and the bushings and no more clunk noise

Apr 26, 2009 | Honda CR-V Cars & Trucks

1 Answer

Thumping noise when apply brakes 1990 Accord


yes my cv axles had to be replace cause of the same thing but when you replace one side you need to do the other side at the same time cause when 1 goes bad the other is not that far behind . i know from experience

Nov 18, 2008 | 1990 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...