Question about 2003 Hummer H2

Open Question

Hummer windshield wiper problem - 2003 Hummer H2

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 2003 HUMMER H2

Had the same problem. i have to re-place my front wiper motor they are all connected.

Posted on Feb 25, 2009

  • 147 Answers

SOURCE: windshield wipers wont shut off

small plastic cam in colum atached to switch . stick a screwdriver in thier and flip it the oly way it will go. or u could just replace the switch. u might just have a short to. do they keep running with the car off

Posted on Aug 15, 2009

iambanshee74
  • 3489 Answers

SOURCE: my 2004 hummer h2 windshield wipers activate on

this is in the wiper control module. the dealer sells replacement kits with new boards and the cover. not too expensive. common problem.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I find out if the wipers on my 2006 H3 Hummeris on a relay?


The Wiper/Washer System consists of the following components:
• Windshield wiper/washer switch
• Body control module (BCM)
• Wiper micro relay
• Wiper 2 relay
• Wiper diode
• Windshield wiper motor
• Windshield washer pump
• Windshield washer nozzles
• Windshield washer solvent container
• Windshield wiper arm and blade assemblies
• Windshield wiper transmission
• WIP/WASH 10A fuse
• WIPER 25A fuse

Wiper/Washer System Description
The body control module (BCM) controls wiper motor low speed operation. The washer pump and high speed operation are controlled directly by the wiper/washer switch. The windshield wiper/washer switch supplies voltage on the signal circuits to the BCM for windshield wiper/washer operation. When WASH, MIST, DELAY, LOW, or HIGH is detected, the BCM energizes the wiper micro relay by suppling voltage to the relay coil. This allows battery voltage from the WIPER fuse to flow through the relay switched input then through the contacts and out the relay switched output to the wiper 2 relay switch contacts. Since the wiper 2 relay switch contacts are normally closed to the low speed circuit of the windshield wiper motor, the motor will operate at low speed.

Low Speed Operation
When the wiper switch is in the Low position, voltage is supplied through an internal resistor to the signal circuit. The body control module (BCM) monitors the windshield wiper switch signal 1 circuit, and energizes the wiper micro relay which will operate the windshield wiper motor. The wiper motor will operate at low speed, since the wiper 2 relay is de-energized. Low speed can also be commanded with a scan tool, by commanding Wiper Relay Cmd. ON and OFF. Refer to Scan Tool Output Controls .
High Speed Operation
In the High position, the windshield wiper/washer switch supplies voltage to both the wiper micro relay and wiper 2 relay coils. This energizes both relays and allows battery voltage from the wiper micro relay switched output to the switched input of the wiper 2 relay through its contacts and out the switched output of the wiper 2 relay to the high speed circuit of the windshield wiper motor. The windshield wiper motor will operate at high speed. During high speed wiper motor operation the wiper switch signal circuit is at the low speed signal voltage, and the body control module (BCM) supplies redundant voltage to the wiper relay via the wiper diode.

This info is out of hummer factory service manual !

Dec 10, 2016 | 2006 Hummer H3

1 Answer

Why did my wipers on my 2006 H3 Hummer quit?


This is a complex wiper circuit ! The place to start would be to check for DTC'S - diagnostic trouble code's .
DTC B3715, B3716, B3717, B3718, or B3719
The body control module (BCM) controls and monitors the state of the ON/OFF wiper relay control circuit. When the windshield wiper switch is placed in to a low speed setting, a signal is applied to the BCM. The BCM then applies battery positive voltage to the coil side of the ON/OFF WPR relay through the relay control circuit. This energizes the relay, allowing battery positive voltage from the FRT/WPR fuse through the switched side of the ON/OFF WPR relay through the HI/LOW WPR relay and to the windshield wiper motor. Ground is applied at all times to the coil sides of the wiper relays and the windshield wiper motor from G105.
• DTC B3717, the BCM detects a low voltage level on the supply circuit of the wiper micro relay for 1 second when the relay is energized.
• DTC B3718, the BCM detects a high voltage level on the supply circuit of the wiper micro relay for 1 second when the relay is de-energized
Your best bet mite be to take your vehicle to a qualified repair shop !

Dec 10, 2016 | 2006 Hummer H3

1 Answer

My back windshield wiper for my hummer h2 2005 won't turn off? How can i disable it untill i get to a mechanic?


Pull the two fuse's , RR WPR 15amp in the instrument panel fuse box an the RR WRP 25amp fuse in the under hood fuse box.

Nov 24, 2015 | Hummer Cars & Trucks

1 Answer

The wiper stops every where when u shut it off,does not go down


Your small circuit on wiper motor is bad i had the same problem check it take a look its called wiper censor change it and it will stop raining its like majic. Kcp

Dec 31, 2014 | 2007 Hummer H3

1 Answer

My windshield wiper fluid is not comimg out the driver side


probably a clogged squirter. Us a paper clip or safety pin to poke in the hole then try again.

Jan 22, 2012 | 2005 Hummer H2

1 Answer

The wipers keep icing up while driving. We had to stop several times to clean the ice off the wipers.


The only thing that might help some with that is to keep your defrost vents on high to keep the windshield warm. There is not much else you can do to stop the wipers from freezing up in inclement winter weather.

Dec 19, 2009 | 2009 Hummer H3

1 Answer

My 2004 hummer h2 windshield wipers activate on their own and cant be stopped.


this is in the wiper control module. the dealer sells replacement kits with new boards and the cover. not too expensive. common problem.

Nov 05, 2009 | 2003 Hummer H2

2 Answers

Windshield wipers wont shut off


small plastic cam in colum atached to switch . stick a screwdriver in thier and flip it the oly way it will go. or u could just replace the switch. u might just have a short to. do they keep running with the car off

Aug 15, 2009 | 2003 Hummer H2

1 Answer

2003 HUMMER H2


Had the same problem. i have to re-place my front wiper motor they are all connected.

Dec 08, 2008 | 2003 Hummer H2

Not finding what you are looking for?
2003 Hummer H2 Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7699 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...