Question about Dodge Cars & Trucks

1 Answer

Fusible link location

Blower fan on front ac stopped working

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Dodge Expert
  • 139 Answers

Hard to know with only what you asked but if you follow the wiring from it you will see black connector plugins those Ade your fusable links

Posted on Dec 08, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Dymondy
  • 2 Answers

SOURCE: Relay center location

Finally located the AC primary small relay in the relay center under the right dashboard site. The relay had burned winding and only the resistor connected parallel to the coil was showing some resistance otherwise it wasn't engaging when I applied power to it. The Buick is actually 1990.

Posted on Aug 05, 2008

  • 117 Answers

SOURCE: Front AC Blower quit working. Rear AC blower

The first thing I would do is check to see if a fuse is blown or bad relay. Then I would unplug the blower motor with a test light make sure you are getting power to the blower located on the far passenger side of the vehicle under the dash if it has power and good ground then suspect vaulty motor. If you are not getting power at the plug then you might have a bad switch or resister. If it does have a blown fuse remember they usually blow for a reason like faulty wiring or even a in the motor itself. I would also recommend that you change the ac cabin filters behind the glove box if they have not been changed most people neglect them on that vehicle because they are a little more difficult to change, after removing the glove box there is a metal bracket in the way of opening the cabin filter compartment. They wont cause a blower motor to not work, however they do restrict airflow to the evaporator and they protect you from pollen, dust, and even exhaust gases. Hope this helps.

Posted on Jul 08, 2009

kirkx
  • 2019 Answers

SOURCE: blower fan not working. AC still cooling. Not

Sure. But could also be fan switch or motor. Check with a test light to make sure where the voltage stops.

Posted on Apr 13, 2010

  • 1243 Answers

SOURCE: My front air bower for my ac stopped working my

if you have cold air in the rear then it isn't the a/c compressor. if no air comes out of the front vents the it is either the blower motor or the blower motor resistor.

Posted on Aug 04, 2011

SOURCE: How to access ac blower and fan switch, 1999 Volkswagen Beetle?

ac wont work light doesnt come on defrost dont even work wat do i do

Posted on Jun 08, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is fusible link located on a 2004 Hyndai Elantra?


There are nine fusible links in the engine compartment relay and fuse box: 120A FUSIBLE LINK (BATT), 30A FUSIBLE LINK (ABS 1), 30A FUSIBLE LINK (ABS 2). 30A FUSIBLE LINK (BLOWER), 40A FUSIBLE LINK (IGN), 20A FUSIBLE LINK (ECU), 50A FUSIBLE LINK(BAT), 20A FUSIBLE LINK (RAD), and 20A FUSIBLE LINK (COND). The passenger compartment junction block contains the 30A FUSIBLE LINK (PWDW)

Jul 20, 2017 | 2004 Hyundai Elantra

1 Answer

Acura legend ac control untied stop working along with the fans any idea wat could it be


The rotary control switch on the dash controls the blower motor for the A/C. The A/C will not turn on unless the blower motor is functioning properly. The passenger-side radiator fan will not turn on until the A/C begins running. BUT the driver's side radiator fan should always work. Ergo, check the function of the blower motor (located underneath the dash behind the glove box). Usually when it goes bad, it's because of the blower motor RESISTOR (mounted inside the blower motor housing). When the resistor goes bad, the blower motor shorts out, causing it to fail. The switch rarely ever fails. The radiator fan relays are located next to & on both ends of the radiator. Check them too. In the link, the blower motor RESISTOR is #5.
Acura Parts AcuraOEMparts com Genuine Acura OEM Parts from Delray Acura

Apr 02, 2013 | 1991 Acura Integra Hatchback

2 Answers

I need to locate my blower motor resistor on my 1999 S-10. do u know where it is located on my s-10?


The resistor is located under the hood on the passenger side. At the back of the engine compartment you need to locate the airbox it can be identified by a circular piece that's right beside the fender on the firewall (this is your blower motor) to the right if it (looking from the front of the truck) about 4 -6" you will see a wire plug. Unplug this connector and locate the four screws that attach it to the air box. Remove these screws and pull the resistor from the housing.

Hope helps (remember to rate this answer).

Dec 13, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

My ac/heater fan stopped blowing. There were no previous problems with the ac. How can I tell if it's just a blower fuse or the fan/motor itself. And where is the blower motor located?


Does it work on all speeds, or has it only stopped on #1 speed for instance....the blower motor is located at the passenger side footwell...

Sep 20, 2010 | 2003 Hyundai Accent

1 Answer

Radiator Fan Not Coming On, NO AC, Overheating 2001 Oldsmobile Alero, 3.4L V6, 130K miles Put new relays in, checked all fuses. Removed the temperature sensor wire and fans came on full blast. Tried to...


Usually when the fans won't turn on it's a fusible link, a relay, or a bad temp. sensor, or fuse.

You seem to have covered all of the bases except the fusible link that comes off of the starter in an array of fusible links that are different colors and have a rubber piece attached to differentiate it from regular wires.

You can stretch the fusible links to determine if the wire inside has broken.

This is an often overlooked aspect of GM cars when trying to get the fan to work.

Aug 11, 2010 | 2001 Oldsmobile Alero

2 Answers

I need to know where the heater fuse is in a 1991 civic the heater is not working at all


open the engine hood and locate the fuse box of your electronic fusible link, lift the fuse box cover and look for the diagram thats says heater, lift off the fusible link with a long nose plier and see if the center of the link is broken then you may have to purchase one with same amps

Apr 07, 2010 | 1991 Honda Civic

1 Answer

Where is the blower motor relay 89 dodge spirit


It's against the firewall under the drivers side of the dash. You'll need to remove the fuse panel and other parts to reach it. Disconnect the battery first in case you were to short something out.  f you're blower motor isn't working, before replacing, check for power through the system by checking for continuity or voltage with a multimeter. The AC/Heating system gets it's own power through the ignition switch seperately from other accessories and only passes power in the RUN position, so check for power there first. If you don't have power at the ignition switch, check the fusible link between the battery and firewall (There's a whole group of them about a foot away from the firewall on the left side). I found out that was the problem with my ventilation system after I'd already torn apart the dash.
If you have to replace the blower motor (make sure it is the blower motor first, because it's not a fun project), you'll have to remove the glovebox. You'll then have to remove the fan enclosure by removing several bolts. You'll probably have to replace the gasket as well, as the one in my car fell apart once the enclosure was removed. You'll then have to remove the fan by decompressing a spring clip and removing from the center spindle. You can then remove the fan. In my car, there wasn't a connector at the blower motor, so you'd have to desolder or cut the wires. If you do cut the wires, you'll have to resolder the new blower motor in and put heatshrink over the solder joints (adhesive preferably), as I don't believe it is advised to use crimps due to the amount of current. Ultimately there'll be soldering involved, most likely in a cramped space, so be careful of solder drips. If the fusible link is blown, check the connection at the ignition switch. Mine melted pretty severely, which is probably what blew the fusible link. If you change the fusible link, put a fuse holder in it's place. If you have to replace the ignition switch connector as well, solder everything... no crimps. 

Apr 01, 2009 | 1989 Dodge Spirit

3 Answers

How to access ac blower and fan switch, 1999 Volkswagen Beetle?


if its work in only low speed u have to replace the blower motor resstor which located close to the blower
let me know have a good one

Mar 31, 2009 | 1999 Volkswagen Beetle

1 Answer

1992 Dakota heater problem??


The fan generally is located under the dash on the passenger side... while you are there you will notice a couple wires plugged into the side of the duct work near the fan... that's your resister block for the fan speeds... it's likely failed... remove the two or three screws holding it in... unplug the connecter and replace it.

Robert

Jan 16, 2009 | 1996 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...