Question about Cars & Trucks

Open Question

How to adjust camber macpherson strut on nissan bluebird

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 750 Answers

SOURCE: where is the fuel pump located on the 1992 nissan bluebird arx

its located in the fuel tank makes up part of the fuel level sending unit

Posted on Jun 24, 2009

  • 64 Answers

SOURCE: Camber adjustment

Camber adjustment is part of the alignment. who told you that?

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: have new mono rear shock and strut assembly for

Don't know if you got your answer properly or not, but you need NO rear camber Alignment on that vehicle. In fact it takes no alignment at all in the rear and the only thing adjustable in the front is TOE. So, YOU'RE GOOD!!!

Posted on Aug 20, 2009

SOURCE: when do i need to change my 2004 Toyota matrix XR

There isn't really a replacement interval for struts however if you notice that the ride is a lot more bouncy then it used to be or notice oil leaking from them it's time to replace. For a quick crude but effective test, using the palm of your hands push down on a corner of the vehicle a few times to get it bouncing up and down. If once you release it it continues to bounce for more then 2 or 3 times it might be time to replace the struts.

Posted on Sep 27, 2009

Testimonial: "Thanks!"

  • 205 Answers

SOURCE: I need a diagram of a MacPherson Strut please

There are only 3 pieces associated with a McPherson Strut. The top cap, the strut and the coil spring. You'll need a set of spring compressors to replace the coil spring. Otherwise its plug and play.

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need to now how to set front caster camber on 2.3i 1996 VW Combi

Castor and camber are two separate adjustments.
Castor is how far the suspension strut leans forward or backwards and adjustment is very limited.
Camber is the tilt of the wheels top to bottom measured across the car. How far apart are the wheels at the top compared to the distance at the bottom. Adjustment depends on the suspension fitted. Like castor, camber adjustment can be limited. So work out which one it is you to adjust.

Feb 09, 2018 | Volkswagen Cars & Trucks

2 Answers

I have a 04 saab my pass wheel is leaning in. Why?

Have the alignment checked for a camber issue. Have you hit anything recently ( curb/pothole ) that may have caused this issue? Camber angles, if not in specification will cause tire wear and pulling. Most but not all vehicles have a provision for camber adjustment. Worst case scenerio is something is bent and may have to be replaced to correct your problem

Jun 07, 2015 | Saab Cars & Trucks

1 Answer

Nissan bluebird front window adjustments as the windowgose up then dowon abit when you close it

Remove the inner door panel to see the problem

My guess would be a worn window regulator

May 01, 2014 | 2002 Nissan Bluebird

1 Answer

Macpherson strut Polo Hard 2010 G33/34/35

If the tire is wearing on the outside or inside it is the toe in that is out. Camber rarely changes, however you may have worn out control arm bushings on that side. Of course the right should be done as well. The camber should be fine at 0 degrees. Hope this helps, plese post solved on I get credit for a solved problem if it does solve it. If not, check back and give me more info

Apr 07, 2014 | 2010 Volkswagen Polo 1.2

1 Answer

Changed all 4 struts on 03 cavalier, now the camber is off on the front wheels..

If you put on new struts the bottom bolt hole is oblong for camber adjustments.Where the old struts bottom hole was not. If you put a jack under the lower control arm, jack the wheel off the ground and adjust the struts camber to where the wheel looks straight.And tighten bolts.

Feb 02, 2014 | 2003 Chevrolet Cavalier

1 Answer

Adjust camber right front on chevy cobalt

camber is changed by moving the bolts the hold the strut to the knuckle find more that the strut and or knuckle get bent

Jun 24, 2012 | Chevrolet Cobalt Cars & Trucks

1 Answer

Camber adjustments 99 hyundai accent

The only camber adjustment that they make for this particular vehicle is what they call a camber correction bolt kit.It is sold in pairs and there are two bolts per package(one package covers one axle of vehicle) These run about $30 a set and they replace the upper strut bolt mount, they simply go in and replace the upper bolt on the strut, and they give you the option of moving the strutin and out up to three degrees to adjust camber.Are available at most auto pars stores. Any other questions get back to me...I'M HERE TO HELP!!!

Nov 20, 2009 | 1999 Hyundai Accent

2 Answers

Does macpherson strut rotate when the front wheels are turned?

yes just the lower control arm and lower ball joint

Oct 19, 2009 | 1993 Nissan 300ZX

1 Answer

Negative camber

On your Celica.
Check if the Strut is NOT bent.
Or if the car was not involved on accidente on the front.
Check the Comdittion of the Lower Ball joint, LOwer control arm.

Check if the Camber in your car is adjustable.
Removing the Tire and removing the Bolt that hold the Strut in position. If the Holes in the Strut are Like Oval, is adjustable.
But if NOT. Some Autoparts SELL a Camber kit. That include
New bolt and washers.

But if you Don't want to spend money on the KIT.
Remove the Tire , Remove the 2 Bolt that hold the Strut.
And make the Holes A little oval the holes .
Move a little at front and rear. For make the strut adjustable.

Ok I hope this help on your problem...
Thank you for use fixya,,,,,,

Aug 22, 2008 | 1995 Toyota Celica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides